Collision avoidance for CTV: Requirements and capabilities

Cargo transfer vehicle (CTV) operations near Space Station Freedom will require positive collision avoidance maneuver (CAM) capability to preclude any change of collision, even in the event of CTV failures. The requirements for CAM are discussed, and the CAM design approach and design of the Orbiting Maneuvering Vehicle (OMV) are reviewed; this design met requirements for OMV operation near the Space Station, provided a redundant collision avoidance maneuver capability. Significant portions of the OMV CAM design should be applicable to CTV. The key features of the OMV design are summarized and related to the CTV mission design to that of OMV's. CAM is a defined sequence of events executed by the CTV to place the vehicle in a safe position relative to a target such as the Space Station. CAM can be performed through software commands to the propulsion system, or through commands pre-stored in hardware. Various techniques for triggering CAM are considered, and the risks associated with CAM enable and execution in phases are considered. OMV CAM design features both hardware and software CAM capability, with analyses conducted to assess the ability to meet the collision-free requirement during all phases of the mission

Ceramics for the advanced automotive gas turbine engine: A look at a single shaft design

The results of a preliminary analysis of a single shaft regenerative design with a single stage radial turbine are presented to show the fuel economy that can be achieved at high turbine inlet temperatures, with this particular advanced design, if the turbine tip speed and regenerator inlet temperature are not limited. The engine size was 100 hp for application to a 3500 lb auto. The fuel economy was analyzed by coupling the engine to the auto through a continuously variable speed-ratio transmission and operating the system at constant turbine inlet temperature over the Composite Driving Cycle. The fuel was gasoline and the analysis was for a 85 F day. With a turbine inlet temperature of 2500 F the fuel economy was 26.2 mpg, an improvement of 18 percent over that of 22.3 mpg with a turbine inlet temperature of 1900 F. The turbine tip speed needed for best economy with the 2500 F engine was 2530 ft/sec. The regenerator temperature was approximately 2200 F at idle. Disk stresses were estimated for one single stage radial turbine and two two-stage radial-axial turbines and compared with maximum allowable stress curves estimated for a current ceramic material. Results show a need for higher Weibull Modulus, higher strength ceramics

Affective focus increases the concordance between implicit and explicit attitudes

Two attitude dichotomies - implicit versus explicit and affect versus cognition - are presumed to be related. Following a manipulation of attitudinal focus (affective or cognitive), participants completed two implicit measures (Implicit Association Test and the Sorting Paired Features task) and three explicit attitude measures toward cats/dogs (Study 1) and gay/straight people (Study 2). Based on confirmatory factor analysis, both studies showed that explicit attitudes were more related to implicit attitudes in an affective focus than in a cognitive focus. We suggest that, although explicit evaluations can be meaningfully parsed into affective and cognitive components, implicit evaluations are more related to affective than cognitive components of attitudes