Use of Guided Wave Inspections to Monitor the Integrity of Nuclear Power Station Boilers

This paper describes a ground-breaking application of guided wave testing for the nuclear power industry. Hartlepool and Heysham 1 power stations in the UK contain boilers of a unique ‘pod’ design in which the spiral boiler tubes are supported from above by a central vertical ‘spine’, which is a tubular component approximately 520mm in diameter and 21m long with complex changes in cross-section and attachments along its length. There are 32 boilers in the two stations. The gas which has passed through the reactor core flows down over the boiler tubes, heating the water inside. Only the top 2m of each spine is accessible above the top of the boiler pod. Plant Integrity Ltd was engaged by to inspect these ‘spine’ supports in 2003 using its Teletest guided wave system at statutory outages, which occur on a 3-year interval for each reactor. The Teletest tool was positioned in the only accessible place, just below the inlet header which protrudes approximately 2m from the top of the boiler. A procedure was developed to enable the full 21m length of the spine inside the boiler pod itself to be examined. During one of the regular Teletest inspections, at Heysham 1 power station in September 2013, a significant change in response was detected from the central part of one of the boiler spines. As a result, two of the eight boilers at Heysham 1 Reactor 1 were shut down pending further investigations. The indication was confirmed to be a structurally significant crack in the spine concerned. The crack detected was at the exact position and of the approximate extent reported by Teletest, which had detected the flaw from some 10m away. All four reactors at Hartlepool and Heysham 1 power stations were shut down in the latter part of 2014 while a new safety case for return to service of the remaining boilers was made. There is currently no viable alternative to guided wave inspection for monitoring the integrity of these boiler spines and a significant programme of work has been carried out to demonstrate the performance of Teletest for detection of flaws in these components under a variety of circumstances in order to support the safety case for operation. This has involved theoretical modelling, review of information contained in historical inspection data, practical tests on a full scale mock-up component, development of high temperature Teletest tooling to allow in- service tests and production of automated Teletest data collection equipment to allow real time in-service monitoring of the spines. TWI’s and Plant Integrity’s support enabled all four reactors to be returned to service before the end of 2014

Compensation of Strong Thermal Lensing in High Optical Power Cavities

In an experiment to simulate the conditions in high optical power advanced gravitational wave detectors such as Advanced LIGO, we show that strong thermal lenses form in accordance with predictions and that they can be compensated using an intra-cavity compensation plate heated on its cylindrical surface. We show that high finesse ~1400 can be achieved in cavities with internal compensation plates, and that the cavity mode structure can be maintained by thermal compensation. It is also shown that the measurements allow a direct measurement of substrate optical absorption in the test mass and the compensation plate.Comment: 8 page

Mobility deficit – Rehabilitate, an opportunity for functionality

There are many pathological conditions that cause mobility deficits and that ultimately influence someone’s autonomy.Aims: to evaluate patients with mobility deficits functional status; to implement a Rehabilitation Nursing intervention plan; to monitor health gains through mobility deficits rehabilitation.Conclusion: Early intervention and the implementation of a nursing rehabilitation intervention plan results in health gains (direct or indirect), decreases the risk of developing Pressure Ulcers (PU) and the risk of developing a situation of immobility that affects patients’ autonomy and quality of life

The cultural capitalists: notes on the ongoing reconfiguration of trafficking culture in Asia

Most analysis of the international flows of the illicit art market has described a global situation in which a postcolonial legacy of acquisition and collection exploits cultural heritage by pulling it westwards towards major international trade nodes in the USA and Europe. As the locus of consumptive global economic power shifts, however, these traditional flows are pulled in other directions: notably for the present commentary, towards and within Asia

Observation of Three Mode Parametric Interactions in Long Optical Cavities

We report the first observation of three-mode opto-acoustic parametric interactions of the type predicted to cause parametric instabilities in an 80 m long, high optical power cavity that uses suspended sapphire mirrors. Resonant interaction occurs between two distinct optical modes and an acoustic mode of one mirror when the difference in frequency between the two optical cavity modes is close to the frequency of the acoustic mode. Experimental results validate the theory of parametric instability in high power optical cavities.Comment: 10 pages and 5 figure

The Interface Region Imaging Spectrograph (IRIS)

The Interface Region Imaging Spectrograph (IRIS) small explorer spacecraft provides simultaneous spectra and images of the photosphere, chromosphere, transition region, and corona with 0.33-0.4 arcsec spatial resolution, 2 s temporal resolution and 1 km/s velocity resolution over a field-of-view of up to 175 arcsec x 175 arcsec. IRIS was launched into a Sun-synchronous orbit on 27 June 2013 using a Pegasus-XL rocket and consists of a 19-cm UV telescope that feeds a slit-based dual-bandpass imaging spectrograph. IRIS obtains spectra in passbands from 1332-1358, 1389-1407 and 2783-2834 Angstrom including bright spectral lines formed in the chromosphere (Mg II h 2803 Angstrom and Mg II k 2796 Angstrom) and transition region (C II 1334/1335 Angstrom and Si IV 1394/1403 Angstrom). Slit-jaw images in four different passbands (C II 1330, Si IV 1400, Mg II k 2796 and Mg II wing 2830 Angstrom) can be taken simultaneously with spectral rasters that sample regions up to 130 arcsec x 175 arcsec at a variety of spatial samplings (from 0.33 arcsec and up). IRIS is sensitive to emission from plasma at temperatures between 5000 K and 10 MK and will advance our understanding of the flow of mass and energy through an interface region, formed by the chromosphere and transition region, between the photosphere and corona. This highly structured and dynamic region not only acts as the conduit of all mass and energy feeding into the corona and solar wind, it also requires an order of magnitude more energy to heat than the corona and solar wind combined. The IRIS investigation includes a strong numerical modeling component based on advanced radiative-MHD codes to facilitate interpretation of observations of this complex region. Approximately eight Gbytes of data (after compression) are acquired by IRIS each day and made available for unrestricted use within a few days of the observation.Comment: 53 pages, 15 figure

Hybrid assembly with long and short reads improves discovery of gene family expansions

BACKGROUND: Long-read and short-read sequencing technologies offer competing advantages for eukaryotic genome sequencing projects. Combinations of both may be appropriate for surveys of within-species genomic variation. METHODS: We developed a hybrid assembly pipeline called "Alpaca" that can operate on 20X long-read coverage plus about 50X short-insert and 50X long-insert short-read coverage. To preclude collapse of tandem repeats, Alpaca relies on base-call-corrected long reads for contig formation. RESULTS: Compared to two other assembly protocols, Alpaca demonstrated the most reference agreement and repeat capture on the rice genome. On three accessions of the model legume Medicago truncatula, Alpaca generated the most agreement to a conspecific reference and predicted tandemly repeated genes absent from the other assemblies. CONCLUSION: Our results suggest Alpaca is a useful tool for investigating structural and copy number variation within de novo assemblies of sampled populations

Different expressions of the same mode: a recent dialogue between archaeological and contemporary drawing practices

In this article we explore what we perceive as pertinent features of shared experience at the excavations of an Iron Age Hillfort at Bodfari, North Wales, referencing artist, archaeologist and examples of seminal art works and archaeological records resulting through inter-disciplinary collaboration. We explore ways along which archaeological and artistic practices of improvisation become entangled and productive through their different modes of mark-making. We contend that marks and memories of artist and archaeologist alike emerge interactively, through the mutually constituting effects of the object of study, the tools of exploration, and the practitioners themselves, when they are enmeshed in the cross-modally bound activities. These include, but are not limited to, remote sensing, surveying, mattocking, trowelling, drawing, photographing, videoing and sound recording. These marks represent the co-signatories: the gesture of the often anonymous practitioners, the voice of the deposits, as well as the imprint of the tools, and their interplay creates a multi-threaded narrative documenting their modes of intra-action, in short our practices. They occupy the conceptual space of paradata, and in the process of saturating the interstices of digital cognitive prosthetics they lend probity to their translations in both art form and archive

Do oral aluminium phosphate binders cause accumulation of aluminium to toxic levels?

<p>Abstract</p> <p>Background</p> <p>Aluminium (Al) toxicity was frequent in the 1980s in patients ingesting Al containing phosphate binders (Alucaps) whilst having HD using water potentially contaminated with Al. The aim of this study was to determine the risk of Al toxicity in HD patients receiving Alucaps but never exposed to contaminated dialysate water.</p> <p>Methods</p> <p>HD patients only treated with Reverse Osmosis(RO) treated dialysis water with either current or past exposure to Alucaps were given standardised DFO tests. Post-DFO serum Al level > 3.0 μmol/L was defined to indicate toxic loads based on previous bone biopsy studies.</p> <p>Results</p> <p>39 patients (34 anuric) were studied. Mean dose of Alucap was 3.5 capsules/d over 23.0 months. Pre-DFO Al levels were > 1.0 μmol/L in only 2 patients and none were > 3.0 μmol/L. No patients had a post DFO Al levels > 3.0 μmol/L. There were no correlations between the serum Al concentrations (pre-, post- or the incremental rise after DFO administration) and the total amount of Al ingested.</p> <p>No patients had unexplained EPO resistance or biochemical evidence of adynamic bone.</p> <p>Conclusions</p> <p>Although this is a small study, oral aluminium exposure was considerable. Yet no patients undergoing HD with RO treated water had evidence of Al toxicity despite doses equivalent to 3.5 capsules of Alucap for 2 years. The relationship between the DFO-Al results and the total amount of Al ingested was weak (R²= 0.07) and not statistically significant. In an era of financial prudence, and in view of the recognised risk of excess calcium loading in dialysis patients, perhaps we should re-evaluate the risk of using Al-based phosphate binders in HD patients who remain uric.</p