1,758 research outputs found
The evolution of galaxy groups and of galaxies therein
Properties of groups of galaxies depend sensitively on the algorithm for
group selection, and even the most recent catalogs of groups built from
redshift-space selection should suffer from projections and infalling galaxies.
The cosmo-dynamical evolution of groups from initial Hubble expansion to
collapse and virialization leads to a fundamental track (FT) in
virial-theorem-M/L vs crossing time. The increased rates of mergers, both
direct and after dynamical friction, in groups relative to clusters, explain
the higher fraction of elliptical galaxies at given local number density in
X-ray selected groups, relative to clusters, even when the hierarchical
evolution of groups is considered. Galaxies falling into groups and clusters
should later travel outwards to typically 2 virial radii, which is somewhat
less than the outermost radius where observed galaxy star formation
efficiencies are enhanced relative to field galaxies of same morphological
type. An ongoing analysis of the internal kinematics of X-ray selected groups
suggests that the radial profiles of line of sight velocity dispersion are
consistent with isotropic NFW distributions for the total mass density, with
higher (lower) concentrations than LambdaCDM predictions in groups of high
(low) mass. The critical mass, at M200 ~ 10^13 M_sun is consistent with
possible breaks in the X-ray luminosity-temperature and Fundamental Plane
relations. The internal kinematics of groups indicate that the M-T relation of
groups should agree with that extrapolated from clusters with no break at the
group scale. The analyses of observed velocity dispersion profiles and of the
FT both suggest that low velocity dispersion groups (compact and loose, X-ray
emitting or undetected) are quite contaminated by chance projections.Comment: Invited review, ESO workshop "Groups of Galaxies in the Nearby
Universe", held in Santiago, Chile, 5-9 December 2005, ed. I. Saviane, V.
Ivanov & J. Borissova, 16 page
Sample convection in liquid-state NMR: Why it is always with us, and what we can do about it
AbstractMany NMR experiments on liquids suffer if the sample convects. This is particularly true for applications, such as the measurement of diffusion, that rely on spatial labelling of spins. It is widely assumed that, in most well-conducted experiments with stable temperature regulation, samples do not convect. Unfortunately this is not the case. It is shown here that typical NMR samples show measurable convective flow for all but a very narrow range of temperatures; convection is seen both above and below this range, which can be as small as a degree or so for a mobile solvent such as chloroform. This convection is driven by both vertical and horizontal temperature gradients.Measurements of convection velocity are presented for a range of samples, sample tubes, probes, and temperatures. Both decreasing sample tube inner diameter and changing sample tube material from glass to sapphire can slow convection markedly, with sapphire tubes being particularly effective. Such tubes are likely to be particularly helpful for accurate measurement of diffusion by NMR
Recommended from our members
Testing and Acceptance of Fuel Plates for RERTR Fuel Development Experiments
This paper discusses how candidate fuel plates for RERTR Fuel Development experiments are examined and tested for acceptance prior to reactor insertion. These tests include destructive and nondestructive examinations (DE and NDE). The DE includes blister annealing for dispersion fuel plates, bend testing of adjacent cladding, and microscopic examination of archive fuel plates. The NDE includes Ultrasonic (UT) scanning and radiography. UT tests include an ultrasonic scan for areas of “debonds” and a high frequency ultrasonic scan to determine the "minimum cladding" over the fuel. Radiography inspections include identifying fuel outside of the maximum fuel zone and measurements and calculations for fuel density. Details of each test are provided and acceptance criteria are defined. These tests help to provide a high level of confidence the fuel plate will perform in the reactor without a breach in the cladding
NOAO fundamental plane survey II: Age and metallicity along the red sequence from line-strength data
We present spectroscopic line-strength data for 4097 red-sequence galaxies in 93 low-redshift galaxy clusters and use these to investigate variations in average stellar populations as a function of galaxy mass. Our analysis includes an improved treatment of nebular emission contamination, which affects 10% of the sample galaxies. Using the stellar population models of D. Thomas and collaborators, we simultaneously fit 12 observed line-strength relations in terms of common underlying trends of age, [Z/H] (total metallicity), and [/Fe] (-element enhancement). We find that the observed line-strength relations can be explained only if higher mass red-sequence galaxies are, on average, older, more metal-rich, and more -enhanced than lower mass galaxies. Quantitatively, the scaling relations are age0.59±0.13, Z/H0.53±0.08, and /Fe0.31±0.06, where the errors reflect the range obtained using different subsets of indices. Our conclusions are not strongly dependent on which Balmer lines are used as age indicators. The derived age- relation is such that if the largest (400 km s-1) galaxies formed their stars 13 Gyr ago, then the mean age of low-mass (50 km s-1) objects is only 4 Gyr. The data also suggest a large spread in age at the low-mass end of the red sequence, with 68% of the galaxies having ages between 2 and 8 Gyr. We conclude that although the stars in giant red galaxies in clusters formed early, most of the galaxies at the faint end joined the red sequence only at recent epochs. This "downsizing" trend is in good qualitative agreement with observations of the red sequence at higher redshifts but is not predicted by semianalytic models of galaxy formation
Exercise training and weight loss, not always a happy marriage: single blind exercise trials in females with diverse BMI
Individuals show high variability in body weight responses to exercise training. Expectations and motivation towards effects of exercise on body weight might influence eating behaviour and could conceal regulatory mechanisms. We conducted two single-blind exercise trials (4 weeks (study 1) and 8 weeks (study 2)) with concealed objectives and exclusion of individuals with weight loss intention. Circuit exercise training programs (3 times a week (45-90 min), intensity 50-90% VO2peak, for 4 and 8 weeks) were conducted. 34 females finished the 4 weeks intervention and 36 females the 8 weeks intervention. Overweight/obese (OV/OB) and lean (L) female participants´ weight/body composition responses were assessed and fasting and postprandial appetite hormone levels (PYY, insulin, amylin, leptin, ghrelin) were measured pre and post intervention for understanding potential contribution to individuals’ body weight response to exercise training (study 2). Exercise training in both studies did not lead to a significant reduction of weight/BMI in the participants’ groups, however, lean participants gained muscle mass. Appetite hormones levels were significantly (p<0.05) altered in the OV/OB group affecting fasting (-24%) and postprandial amylin (-14%) levels. Investigation of individuals’ BMI responses using multiple regression analysis revealed that levels of fasting leptin, postprandial amylin increase, and BMI were significant predictors of BMI change explaining about 43% of the variance. In conclusion, tested exercise training did not lead to weight loss in female participants, while a considerable proportion of variance in body weight response to training could be explained by individuals’ appetite hormone levels and BMI
Higher-order mutual coherence of optical and matter waves
We use an operational approach to discuss ways to measure the higher-order
cross-correlations between optical and matter-wave fields. We pay particular
attention to the fact that atomic fields actually consist of composite
particles that can easily be separated into their basic constituents by a
detection process such as photoionization. In the case of bosonic fields, that
we specifically consider here, this leads to the appearance in the detection
signal of exchange contributions due to both the composite bosonic field and
its individual fermionic constituents. We also show how time-gated counting
schemes allow to isolate specific contributions to the signal, in particular
involving different orderings of the Schr\"odinger and Maxwell fields.Comment: 11 pages, 2 figure
NONDESTRUCTIVE EXAMINATION OF FUEL PLATES FOR THE RERTR FUEL DEVELOPMENT EXPERIMENTS
Nuclear fuel is the core component of reactors that is used to produce the neutron flux required for irradiation research purposes as well as commercial power generation. The development of nuclear fuels with low enrichments of uranium is a major endeavor of the RERTR program. In the development of these fuels, the RERTR program uses nondestructive examination (NDE) techniques for the purpose of determining the properties of nuclear fuel plate experiments without imparting damage or altering the fuel specimens before they are irradiated in a reactor. The vast range of properties and information about the fuel plates that can be characterized using NDE makes them highly useful for quality assurance and for analyses used in modeling the behavior of the fuel while undergoing irradiation. NDE is also particularly useful for creating a control group for post-irradiation examination comparison. The two major categories of NDE discussed in this paper are X-ray radiography and ultrasonic testing (UT) inspection/evaluation. The radiographic scans are used for the characterization of fuel meat density and homogeneity as well as the determination of fuel location within the cladding. The UT scans are able to characterize indications such as voids, delaminations, inclusions, and other abnormalities in the fuel plates which are generally referred to as debonds as well as to determine the thickness of the cladding using ultrasonic acoustic microscopy methods. Additionally, the UT techniques are now also being applied to in-canal interim examination of fuel experiments undergoing irradiation and the mapping of the fuel plate surface profile to determine fuel swelling. The methods used to carry out these NDE techniques, as well as how they operate and function, are described along with a description of which properties are characterized
Dairy manure applications and soil health implications
Dairy manure applications can potentially improve soil health by adding organic matter (OM) to the soil. However, intensive dairy manure applications can cause salt accumulations on arid, irrigated soils, impairing soil health, which can reduce crop growth and yield. Soil organic matter, a major contributor to soil health, increased by 0.02% for every ton of manure-derived organic matter applied. While soil OM increases typically improve soil health, salt accumulations from manure applications had antagonistic effects on soil health. As manure application rates and frequencies increased, soil properties became increasingly saline-sodic, as indicated by elevated EC and SAR values. Aggregate stability also decreased at the heaviest annual manure application rate, likely a consequence of clay dispersion caused by sodium in the added manure. One concern with some of the new soil health tests is that they do not account for the negative effects of salt accumulations. For example, the Haney “soil health score” increased with increasing organic matter and nutrient content, not taking into account the fact that EC and SAR increased to levels above the recommended salinity/sodicity thresholds for salt sensitive and even salt tolerant crops. The decline in aggregate stability also revealed that soil structure was compromised at the higher soil health scores. A newly proposed N mineralization estimation procedure is the “Haney – Additional N” test, which relates carbon dioxide respiration measurements to soil organic C to organic N ratios to estimate how much N will be available to plants in addition to the nitrate and ammonium traditionally measured in preplant soil tests. Unfortunately, the “Haney – Additional N” test severely under-predicted mineralizable N pools by 20-fold. Thus, use of this test for estimating N fertilizer applications would drastically under-estimate plant available N in the soil, which would lead to greatly over-estimating the N requirement of a crop to be grown on that field. Including salinity and sodicity parameters should be considered in future soil health evaluation programs, especially in semi-arid irrigated regions like southern Idaho where saline and sodic soil conditions can occur
Thomson and Compton scattering with an intense laser pulse
Our paper concerns the scattering of intense laser radiation on free
electrons and it is focused on the relation between nonlinear Compton and
nonlinear Thomson scattering. The analysis is performed for a laser field
modeled by an ideal pulse with a finite duration, a fixed direction of
propagation and indefinitely extended in the plane perpendicular to it. We
derive the classical limit of the quantum spectral and angular distribution of
the emitted radiation, for an arbitrary polarization of the laser pulse. We
also rederive our result directly, in the framework of classical
electrodynamics, obtaining, at the same time, the distribution for the emitted
radiation with a well defined polarization. The results reduce to those
established by Krafft et al. [Phys. Rev. E 72, 056502 (2005)] in the particular
case of linear polarization of the pulse, orthogonal to the initial electron
momentum. Conditions in which the differences between classical and quantum
results are visible are discussed and illustrated by graphs
Challenges of open innovation: the paradox of firm investment in open-source software
Open innovation is a powerful framework encompassing the generation, capture, and employment of intellectual property at the firm level. We identify three fundamental challenges for firms in applying the concept of open innovation: finding creative ways to exploit internal innovation, incorporating external innovation into internal development, and motivating outsiders to supply an ongoing stream of external innovations. This latter challenge involves a paradox, why would firms spend money on R&D efforts if the results of these efforts are available to rival firms? To explore these challenges, we examine the activity of firms in opensource software to support their innovation strategies. Firms involved in open-source software often make investments that will be shared with real and potential rivals. We identify four strategies firms employ – pooled R&D/product development, spinouts, selling complements and attracting donated complements – and discuss how they address the three key challenges of open innovation. We conclude with suggestions for how similar strategies may apply in other industries and offer some possible avenues for future research on open innovation
- …