Detailed studies of aviation fuel flowability

Six Jet A fuels, with varying compositions, were tested for low temperature flowability in a 190-liter simulator tank that modeled a section of a wing tank of a wide-body commercial airplane. The insulated tank was chilled by circulating coolant through the upper and lower surfaces. Flow-ability was determined as a function of fuel temperature by holdup, the fraction of unflowable fuel remaining in the tank after otherwise complete withdrawal. In static tests with subfreezing tank conditions, hold up varied with temperature and fuel composition. However, a general correlation of two or three classes of fuel type was obtained by plotting holdup as a function of the difference between freezing point and boundary-layer temperature, measured 0.6 cm above the bottom tank surface. Dynamic conditions of vibrations and slosh or rate of fuel withdrawal had very minor effects on holdup. Tests with cooling schedules to represent extreme, cold-day flights showed, at most, slight holdup for any combination of fuel type or dynamic conditions. Tests that superimposed external fuel heating and recirculation during the cooldown period indicates reduced hold up by modification of the low-temperature boundary layer. Fuel heating was just as effective when initiated during the later times of the tests as when applied continuously

Analysis of the separated boundary layer flow on the surface and in the wake of blunt trailing edge airfoils

The viscous flow phenomena associated with sharp and blunt trailing edge airfoils were investigated. Experimental measurements were obtained for a 17 percent thick, high performance GAW-1 airfoil. Experimental measurements consist of velocity and static pressure profiles which were obtained by the use of forward and reverse total pressure probes and disc type static pressure probes over the surface and in the wake of sharp and blunt trailing edge airfoils. Measurements of the upper surface boundary layer were obtained in both the attached and separated flow regions. In addition, static pressure data were acquired, and skin friction on the airfoil upper surface was measured with a specially constructed device. Comparison of the viscous flow data with data previously obtained elsewhere indicates reasonable agreement in the attached flow region. In the separated flow region, considerable differences exist between these two sets of measurements

A two-species continuum model for aeolian sand ripples

We formulate a continuum model for aeolian sand ripples consisting of two species of grains: a lower layer of relatively immobile clusters, with an upper layer of highly mobile grains moving on top. We predict analytically the ripple wavelength, initial ripple growth rate and threshold saltation flux for ripple formation. Numerical simulations show the evolution of realistic ripple profiles from initial surface roughness via ripple growth and merger.Comment: 9 pages, 3 figure

Calculation of some determinants using the s-shifted factorial

Several determinants with gamma functions as elements are evaluated. This kind of determinants are encountered in the computation of the probability density of the determinant of random matrices. The s-shifted factorial is defined as a generalization for non-negative integers of the power function, the rising factorial (or Pochammer's symbol) and the falling factorial. It is a special case of polynomial sequence of the binomial type studied in combinatorics theory. In terms of the gamma function, an extension is defined for negative integers and even complex values. Properties, mainly composition laws and binomial formulae, are given. They are used to evaluate families of generalized Vandermonde determinants with s-shifted factorials as elements, instead of power functions.Comment: 25 pages; added section 5 for some examples of application

Smoothing of sandpile surfaces after intermittent and continuous avalanches: three models in search of an experiment

We present and analyse in this paper three models of coupled continuum equations all united by a common theme: the intuitive notion that sandpile surfaces are left smoother by the propagation of avalanches across them. Two of these concern smoothing at the `bare' interface, appropriate to intermittent avalanche flow, while one of them models smoothing at the effective surface defined by a cloud of flowing grains across the `bare' interface, which is appropriate to the regime where avalanches flow continuously across the sandpile.Comment: 17 pages and 26 figures. Submitted to Physical Review

Density of critical points for a Gaussian random function

Critical points of a scalar quantitiy are either extremal points or saddle points. The character of the critical points is determined by the sign distribution of the eigenvalues of the Hessian matrix. For a two-dimensional homogeneous and isotropic random function topological arguments are sufficient to show that all possible sign combinations are equidistributed or with other words, the density of the saddle points and extrema agree. This argument breaks down in three dimensions. All ratios of the densities of saddle points and extrema larger than one are possible. For a homogeneous Gaussian random field one finds no longer an equidistribution of signs, saddle points are slightly more frequent.Comment: 11 pages 1 figure, changes in list of references, corrected typo

Effects of processing and dopant on radiation damage removal in silicon solar cells

Gallium and boron doped silicon solar cells, processed by ion-implantation followed by either laser or furnace anneal were irradiated by 1 MeV electrons and their post-irradiation recovery by thermal annealing determined. During the post-irradiation anneal, gallium-doped cells prepared by both processes recovered more rapidly and exhibited none of the severe reverse annealing observed for similarly processed 2 ohm-cm boron doped cells. Ion-implanted furnace annealed 0.1 ohm-cm boron doped cells exhibited the lowest post-irradiation annealing temperatures (200 C) after irradiation to 5 x 10 to the 13th e(-)/sq cm. The drastically lowered recovery temperature is attributed to the reduced oxygen and carbon content of the 0.1 ohm-cm cells. Analysis based on defect properties and annealing kinetics indicates that further reduction in annealing temperature should be attainable with further reduction in the silicon's carbon and/or divacancy content after irradiation

The effects of lithium counterdoping on radiation damage and annealing in n(+)p silicon solar cells

Boron-doped silicon n(+)p solar cells were counterdoped with lithium by ion implantation and the resultant n(+)p cells irradiated by 1 MeV electrons. Performance parameters were determined as a function of fluence and a deep level transient spectroscopy (DLTS) study was conducted. The lithium counterdoped cells exhibited significantly increased radiation resistance when compared to boron doped control cells. Isochronal annealing studies of cell performance indicate that significant annealing occurs at 100 C. Isochronal annealing of the deep level defects showed a correlation between a single defect at E sub v + 0.43 eV and the annealing behavior of short circuit current in the counterdoped cells. The annealing behavior was controlled by dissociation and recombination of this defect. The DLTS studies showed that counterdoping with lithium eliminated three deep level defects and resulted in three new defects. The increased radiation resistance of the counterdoped cells is due to the interaction of lithium with oxygen, single vacancies and divacancies. The lithium-oxygen interaction is the most effective in contributing to the increased radiation resistance

Green Building Construction for Sustainable Future

Green building construction is relatively new phenomenon in Indian construction industry. With increasing awareness about global warming and climate change movement for sustainable development is gaining force. Indian Government also realizes the need for sustainable construction as its economy is growing at fast pace (7 to 8 percent annually) and that needs a rapid and vast infrastructure development. This paper provides a state of the art literature review on green building construction movement in India. This study provides an overview of green building rating systems, cost & benefits, green design strategies, and discusses their implications for future of sustainable development in India. A need for widespread awareness about sustainable development and capacity building for design, construction and operations of green buildings is realized. Key Words: Green Buildings, LEED, GRIHA, Intelligent Building

Full counting statistics of chaotic cavities with many open channels

Explicit formulas are obtained for all moments and for all cumulants of the electric current through a quantum chaotic cavity attached to two ideal leads, thus providing the full counting statistics for this type of system. The approach is based on random matrix theory, and is valid in the limit when both leads have many open channels. For an arbitrary number of open channels we present the third cumulant and an example of non-linear statistics.Comment: 4 pages, no figures; v2-added references; typos correcte