13,233 research outputs found
Residual stress relaxation and microstructure in ZnO thin films
Stability under normal environmental conditions over a long period of time is crucial for sustainable thin-film device performance. Pure ZnO films with thicknesses in the 140 - 450 nm range were deposited on amorphous glass microscope slides and (100)-oriented single crystal silicon wafers by radio frequency magnetron sputtering. The depositions were performed at a starting temperature of 200 oC. ZnO films had a columnar microstructure strongly textured along the direction. XRD peak-shift analysis revealed that the films were under residual, compressive, in-plane stress of -5.46 GPa for the glass substrate and -6.69 GPa for the Si substrate. These residual stresses could be completely relaxed by thermal annealing in air. When left under normal environmental condition over an extended period of time the films failed under buckling leading to extensive cracking of the films. The XRD and SEM results indicated different mechanisms of stress relaxation that were favored in the ZnO thin films depending on the energy provided. Although thermal annealing eliminated residual stresses, serious micro-structural damage upon annealing was observed. Thermal annealing also led to preferential growth of some ZnO crystals in the films. This kind of behavior is believed to be indicative of stress-induced directional diffusion of ZnO. It appears that for the extended stability of the films, the stresses have to be eliminated during deposition
Formation control of a group of micro aerial vehicles (MAVs)
Coordinated motion of Unmanned Aerial Vehicles (UAVs) has been a growing research interest in the last decade. In this paper we propose a coordination model that makes use of virtual springs and dampers to generate reference trajectories for a group of quadrotors. Virtual forces exerted on each vehicle are produced by using projected distances between the quadrotors. Several coordinated task scenarios are presented and the performance of the proposed method is verified by simulations
Dirac Equation on a Curved 2+1 Dimensional Hypersurface
Interest on 2 + 1 dimensional electron systems has increased considerably
after the realization of novel properties of graphene sheets, in which the
behaviour of electrons is effectively described by relativistic equations.
Having this fact in mind, the following problem is studied in this work: when a
spin 1/2 particle is constrained to move on a curved surface, is it possible to
describe this particle without giving reference to the dimensions external to
the surface? As a special case of this, a relativistic spin 1/2 particle which
is constrained to move on a 2 + 1 dimensional hypersurface of the 3 + 1
dimensional Minkowskian spacetime is considered, and an effective Dirac
equation for this particle is derived using the so-called thin layer method.
Some of the results are compared with those obtained in a previous work by M.
Burgess and B. Jensen.Comment: 5 pages. To be published in Modern Physics Letters
Pressure drop across micro-pin heat sinks under boiling conditions
Two-phase pressure drop was studied in four different micro pin fin heat sinks. Micro pin fin heat sinks used in the current studies were operated under boiling conditions using water and R-123 as working fluids. It was observed that once boiling was initiated severe temperature fluctuations and flow oscillations were recorded for three of the micro pin fin heat sinks, which was characterized as unstable boiling. Pressure drop signals were presented just before and after the unstable boiling conditions. Flow images and FFT (fast Fourier Transform) profiles of pressure signals were used to explain experimental results and unstable nature in flow boiling observed in the three of the devices. Stable boiling conditions where the temperature and pressure drop had a steady and stable profile could be only obtained from one micro pin fin heat sink at high mass velocities. The two-phase pressure drop in this hydrofoil-based micro pin fin heat sink has been investigated using R-123 as the working fluid. Two-phase frictional multipliers have been obtained over mass fluxes from 976 to 2349 kg/m2. It has been found that the two-phase frictional multiplier is strongly dependent on flow pattern. The theoretical prediction using Martinelli parameter based on the laminar fluid and laminar gas flow represented the experimental data fairly well for the spray-annular flow. For the bubbly and wavy-intermittent flow, however, large deviations from the experimental data were recorded. The Martinelli parameter was used successfully to determine the flow patterns, which were bubbly, wavy-intermittent, and spray-annular flow in the current study
On the calculation of covariant expressions for Dirac bilinears
In this article, various approaches to calculate covariant expressions for
the bilinears of Dirac spinors are presented. For this purpose, algebraic
equations defining Dirac spinors are discussed. Following that, a covariant
approach for spacetime parameterization is presented and the equations defining
Dirac spinors are written fully in terms of Lorentz scalars. After presenting
how the tensorial bilinears can be reduced to combinations of scalar bilinears
with appropriate Lorentz structures, a covariant recipe for the calculation of
scalar bilinears is provided.Comment: 10 pages, 1 figur
- …