699 research outputs found
Emission, absorption and polarization of gyrosynchrotron radiation of mildly relativistic particles
Approximate analytic expressions are presented for the emissivity and absorption coefficient of synchrotron radiation of mildly relativistic particles with an arbitrary energy spectrum and pitch angle distribution. From these, an expression for the degree of polarization is derived. The analytic results are compared with numerical results for both thermal and non-thermal (power law) distributions of particles
Emission, absorption and polarization of gyrosynchrotron radiation of mildly relativistic paricles
Approximate analytic expressions for the emissivity and absorption coefficient of synchrotron radiation of mildly relativistic particles with an arbitrary energy spectrum and pitch angle distribution are given. From these, an expression for the degree of polarization is derived. To accomplish this, previously developed methods of integration are used. The analytic results are compared with numerical results for both thermal and non-thermal (power law) distributions of particles
Looptop Hard X-Ray Emission in Solar Flares: Images and Statistics
The discovery of hard X-ray sources near the top of a flaring loop by the HXT
instrument on board the YOHKOH satellite represents a significant progress
towards the understanding of the basic processes driving solar flares. In this
paper we extend the previous study of limb flares by Masuda (1994) by including
all YOHKOH observations up through August 1998. We report that from October
1991 to August 1998, YOHKOH observed 20 X-ray bright limb flares (where we use
the same selection criteria as Masuda), of which we have sufficient data to
analyze 18 events, including 8 previously unanalyzed flares. Of these 18
events, 15 show detectable impulsive looptop emission. Considering that the
finite dynamic range (about a decade) of the detection introduces a strong bias
against observing comparatively weak looptop sources, we conclude that looptop
emission is a common feature of all flares. We summarize the observations of
the footpoint to looptop flux ratio and the spectral indices. We present light
curves and images of all the important newly analyzed limb flares. Whenever
possible we present results for individual pulses in multipeak flares and for
different loops for multiloop flares. We then discuss the statistics of the
fluxes and spectral indices of the looptop and footpoint sources taking into
account observational selection biases. The importance of these observations
(and those expected from the scheduled HESSI satellite with its superior
angular spectral and temporal resolution) in constraining acceleration models
and parameters is discussed briefly.Comment: 27 pages (13 embedded figures). Accepted for publication in Ap
Stereoscopic observations of hard x ray sources in solar flares made with GRO and other spacecraft
Since the launch of the Gamma Ray Observatory (GRO) in Apr. 1991, the Burst and Transient Source Experiment (BATSE) instrument on GRO has recorded a large number of solar flares. Some of these flares have also been observed by the Gamma-Ray Burst Detector on the Pioneer Venus Orbiter (PVO) and/or by the Solar X-Ray/Cosmic Gamma-Ray Burst Experiment on the Ulysses spacecraft. A preliminary list of common flares observed during the period May-Jun. 1991 is presented and the possible joint studies are indicated
Global Energetics of Solar Flares: III. Non thermal Energies
This study entails the third part of a global flare energetics project, in
which Ramaty High-Energy Solar Spectroscopic Imager (RHESSI) data of 191 M and
X-class flare events from the first 3.5 yrs of the Solar Dynamics Observatory
(SDO) mission are analyzed. We fit a thermal and a nonthermal component to
RHESSI spectra, yielding the temperature of the differential emission measure
(DEM) tail, the nonthermal power law slope and flux, and the thermal/nonthermal
cross-over energy . From these parameters we calculate the
total nonthermal energy in electrons with two different
methods: (i) using the observed cross-over energy as
low-energy cutoff, and (ii) using the low-energy cutoff
predicted by the warm thick-target bremsstrahlung model of Kontar et al. {\bf
Based on a mean temperature of MK in active regions we find
low-energy cutoff energies of keV for the
warm-target model, which is significantly lower than the cross-over energies
keV. Comparing with the statistics of magnetically
dissipated energies and thermal energies
from the two previous studies, we find the following mean (logarithmic) energy
ratios with the warm-target model: ,
, and $E_{\mathrm{th}} = 0.15 \
E_{\mathrm{nt}}$. The total dissipated magnetic energy exceeds the thermal
energy in 95% and the nonthermal energy in 71% of the flare events, which
confirms that magnetic reconnection processes are sufficient to explain flare
energies. The nonthermal energy exceeds the thermal energy in 85\% of the
events, which largely confirms the warm thick-target model.Comment: 34p, 9 Figs., 1 Tabl
A Phase II Nonrandomised Open-Label Study of Liposomal Daunorubicin (DaunoXome) in Advanced Soft Tissue Sarcoma
Thirty four patients with advanced soft tissue sarcoma not previously treated with an anthracycline were treated with DaunoXome 100mg/m2 every 3 weeks. Thirty-three patients were evaluable for toxicity. Grade 3-4 neutropenia was seen in 20 patients (60.6%), complicated by febrile neutropenia in 2 (6.1%). Other grade 3 toxicities were rare. Among 32 patients assessable for response, one patient had a partial response, giving a response rate of 3.13% (95% confidence interval, 0.08–16.22%). Seven patients (21.9%) had stable disease, and 24 patients (75.0%) had disease progression. The median time to progression for all patients was 42 days (95% CI, 39–49) and the progression-free rate at 3 months was 12.5%. In conclusion, DaunoXome at this dose and schedule is well tolerated in patients with advanced soft tissue sarcoma, but is not associated with significant activity. Further studies at this dose and schedule cannot be recommended in this disease
The space physics environment data analysis system (SPEDAS)
With the advent of the Heliophysics/Geospace System Observatory (H/GSO), a complement of multi-spacecraft missions and ground-based observatories to study the space environment, data retrieval, analysis, and visualization of space physics data can be daunting. The Space Physics Environment Data Analysis System (SPEDAS), a grass-roots software development platform (www.spedas.org), is now officially supported by NASA Heliophysics as part of its data environment infrastructure. It serves more than a dozen space missions and ground observatories and can integrate the full complement of past and upcoming space physics missions with minimal resources, following clear, simple, and well-proven guidelines. Free, modular and configurable to the needs of individual missions, it works in both command-line (ideal for experienced users) and Graphical User Interface (GUI) mode (reducing the learning curve for first-time users). Both options have “crib-sheets,” user-command sequences in ASCII format that can facilitate record-and-repeat actions, especially for complex operations and plotting. Crib-sheets enhance scientific interactions, as users can move rapidly and accurately from exchanges of technical information on data processing to efficient discussions regarding data interpretation and science. SPEDAS can readily query and ingest all International Solar Terrestrial Physics (ISTP)-compatible products from the Space Physics Data Facility (SPDF), enabling access to a vast collection of historic and current mission data. The planned incorporation of Heliophysics Application Programmer’s Interface (HAPI) standards will facilitate data ingestion from distributed datasets that adhere to these standards. Although SPEDAS is currently Interactive Data Language (IDL)-based (and interfaces to Java-based tools such as Autoplot), efforts are under-way to expand it further to work with python (first as an interface tool and potentially even receiving an under-the-hood replacement). We review the SPEDAS development history, goals, and current implementation. We explain its “modes of use” with examples geared for users and outline its technical implementation and requirements with software developers in mind. We also describe SPEDAS personnel and software management, interfaces with other organizations, resources and support structure available to the community, and future development plans.Published versio
- …