Impact of testing temperature on the structure and catalytic properties of au nanotubes composites

In the paper, the catalytic activity of composites based on gold nanotubes and ion track membranes was studied using bench reaction of the p-nitrophenol (4-NP) reduction in the temperature range of 25-40 °C. The efficiency of the prepared catalysts was estimated on the rate constant of the reaction and by conversion degree of 4-NP to p-aminophenol (4-AP). The comprehensive evaluation of the structure was performed by X-ray diffraction and scanning electron microscopy. A decreasing of the composites activity was observed when the reaction were carried out at the temperature over 35 °C, due to an increased average crystallite size from 7.31±1.07 to 10.35±3.7 nm (after 1st run). In temperature range of 25-35 °C the efficiency of the composite catalyst was unchanged in 3 runs and decreases by 24-32 % after the 5th run. At the high temperature of 40 °C after the 5th run the composite become completely catalytically inert. Copyright © 2018 BCREC Group. All rights reserved.Ministry of Education and Science of the Republic of Kazakhstan: АP05130797This work was supported by the Ministry of Education and Science of the Republic of Kazakhstan under project АP05130797

Cu/cuo composite track-etched membranes for catalytic decomposition of nitrophenols and removal of as(III)

One of the promising applications of nanomaterials is to use them as catalysts and sorbents to remove toxic pollutants such as nitroaromatic compounds and heavy metal ions for environmental protection. This work reports the synthesis of Cu/CuO-deposited composite track-etched membranes through low-temperature annealing and their application in catalysis and sorption. The synthesized Cu/CuO/poly(ethylene terephthalate) (PET) composites presented efficient catalytic activity with high conversion yield in the reduction of nitro aryl compounds to their corresponding amino derivatives. It has been found that increasing the time of annealing raises the ratio of the copper(II) oxide (CuO) tenorite phase in the structure, which leads to a significant increase in the catalytic activity of the composites. The samples presented maximum catalytic activity after 5 h of annealing, where the ratio of CuO phase and the degree of crystallinity were 64.3% and 62.7%, respectively. The catalytic activity of pristine and annealed composites was tested in the reduction of 4-nitroaniline and was shown to remain practically unchanged for five consecutive test cycles. Composites annealed at 140 °C were also tested for their capacity to absorb arsenic(III) ions in cross-flow mode. It was observed that the sorption capacity of composite membranes increased by 48.7% compared to the pristine sample and reached its maximum after 10 h of annealing, then gradually decreased by 24% with further annealing. © 2020 by the authors. Licensee MDPI, Basel, Switzerland.Ministry of Education and Science of the Republic of Kazakhstan: AP05130797Funding: A.M. gratefully acknowledges the funding of the Ministry of Education and Science of the Republic of Kazakhstan (Project AP05130797)

Synthesis and Properties of the Copper Composite Membranes

Composite catalysts based on track-etched membranes (TeMs) and metal nanoparticles (NPs) or nanotubes (NTs) deposited by different approaches have drawn a special attention because of attractive catalytic properties coupled with large catalytically active surface, high mechanical strength and efficient flexibility, which allows them to be successfully used for several reaction cycles without additional manipulation of purification and activation

Electron beam induced enhancement of the catalytic properties of ion-track membranes supported copper nanotubes in the reaction of the P-nitrophenol reduction

This study considers the effect of various doses of electron irradiation on the crystal structure and properties of composite catalysts based on polyethylene terephthalate track-etched membranes and copper nanotubes. Copper nanotubes were obtained by electroless template synthesis and irradiated with electrons with 3.8 MeV energy in the dose range of 100–250 kGy in increments of 50 kGy. The original and irradiated samples of composites were investigated by X-ray diffraction technique (XRD), scanning electron microscopy (SEM) and atomic force microscopy (AFM). The improved catalytic activity of composite membranes with copper nanotubes was demonstrated by the example of the reduction reaction of p-nitrophenol in the presence of sodium borohydride. Irradiation with electrons at doses of 100 and 150 kGy led to reaction rate constant increases by 35 and 59%, respectively, compared to the non-irradiated sample. This enhancing catalytic activity could be attributed to the changing of the crystallite size of copper, as well as the surface roughness of the composite membrane. © 2019 by the authors. Licensee MDPI, Basel, Switzerland.Ministry of Education and Science of the Republic of Kazakhstan: AP05130797Funding: A.A.M. gratefully acknowledges the funding of the Ministry of Education and Science of the Republic of Kazakhstan (Project AP05130797)

Biologically active peptides of meat and meat product proteins: a review. Part 2. Functionality of meat bioactive peptides

Biologically active peptides (BAP) are regarded as the main products of protein hydrolysis. BAP activity depends on the amino acid sequence molecular weight and chain length, type and charge of an amino acid at the N-terminus and C-terminus, hydrophobic and hydrophilic properties, spatial structure. They positively influence many systems of the human body, including the blood circulatory, nervous, immune, gastrointestinal and other systems. The health-improving effect of bioactive peptides is formed due to their antioxidant, antihypertensive, antithrombotic, immunomodulatory, antimicrobial, anti-allergic, opioid, anti-inflammatory, hypocholesterolemic and anticancer properties. Angiotensin-I-converting enzyme (ACE) inhibitory peptides are most studied due to their effect on blood pressure regulation. Unlike synthetic preparations, biologically active peptides do not have side effects and, therefore, can be used as their alternative. There is a growing commercial interest in peptides generated from meat proteins is in the context of health saving functional foods. The paper describes prospects, pros and cons of using bioactive peptides as functional food ingredients and biologically active food additives

Application of silver-loaded composite track-etched membranes for photocatalytic decomposition of methylene blue under visible light

In this study, the use of composite track-etched membranes (TeMs) based on polyethylene terephthalate (PET) and electrolessly deposited silver microtubes (MTs) for the decomposition of toxic phenothiazine cationic dye, methylene blue (MB), under visible light was investigated. The structure and composition of the composite membranes were elucidated by scanning electron microscopy, energy dispersive spectroscopy, and X-ray diffraction technique. Under visible light irradiation, composite membrane with embedded silver MTs (Ag/PET) displayed high photocatalytic efficiency. The effects of various parameters such as initial dye concentration, temperature, and sample exposure time on the photocatalytic degradation process were studied. The decomposition reaction of MB was found to follow the Langmuir-Hinshelwood mechanism and a pseudo-first-order kinetic model. The degradation kinetics of MB accelerated with increasing temperature and activation energy, Ea, was calculated to be 20.6 kJ/mol. The reusability of the catalyst was also investigated for 11 consecutive runs without any activation and regeneration procedures. The Ag/PET composite performed at high degradation efficiency of over 68% after 11 consecutive uses. © 2021 by the authors.The research titled ?Development of functionalized composite track-etched membranes for environmental applications? (grant No AP08855527) was funded by the Ministry of Education and Science of the Republic of Kazakhstan. M.V.Z. acknowledges the International Atomic Energy Agency (IAEA) for support under coordinated research project F22070 (IAEA Research Contract No: 23152)

Impact of Testing Temperature on the Structure and Catalytic Properties of Au Nanotubes Composites

In the paper, the catalytic activity of composites based on gold nanotubes and ion track membranes was studied using bench reaction of the p-nitrophenol (4-NP) reduction in the temperature range of 25-40 °C. The efficiency of the prepared catalysts was estimated on the rate constant of the reaction and by conversion degree of 4-NP to p-aminophenol (4-AP). The comprehensive evaluation of the structure was performed by X-ray diffraction and scanning electron microscopy. A decreasing of the composites activity was observed when the reaction were carried out at the temperature over 35 °C, due to an increased average crystallite size from 7.31±1.07 to 10.35±3.7 nm (after 1st run). In temperature range of 25-35 °C the efficiency of the composite catalyst was unchanged in 3 runs and decreases by 24-32 % after the 5th run. At the high temperature of 40 °C after the 5th run the composite become completely  catalytically inert. Copyright © 2018 BCREC Group. All rights reserved Received: 23rd January 2018; Revised: 19th March 2018; Accepted: 19th March 2018 How to Cite: Mashentseva, A.A., Zdorovets, M.V., Borgekov, D.B. (2018). Impact of Testing Temperature on the Structure and Catalytic Properties of Au Nanotubes Composites. Bulletin of Chemical Reaction Engineering & Catalysis, 13 (3): 405-411 (doi:10.9767/bcrec.13.3.2127.405-411) Permalink/DOI: https://doi.org/10.9767/bcrec.13.3.2127.405-41

Kinetic and isotherm study of as(Iii) removal from aqueous solution by pet track-etched membranes loaded with copper microtubes

This paper reports on the synthesis and structure elucidation of track-etched membranes (TeMs) with electrolessly deposited copper microtubes (prepared in etched-only and oxidized polyethylene terephthalate (PET) TeMs), as well as on the comparative testing of arsenic (III) ion removal capacities through bath adsorption experiments. The structure and composition of composites were investigated by X-ray diffraction technique and scanning electron and atomic force microscopies. It was determined that adsorption followed pseudo-second-order kinetics, and the adsorption rate constants were calculated. A comparative study of the applicability of the adsorption models of Langmuir, Freundlich, and Dubinin–Radushkevich was carried out in order to describe the experimental isotherms of the prepared composite TeMs. The constants and parameters of all of the above equations were determined. By comparing the regression coefficients R2, it was shown that the Freundlich model describes the experimental data on the adsorption of arsenic through the studied samples better than others. Free energy of As(III) adsorption on the samples was determined using the Dubinin–Radushkevich isotherm model and was found to be 17.2 and 31.6 kJ/mol for Cu/PET and Cu/Ox_PET samples, respectively. The high EDr value observed for the Cu/Ox_PET composite indicates that the interaction between the adsorbate and the composite is based on chemisorption. © 2021 by the authors. Licensee MDPI, Basel, Switzerland.The research project titled “Development of functionalized composite track-etched membranes for environmental applications” (grant No. AP08855527) was funded by the Ministry of Education and Science of the Republic of Kazakhstan

Bioactive peptides and antinutrients in chickpea: description and properties (a review)

Legumes are a rich source of many different biologically active substances, such as fiber, proteins, vitamins and minerals. Chickpea (Cicer arietinum L.) is the third most important leguminous plant in the world: it has high nutritional value and is a source of a wide range of bioactive compounds. Bioactive peptides of chickpea seeds have antioxidant, ACE-inhibiting, cholesterollowering, antihypertensive, antimicrobial, antithrombotic, immunomodulatory, and opioid activities as well as the ability to bind minerals. But despite the benefits and high nutritional value, chickpea seeds contain antinutrients that reduce their nutritional and biological advantages. These antinutritional factors include condensed tannins, raffinose, and phytic acid. Research has shown that cooking, pregermination or fermentation can effectively reduce the indigestible content of chickpea seeds. For this purpose, it is recommended to use certain physical, chemical or biological methods: heat treatment, soaking and/or germination, enzymatic hydrolysis, irradiation, etc.This review article presents the world’s results of research aimed at studying bioactive chickpea peptides derived from chickpea seeds and ways of their formation as well as methods for elimination of antinutritional factors

A Novel Cu2O/ZnO@PET Composite Membrane for the Photocatalytic Degradation of Carbendazim

The extremely high levels of water pollution caused by various industrial activities represent one of the most important environmental problems. Efficient techniques and advanced materials have been extensively developed for the removal of highly toxic organic pollutants, including pesticides. This study investigated the photocatalytic degradation of the fungicide carbendazim (Czm) using composite track-etched membranes (TeMs) in an aqueous solution. Copper(I) oxide (Cu2O) and zinc oxide (ZnO) microtubes (MTs) were prepared using an electroless template deposition technique in porous poly(ethylene terephthalate) (PET) TeMs with nanochannels with a density of 4 × 107 pores/cm-2 and diameter of 385 _ 9 nm to yield Cu2O@PET and ZnO@PET composite membranes, respectively. A mixed Cu2O/ZnO@PET composite was prepared via a two-step deposition process, containing ZnO (87%) and CuZ (13%) as crystalline phases. The structure and composition of all composite membranes were elucidated using scanning electron microscopy (SEM), atomic force microscopy (AFM), energy-dispersive X-ray spectroscopy (EDS), X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD) techniques. Under UV-visible light irradiation, the Cu2O/ZnO@PET composite displayed enhanced photocatalytic activity, reaching 98% Czm degradation, higher than Cu2O@PET and ZnO@PET composites. The maximum Czm degradation efficiency from aqueous solution was obtained at an optimal pH of 6 and contact time of 140 min. The effects of various parameters such as temperature, catalyst dosage and sample exposure time on the photocatalytic degradation process were studied. The degradation reaction of Czm was found to follow the Langmuir-Hinshelwood mechanism and a pseudo-first order kinetic model. The degradation kinetics of Czm accelerated with increasing temperature, and the activation energy (Ea) levels were calculated as 11.9 kJ/mol, 14.22 kJ/mol and 15.82 kJ/mol for Cu2O/ZnO@PET, ZnO@PET and Cu2O@PET composite membranes, respectively. The reusability of the Cu2O/ZnO@PET catalyst was also investigated at different temperatures for 10 consecutive runs, without any activation or regeneration processes. The Cu2O/ZnO@PET composite exhibited degradation efficiency levels of over 50% at 14 °C and over 30% at 52 °C after 5 consecutive uses. © 2022 by the authors. Licensee MDPI, Basel, Switzerland.Ministry of Education and Science of the Republic of KazakhstanFunding: The research titled “Development of Functionalized Composite Track-Etched Membranes for Environmental Applications” (grant No AP08855527) was funded by the Ministry of Education and Science of the Republic of Kazakhstan