Ultra-high-sensitivity two-dimensional bend sensor

A multicore fibre Fabry-Perot-based strain sensor interrogated with tandem interferometry for bend measurement is described. Curvature in two dimensions is obtained by measuring the difference in strain between three co-located low finesse Fabry-Perot interferometers formed in each core of the fibre by pairs of Bragg gratings. This sensor provides a responsivity enhancement of up to 30 times that of a previously reported fibre Bragg grating based sensor. Strain resolutions of 0.6 n epsilon/Hz(1/2) above 1 Hz are demonstrated, which corresponds to a curvature resolution of similar to 0.012 km(-1)/Hz(1/2)

Design, Implementation and First Measurements with the Medipix Neutron Camera in CMS

The Medipix detector is the first device dedicated to measuring mixed-field radiation in the CMS cavern and able to distinguish between different particle types. Medipix2-MXR chips bump bonded to silicon sensors with various neutron conversion layers developed by the IEAP CTU in Prague were successfully installed for the 2008 LHC start-up in the CMS experimental and services caverns to measure the flux of various particle types, in particular neutrons. They have operated almost continuously during the 2010 run period, and the results shown here are from the proton run between the beginning of July and the end of October 2010. Clear signals are seen and different particle types have been observed during regular LHC luminosity running, and an agreement in the measured flux rate is found with the simulations. These initial results are promising, and indicate that these devices have the potential for further and future LHC and high energy physics applications as radiation monitoring devices for mixed field environments, including neutron flux monitoring. Further extensions are foreseen in the near future to increase the performance of the detector and its coverage for monitoring in CMS.Comment: 15 pages, 16 figures, submitted to JINS

Combined analysis of the salivary microbiome and host defence peptides predicts dental disease

Understanding the triad of host response, microbiome and disease status is potentially informative for disease prediction, prevention, early intervention and treatment. Using longitudinal assessment of saliva and disease status, we demonstrated that partial least squares modelling of microbial, immunological and clinical measures, grouped children according to future dental disease status. Saliva was collected and dental health assessed in 33 children aged 4 years, and again 1-year later. The composition of the salivary microbiome was assessed and host defence peptides in saliva were quantified. Principal component analysis of the salivary microbiome indicated that children clustered by age and not disease status. Similarly, changes in salivary host defence peptides occurred with age and not in response to, or preceding dental caries. Partial least squares modelling of microbial, immunological and clinical baseline measures clustered children according to future dental disease status. These data demonstrate that isolated evaluation of the salivary microbiome or host response failed to predict dental disease. In contrast, combined assessment of both host response together with the microbiome revealed clusters of health and disease. This type of approach is potentially relevant to myriad diseases that are modified by host–microbiome interactions

Quantitative localized proton-promoted dissolution kinetics of calcite using scanning electrochemical microscopy (SECM)

Scanning electrochemical microscopy (SECM) has been used to determine quantitatively the kinetics of proton-promoted dissolution of the calcite (101̅4) cleavage surface (from natural “Iceland Spar”) at the microscopic scale. By working under conditions where the probe size is much less than the characteristic dislocation spacing (as revealed from etching), it has been possible to measure kinetics mainly in regions of the surface which are free from dislocations, for the first time. To clearly reveal the locations of measurements, studies focused on cleaved “mirror” surfaces, where one of the two faces produced by cleavage was etched freely to reveal defects intersecting the surface, while the other (mirror) face was etched locally (and quantitatively) using SECM to generate high proton fluxes with a 25 μm diameter Pt disk ultramicroelectrode (UME) positioned at a defined (known) distance from a crystal surface. The etch pits formed at various etch times were measured using white light interferometry to ascertain pit dimensions. To determine quantitative dissolution kinetics, a moving boundary finite element model was formulated in which experimental time-dependent pit expansion data formed the input for simulations, from which solution and interfacial concentrations of key chemical species, and interfacial fluxes, could then be determined and visualized. This novel analysis allowed the rate constant for proton attack on calcite, and the order of the reaction with respect to the interfacial proton concentration, to be determined unambiguously. The process was found to be first order in terms of interfacial proton concentration with a rate constant k = 6.3 (± 1.3) × 10–4 m s–1. Significantly, this value is similar to previous macroscopic rate measurements of calcite dissolution which averaged over large areas and many dislocation sites, and where such sites provided a continuous source of steps for dissolution. Since the local measurements reported herein are mainly made in regions without dislocations, this study demonstrates that dislocations and steps that arise from such sites are not needed for fast proton-promoted calcite dissolution. Other sites, such as point defects, which are naturally abundant in calcite, are likely to be key reaction sites

Theory of Pump Depletion and Spike Formation in Stimulated Raman Scattering

By using the inverse spectral transform, the SRS equations are solved and the explicit output data is given for arbitrary laser pump and Stokes seed profiles injected on a vacuum of optical phonons. For long duration laser pulses, this solution is modified such as to take into account the damping rate of the optical phonon wave. This model is used to interprete the experiments of Druhl, Wenzel and Carlsten (Phys. Rev. Lett., (1983) vol. 51, p. 1171), in particular the creation of a spike of (anomalous) pump radiation. The related nonlinear Fourier spectrum does not contain discrete eigenvalue, hence this Raman spike is not a soliton.Comment: LaTex file, includes two figures in LaTex format, 9 page

Investigation of shock waves in explosive blasts using fibre optic pressure sensors

The published version of this article may be accessed at the link below. Copyright @ IOP Publishing, 2006.We describe miniature all-optical pressure sensors, fabricated by wafer etching techniques, less than 1 mm(2) in overall cross-section with rise times in the mu s regime and pressure ranges typically 900 kPa (9 bar). Their performance is suitable for experimental studies of the pressure-time history for test models exposed to shocks initiated by an explosive charge. The small size and fast response of the sensors promises higher quality data than has been previously available from conventional electrical sensors, with potential improvements to numerical models of blast effects. Results from blast tests are presented in which up to six sensors were multiplexed, embedded within test models in a range of orientations relative to the shock front.Support from the UK Engineering&Physical Sciences Research Council and Dstl Fort Halstead through the MoD Joint Grants Scheme are acknowledged. WN MacPherson is supported by an EPSRC Advanced Research Fellowship

Antimicrobial resistance: a biopsychosocial problem requiring innovative interdisciplinary and imaginative interventions

To date, antimicrobials have been understood through largely biomedical perspectives. There has been a tendency to focus upon the effectiveness of pharmaceuticals within individual bodies. However, the growing threat of antimicrobial resistance demands we reconsider how we think about antimicrobials and their effects. Rather than understanding them primarily within bodies, it is increasingly important to consider their effects between bodies, between species and across environments. We need to reduce the drivers of antimicrobial resistance (AMR) at a global level, focusing on the connections between prescribing in one country and resistance mechanisms in another. We need to engage with the ways antimicrobials within the food chain will impact upon human healthcare. Moreover, we need to realise what happens within the ward will impact upon the environment (through waste water). In the future, imaginative interventions will be required that must make the most of biomedicine but draw equally across a wider range of disciplines (e.g. engineering, ecologists) and include an ever-increasing set of professionals (e.g. nurses, veterinarians and farmers). Such collective action demands a shift to working in new interdisciplinary, inter-professional ways. Mutual respect and understanding is required to enable each perspective to be combined to yield synergistic effects

Intra-individual movement variability during skill transitions: A useful marker?

Applied research suggests athletes and coaches need to be challenged in knowing when and how much a movement should be consciously attended to. This is exacerbated when the skill is in transition between two more stable states, such as when an already well learnt skill is being refined. Using existing theory and research, this paper highlights the potential application of movement variability as a tool to inform a coach’s decision-making process when implementing a systematic approach to technical refinement. Of particular interest is the structure of co-variability between mechanical degrees-of-freedom (e.g., joints) within the movement system’s entirety when undergoing a skill transition. Exemplar data from golf are presented, demonstrating the link between movement variability and mental effort as an important feature of automaticity, and thus intervention design throughout the different stages of refinement. Movement variability was shown to reduce when mental effort directed towards an individual aspect of the skill was high (target variable). The opposite pattern was apparent for variables unrelated to the technical refinement. Therefore, two related indicators, movement variability and mental effort, are offered as a basis through which the evaluation of automaticity during technical refinements may be made

On the length of chains of proper subgroups covering a topological group

We prove that if an ultrafilter L is not coherent to a Q-point, then each analytic non-sigma-bounded topological group G admits an increasing chain <G_a : a of its proper subgroups such that: (i) U_{a in b(L)} G_a=G; and $(ii)$ For every sigma-bounded subgroup H of G there exists a such that H is a subset of G_a. In case of the group Sym(w) of all permutations of w with the topology inherited from w^w this improves upon earlier results of S. Thomas

Ambiguous figures and the content of experience

Representationalism is the position that the phenomenal character of an experience is either identical with, or supervenes on, the content of that experience. Many representationalists hold that the relevant content of experience is nonconceptual. I propose a counterexample to this form of representationalism that arises from the phenomenon of Gestalt switching, which occurs when viewing ambiguous figures. First, I argue that one does not need to appeal to the conceptual content of experience or to judgements to account for Gestalt switching. I then argue that experiences of certain ambiguous figures are problematic because they have different phenomenal characters but that no difference in the nonconceptual content of these experiences can be identified. I consider three solutions to this problem that have been proposed by both philosophers and psychologists and conclude that none can account for all the ambiguous figures that pose the problem. I conclude that the onus is on representationalists to specify the relevant difference in content or to abandon their position