Brueckner-Hartree-Fock and its renormalized calculations for finite nuclei

We have performed self-consistent Brueckner-Hartree-Fock (BHF) and its renormalized theory to the structure calculations of finite nuclei. The $G$-matrix is calculated within the BHF basis, and the exact Pauli exclusion operator is determined by the BHF spectrum. Self-consistent occupation probabilities are included in the renormalized Brueckner-Hartree-Fock (RBHF). Various systematics and convergences are studies. Good results are obtained for the ground-state energy and radius. RBHF can give a more reasonable single-particle spectrum and radius. We present a first benchmark calculation with other {\it ab initio} methods using the same effective Hamiltonian. We find that the BHF and RBHF results are in good agreement with other $\it{ab}$ $\it{initio}$ methods

Parton Distributions at Hadronization from Bulk Dense Matter Produced at RHIC

We present an analysis of $\Omega$, $\Xi$, $\Lambda$ and $\phi$ spectra from Au+Au collisions at $\sqrt{s_{NN}}=200$ GeV in terms of distributions of effective constituent quarks at hadronization. Consistency in quark ratios derived from various hadron spectra provides clear evidence for hadron formation dynamics as suggested by quark coalescence or recombination models. We argue that the constituent quark distribution reflects properties of the effective partonic degrees of freedom at hadronization. Experimental data indicate that strange quarks have a transverse momentum distribution flatter than that of up/down quarks consistent with hydrodynamic expansion in partonic phase prior to hadronization. After the AMPT model is tuned to reproduce the strange and up/down quark distributions, the model can describe the measured spectra of hyperons and $\phi$ mesons very well where hadrons are formed through dynamical coalescence.Comment: 5 pages, 3 figures, two more paragraph added to address the referee's comment, figure updated to include the KET scale. Accepted version to appear in Phys. Rev.

Semisolid processing characteristics of AM series Mg alloys by rheo-diecasting

The official published version of this Article can be found at the link below - Copyright @ 2006 ASM InternationalAn investigation has been made into the solidification behavior and microstructural evolution of AM50, AM70, and AM90 alloys during rheo-diecasting, their processibility, and the resulting mechanical properties. It was found that solidification of AM series alloys under intensive melt shearing in the unique twin-screw slurry maker during rheo-diecasting gave rise to numerous spheroidal primary magnesium (Mg) particles that were uniformly present in the microstructure. As a result, the network of the beta-Mg17Al12 phase was consistently interrupted by these spheroidal and ductile particles. Such a microstructure reduced the obstacle of deformation and the harmfulness of the beta-Mg17Al12 network on ductility, and therefore improved the ductility of rheo-diecast AM alloys. It was shown that, even with 9 wt pct Al, the elongation of rheo-diecast AM90 still achieved (9 +/- 1.2) pct. Rheodiecasting thus provides an attractive processing route for upgrading the alloy specification of AM series alloys by increasing the aluminum (Al) content while ensuring ductility. Assessment of the processibility of AM series alloys for semisolid processing showed that high Al content AM series alloys are more suitable for rheo-diecasting than low Al content alloys, because of the lower sensitivity of solid fraction to temperature, the lower liquidus temperature, and the smaller interval between the semisolid processing temperature and the complete solidification temperature.This work is supported by the EPSR

Atomically precise lateral modulation of a two-dimensional electron liquid in anatase TiO2 thin films

Engineering the electronic band structure of two-dimensional electron liquids (2DELs) confined at the surface or interface of transition metal oxides is key to unlocking their full potential. Here we describe a new approach to tailoring the electronic structure of an oxide surface 2DEL demonstrating the lateral modulation of electronic states with atomic scale precision on an unprecedented length scale comparable to the Fermi wavelength. To this end, we use pulsed laser deposition to grow anatase TiO2 films terminated by a (1 x 4) in-plane surface reconstruction. Employing photo-stimulated chemical surface doping we induce 2DELs with tunable carrier densities that are confined within a few TiO2 layers below the surface. Subsequent in-situ angle resolved photoemission experiments demonstrate that the (1 x 4) surface reconstruction provides a periodic lateral perturbation of the electron liquid. This causes strong backfolding of the electronic bands, opening of unidirectional gaps and a saddle point singularity in the density of states near the chemical potential