Formation of Myoglobin Corona at Polymer Microparticles

Adsorption of myoglobin molecules at negatively charged polystyrene microparticles was studied using the dynamic light scattering (DLS), electrophoresis (LDV) and the solution depletion method involving atomic force microscopy (AFM). The measurements were carried out at pH 3.5 and NaCl concentration of 10−2 and 0.15 M. Initially, the stability of myoglobin solutions and the particle suspensions as a function of pH were determined. Afterward, the formation of myoglobin molecule corona was investigated via the direct electrophoretic mobility measurements, which were converted to the zeta potential. The experimental results were quantitatively interpreted in terms of the general electrokinetic model. This approach yielded the myoglobin corona coverage under in situ conditions. The maximum hard corona coverage was determined using the AFM concentration depletion method. It was equal to 0.9 mg m−2 for the NaCl concentration in the range 0.01 to 0.15 M and pH 3.5. The electrokinetic properties of the corona were investigated using the electrophoretic mobility measurements for a broad pH range. The obtained results confirmed that thorough physicochemical characteristics of myoglobin molecules can be acquired using nM amounts of the protein. It was also argued that this method can be used for performing electrokinetic characteristics of other proteins such as the SARS-Cov-2 spike protein exhibiting, analogously to myoglobin, a positive charge at acidic pHs

Mechanism of Myoglobin Molecule Adsorption on Silica: QCM, OWLS and AFM Investigations

Adsorption kinetics of myoglobin on silica was investigated using the quartz crystal microbalance (QCM) and the optical waveguide light-mode spectroscopy (OWLS). Measurements were carried out for the NaCl concentration of 0.01 M and 0.15 M. A quantitative analysis of the kinetic adsorption and desorption runs acquired from QCM allowed to determine the maximum coverage of irreversibly bound myoglobin molecules. At a pH of 3.5–4 this was equal to 0.60 mg m−2 and 1.3 mg m−2 for a NaCl concentration of 0.01 M and 0.15 M, respectively, which agrees with the OWLS measurements. The latter value corresponds to the closely packed monolayer of molecules predicted from the random sequential adsorption approach. The fraction of reversibly bound protein molecules and their biding energy were also determined. It is observed that at larger pHs, the myoglobin adsorption kinetics was much slower. This behavior was attributed to the vanishing net charge that decreased the binding energy of molecules with the substrate. These results can be exploited to develop procedures for preparing myoglobin layers at silica substrates of well-controlled coverage useful for biosensing purposes

Mimicking pseudo-virion interactions with abiotic surfaces : deposition of polymer nanoparticles with albumin corona

Adsorption of human serum albumin (HSA) molecules on negatively charged polystyrene microparticles was studied using the dynamic light scattering, the electrophoretic and the solution depletion methods involving atomic force microscopy. Initially, the physicochemical characteristics of the albumin comprising the hydrodynamic diameter, the zeta potential and the isoelectric point were determined as a function of pH. Analogous characteristics of the polymer particles were acquired, including their size and zeta potential. The formation of albumin corona on the particles was investigated in situ by electrophoretic mobility measurements. The size, stability and electrokinetic properties of the particles with the corona were also determined. The particle diameter was equal to 125 nm, which coincides with the size of the SARS-CoV-2 virion. The isoelectric point of the particles appeared at a pH of 5. The deposition kinetics of the particles was determined by atomic force microscopy (AFM) under diffusion and by quartz microbalance (QCM) under flow conditions. It was shown that the deposition rate at a gold sensor abruptly vanished with pH following the decrease in the zeta potential of the particles. It is postulated that the acquired results can be used as useful reference systems mimicking virus adsorption on abiotic surfaces

Quantifying Nanoparticle Layer Topography: Theoretical Modeling and Atomic Force Microscopy Investigations

A comprehensive method consisting of theoretical modeling and experimental atomic force microscopy (AFM) measurements was developed for the quantitative analysis of nanoparticle layer topography. Analytical results were derived for particles of various shapes such as cylinders (rods), disks, ellipsoids, hemispheres (caps), etc. It was shown that for all particles, their root-mean-square (rms) parameter exhibited a maximum at the coverage about 0.5, whereas the skewness was a monotonically decreasing function of the coverage. This enabled a facile determination of the particle coverage in the layer, even if the shape and size were not known. The validity of the analytical results was confirmed by computer modeling and experimental data acquired by AFM measurements for polymer nanoparticle deposition on mica and silica. The topographical analysis developed in this work can be exploited for a quantitative characterization of self-assembled layers of nano- and bioparticles, e.g., carbon nanotubes, silica and noble metal particles, DNA fragments, proteins, vesicles, viruses, and bacteria at solid surfaces. The acquired results also enabled a proper calibration, in particular the determination of the measurement precision, of various electron and scanning probe microscopies, such as AFM

Recombinant Albumin Monolayers on Latex Particles

The adsorption of recombinant human serum albumin (rHSA) on negatively charged polystyrene latex micro-particles was studied at pH 3.5 and the NaCl concentration range of 10^–3 to 0.15 M. The electrophoretic mobility of latex monotonically increased with the albumin concentration in the suspension. The coverage of adsorbed albumin was quantitatively determined using the depletion method, where the residual protein concentration was determined by electrokinetic measurements and AFM imaging. It was shown that albumin adsorption was irreversible. Its maximum coverage on latex varied between 0.7 mg m^–2 for 10^–3 M NaCl to 1.3 mg m^–2 for 0.15 M NaCl. The latter value matches the maximum coverage previously determined for human serum albumin on mica using the streaming potential method. The increase in the maximum coverage was interpreted in terms of reduced electrostatic repulsion among adsorbed molecules. These facts confirm that albumin adsorption at pH 3.5 is governed by electrostatic interactions and proceeds analogously to colloid particle deposition. The stability of albumin monolayers was measured in additional experiments where changes in the latex electrophoretic mobility and the concentration of free albumin in solutions were monitored over prolonged time periods. Based on these experimental data, a robust procedure of preparing albumin monolayers on latex particles of well-controlled coverage and molecule distribution was proposed