37,077 research outputs found
Detection of changes in the characteristics of a Gauss-Markov process
Sequential detection of changes in Gauss-Markov process achieved through probability ratio tes
Analysis of opposed jet hydrogen-air counter flow diffusion flame
A computational simulation of the opposed-jet diffusion flame is performed to study its structure and extinction limits. The present analysis concentrates on the nitrogen-diluted hydrogen-air diffusion flame, which provides the basic information for many vehicle designs such as the aerospace plane for which hydrogen is a candidate as the fuel. The computer program uses the time-marching technique to solve the energy and species equations coupled with the momentum equation solved by the collocation method. The procedure is implemented in two stages. In the first stage, a one-step forward overal chemical reaction is chosen with the gas phase chemical reaction rate determined by comparison with experimental data. In the second stage, a complete chemical reaction mechanism is introduced with detailed thermodynamic and transport property calculations. Comparison between experimental extinction data and theoretical predictions is discussed. The effects of thermal diffusion as well as Lewis number and Prandtl number variations on the diffusion flame are also presented
A suspended microchannel with integrated temperature sensors for high-pressure flow studies
A freestanding microchannel, with integrated temperature sensors, has been developed for high-pressure flow studies. These microchannels are approximately 20ÎĽm x 2ÎĽm x 4400ÎĽm, and are suspended above 80 ÎĽm deep cavities, bulk micromachined using BrF3 dry etch. The calibration of the lightly boron-doped thermistor-type sensors shows that the resistance sensitivity of these integrated sensors is parabolic with respect to temperature and linear with respect to pressure. Volumetric flow rates of N2 in the microchannel were measured at inlet pressures up to 578 psig. The discrepancy between the data and theory results from the flow acceleration in a channel, the non-parabolic velocity profile, and the bulging of the channel. Bulging effects were evaluated by using incompressible water flow measurements, which also measures 1.045x10^-3N-s/m^2 for the viscosity of DI water. The temperature data from sensors on the channel shows the heating of the channel due to the friction generated by the high-pressure flow inside
Efficient out-coupling and beaming of Tamm optical states via surface plasmon polariton excitation
We present evidence of optical Tamm states to surface plasmon polariton (SPP) coupling. We experimentally demonstrate that for a Bragg stack with a thin metal layer on the surface, hybrid Tamm-SPP modes may be excited when a grating on the air-metal interface is introduced. Out-coupling via the grating to free space propagation is shown to enhance the transmission as well as the directionality and polarization selection for the transmitted beam. We suggest that this system will be useful on those devices, where a metallic electrical contact as well as beaming and polarization control is needed
Micro heat exchanger by using MEMS impinging jets
A micro impinging-jet heat exchanger is presented here. Heat transfer is studied for single jet, slot arrays and jet arrays. In order to facilitate micro heat transfer measurements with these devices, a MEMS sensor chip, which has an 8 x 8 temperature-sensor array on one side, and an integrated heater on the other side has been designed and fabricated. This sensor chip allows 2-D surface temperature
measurement with various jets impinging on it. It is
found that micro impinging jets can be highly efficient when compared to existing macro impinging-jet microelectronics packages such as IBM 4381. For example, using a single nozzle jet (500-μm diameter driven by 5 psig pressure), the sensor chip (2 x 2 cm^2) temperature can be cooled down from 70 to 33°C. The cooling becomes more efficient when
nozzle arrays (4x5 over 1 cm^2 area) are used under
the same driving pressure. Interestingly, although
higher driving pressure gives better cooling (lower
surface temperature), the cooling efficiency, defined
as h/0.5pv^2, is actually higher for lower driving
pressure
The fluctuation spectra around a Gaussian classical solution of a tensor model and the general relativity
Tensor models can be interpreted as theory of dynamical fuzzy spaces. In this
paper, I study numerically the fluctuation spectra around a Gaussian classical
solution of a tensor model, which represents a fuzzy flat space in arbitrary
dimensions. It is found that the momentum distribution of the low-lying
low-momentum spectra is in agreement with that of the metric tensor modulo the
general coordinate transformation in the general relativity at least in the
dimensions studied numerically, i.e. one to four dimensions. This result
suggests that the effective field theory around the solution is described in a
similar manner as the general relativity.Comment: 29 pages, 13 figure
The lowest modes around Gaussian solutions of tensor models and the general relativity
In the previous paper, the number distribution of the low-lying spectra
around Gaussian solutions representing various dimensional fuzzy tori of a
tensor model was numerically shown to be in accordance with the general
relativity on tori. In this paper, I perform more detailed numerical analysis
of the properties of the modes for two-dimensional fuzzy tori, and obtain
conclusive evidences for the agreement. Under a proposed correspondence between
the rank-three tensor in tensor models and the metric tensor in the general
relativity, conclusive agreement is obtained between the profiles of the
low-lying modes in a tensor model and the metric modes transverse to the
general coordinate transformation. Moreover, the low-lying modes are shown to
be well on a massless trajectory with quartic momentum dependence in the tensor
model. This is in agreement with that the lowest momentum dependence of metric
fluctuations in the general relativity will come from the R^2-term, since the
R-term is topological in two dimensions. These evidences support the idea that
the low-lying low-momentum dynamics around the Gaussian solutions of tensor
models is described by the general relativity. I also propose a renormalization
procedure for tensor models. A classical application of the procedure makes the
patterns of the low-lying spectra drastically clearer, and suggests also the
existence of massive trajectories.Comment: 31 pages, 8 figures, Added references, minor corrections, a
misleading figure replace
Recommended from our members
A micro-electro-mechanical-system-based thermal shear-stress sensor with self-frequency compensation
By applying the micro-electro-mechanical-system (MEMS) fabrication technology, we developed a micro-thermal sensor to measure surface shear stress. The heat transfer from a polysilicon heater depends on the normal velocity gradient and thus provides the surface shear stress. However, the sensitivity of the shear-stress measurements in air is less than desirable due to the low heat capacity of air. A unique feature of this micro-sensor is that the heating element, a film 1 µm thick, is separated from the substrate by a vacuum cavity 2 µm thick. The vacuum cavity prevents the conduction of heat to the substrate and therefore improves the sensitivity by an order of magnitude. Owing to the low thermal inertia of the miniature sensing element, this shear-stress micro-sensor can provide instantaneous measurements of small-scale turbulence. Furthermore, MEMS technology allows us make multiple sensors on a single chip so that we can perform distributed measurements. In this study, we use multiple polysilicon sensor elements to improve the dynamic performance of the sensor itself. It is demonstrated that the frequency-response range of a constant-current sensor can be extended from the order of 100 Hz to 100 kHz
- …