Performance of cryogenic microbolometers and calorimeters with on-chip coolers

Astronomical observations of cosmic sources in the far-infrared and X-ray bands require extreme sensitivity. The most sensitive detectors are cryogenic bolometers and calorimeters operating typically at about 100 mK. The last stage of cooling (from 300 mK to 100 mK) often poses significant difficulties in space-borne experiments, both in system complexity and reliability. We address the possibility of using refrigeration based on normal metal/insulator/superconductor (NIS) tunnel junctions as the last stage cooler for cryogenic thermal detectors. We compare two possible schemes: the direct cooling of the electron gas of the detector with the aid of NIS tunnel junctions and the indirect cooling method, when the detector lattice is cooled by the refrigerating system, while the electron gas temperature is decreased by electron-phonon interaction. The latter method is found to allow at least an order of magnitude improvement in detector noise equivalent power, when compared to the direct electron cooling.Comment: 3 pages, 1 figur

A superconducting antenna-coupled hot-spot microbolometer

We report the electrical properties of an antenna-coupled niobium vacuum-bridge bolometer, operated at a temperature of 4.2 K, in which the thermal isolation is maximized by the vacuum gap between the bridge and the underlying silicon substrate. The device is voltage-biased, which results in a formation of a normal state region in the middle of the bridge. The device shows a current responsivity of −1430 A/W and an amplifier limited electrical noise equivalent power of 1.4×10−14 W/√Hz.Peer reviewe

Multiplexed readout of kinetic inductance bolometer arrays

Kinetic inductance bolometer (KIB) technology is a candidate for passive sub-millimeter wave and terahertz imaging systems. Its benefits include scalability into large 2D arrays and operation with intermediate cryogenics in the temperature range of 5 -- 10 K. We have previously demonstrated the scalability in terms of device fabrication, optics integration, and cryogenics. In this article, we address the last missing ingredient, the readout. The concept, serial addressed frequency excitation (SAFE), is an alternative to full frequency-division multiplexing at microwave frequencies conventionally used to read out kinetic inductance detectors. We introduce the concept, and analyze the criteria of the multiplexed readout avoiding the degradation of the signal-to-noise ratio in the presence of a thermal anti-alias filter inherent to thermal detectors. We present a practical scalable realization of a readout system integrated into a prototype imager with 8712 detectors. This is used for demonstrating the noise properties of the readout. Furthermore, we present practical detection experiments with a stand-off laboratory-scale imager.Comment: 7 pages, 6 figure

Effect of a thin AlO_x layer on transition-edge sensor properties

We have studied the physics of transition-edge sensor (TES) devices with an insulating AlOx layer on top of the device to allow implementation of more complex detector geometries. By comparing devices with and without the insulating film, we have observed significant additional noise apparently caused by the insulator layer. In addition, AlOx was found to be a relatively good thermal conductor. This adds an unforeseen internal thermal feature to the system.Comment: 6 pages, 5 figures, Low Temperature Detectors 14 conferenc

Quantization of the elastic modes in an isotropic plate

We quantize the elastic modes in a plate. For this, we find a complete, orthogonal set of eigenfunctions of the elastic equations and we normalize them. These are the phonon modes in the plate and their specific forms and dispersion relations are manifested in low temperature experiments in ultra-thin membranes.Comment: 14 pages, 2 figure

Fluctuation superconductivity limited noise in a transition-edge sensor

In order to investigate the origin of the until now unaccounted excess noise and to minimize the uncontrollable phenomena at the transition in X-ray microcalorimeters we have developed superconducting transition-edge sensors into an edgeless geometry, the so-called Corbino disk (CorTES), with superconducting contacts in the centre and at the outer perimeter. The measured rms current noise and its spectral density can be modeled as resistance noise resulting from fluctuations near the equilibrium superconductor-normal metal boundaryComment: 9 pages, 4 figures.; Corrections to text and equations; replaced the affected figures. Added reference [12

A monolithic resonant terahertz sensor element comprising a metamaterial absorber and micro-bolometer

In this article a monolithic resonant terahertz sensor element with a noise equivalent power superior to that of typical commercial room temperature single pixel terahertz detectors and capable of close to real time read-out rates is presented. The detector is constructed via the integration of a metamaterial absorber and a micro-bolometer sensor. An absorption magnitude of 57% at 2.5 THz, a minimum NEP of inline image and a thermal time constant of 68 ms for the sensor are measured. As a demonstration of detector capability, it is employed in a practical Nipkow terahertz imaging system. The monolithic resonant terahertz detector is readily scaled to focal plane array formats by adding standard read-out and addressing circuitry enabling compact, low-cost terahertz imaging

Ultrasensitive Proximity Josephson Sensor with Kinetic Inductance Read-Out

We propose a mesoscopic kinetic-inductance radiation detector based on a long superconductor--normal metal--superconductor Josephson junction. The operation of this proximity Josephson sensor (PJS) relies on large kinetic inductance variations under irradiation due to the exponential temperature dependence of the critical current. Coupled with a dc SQUID readout, the PJS is able to provide a signal to noise (S/N) ratio up to ~10^3 in the THz regime if operated as calorimeter, while electrical noise equivalent power (NEP) as low as ~7x10^{-20} W(Hz)^(-1/2) at 200 mK can be achieved in the bolometer operation. The high performance together with the ease of fabrication make this structure attractive as an ultrasensitive cryogenic detector of THz electromagnetic radiation.Comment: 4 pages, 3 figure

Influence of temperature gradients on tunnel junction thermometry below 1 K: cooling and electron-phonon coupling

We have studied thermal gradients in thin Cu and AlMn wires, both experimentally and theoretically. In the experiments, the wires were Joule heated non-uniformly at sub-Kelvin temperatures, and the resulting temperature gradients were measured using normal metal-insulator-superconducting tunnel junctions. The data clearly shows that even in reasonably well conducting thin wires with a short ($\sim 10 \mu$m) non-heated portion, significant temperature differences can form. In most cases, the measurements agree well with a model which includes electron-phonon interaction and electronic thermal conductivity by the Wiedemann-Franz law.Comment: J. Low Temp. Phys. in pres