Cytostatic Drug 6-Mercaptopurine Degradation on Pilot Scale Reactors by Advanced Oxidation Processes: UV-C/H2O2 and UV-C/TiO2/H2O2 Kinetics

6-Mercaptopurine (6-MP) is a commonly used cytostatic agent, which represents a particular hazard for the environment because of its low biodegradability. In order to degrade 6-MP, four processes were applied: Photolysis (UV-C), photocatalysis (UV-C/TiO2), and their combination with H2O2, by adding 3 mM H2O2/L (UV-C/H2O2 and UV-C/TiO2/H2O2 processes). Each process was performed with variable initial pH (3.5, 7.0, and 9.5). Pilot scale reactors were used, using UV-C lamps as radiation source. Kinetic calculations for the first 20 min of reaction show that H2O2 addition is of great importance: in UV-C experiments, highest k was reached under pH 3.5, k = 0.0094 min−1, while under UV-C/H2O2, k = 0.1071 min−1 was reached under the same initial pH; similar behavior was observed for photocatalysis, as k values of 0.0335 and 0.1387 min−1 were calculated for UV-C/TiO2 and UV-C/TiO2/H2O2 processes, respectively, also under acidic conditions. Degradation percentages here reported for UV-C/H2O2 and UV-C/TiO2/H2O2 processes are above 90% for all tested pH values. Ecotoxicity analysis of samples taken at 60 min in the photolysis and photocatalysis processes, suggests that contaminant degradation by-products present higher toxicity than the original compound

Study of Influence Factors in the Evaluation of the Performance of a Photocatalytic Fibre Reactor (TiO₂/SiO₂) for the Removal of Organic Pollutants from Water

The performance of a photocatalytic fibre reactor (UBE Chemical Europe), made of cartridges of fine particles of TiO2 dispersed within silicon fibres and irradiated by ultraviolet light, for the removal of organic pollutants from synthetic waters was evaluated. In the sensitivity analysis carried out, the factors catalytic surface area, fibre state, temperature and initial substrate concentration were studied using 4-chlorophenol as a test compound. The percentage of titanium in the fibre remained practically invariable after a series of experiments and cleaning procedures. Furthermore, the kinetics of removal of pyrene, phenol, 4-chlorophenol and bisphenol A (BPA) from water were evaluated by means of HPLC, UV-absorption and fluorescence techniques. Kinetic operational parameters were determined from a mathematical model proposed by Langmuir–Hinshelwood. Results show that catalytic surface, initial substrate concentration and temperature directly affect the degradation rate of organic compounds, whereas fibre state does not have a significant effect on that. It is proposed that removal of organic compounds from water mainly depends on the adsorption of the specific pollutant on the photocatalytic fibre and on the physical diffusion of the substrate towards the photocatalytic TiO2 active sites on the fibre, with the heterogeneous phase reaction prevailing over the homogeneous phase reaction

Kinetic Study and Modeling of the Degradation of Aqueous Ammonium/Ammonia Solutions by Heterogeneous Photocatalysis with TiO2 in a UV-C Pilot Photoreactor

The degradation mechanism of NH4+/NH3 in aqueous solutions by heterogeneous photocatalysis (TiO2/SiO2) and photolysis in UV-C pilot photoreactor has been studied. Under the conditions used, NH4+/NH3 can be decomposed both by photolytically and photocatalytically, without disregarding stripping processes. The greatest degradation is achieved at the highest pH studied (pH 11.0) and at higher lamp irradiation power used (25 W) with degradation performances of 44.1% (photolysis) and 59.7% (photocatalysis). The experimental kinetic data fit well with a two parallel reactions mechanism. A low affinity of ammonia for adsorption and surface reaction on the photocatalytic fiber was observed (coverage not higher than 10%), indicating a low influence of surface phenomena on the reaction rate, the homogeneous phase being predominant over the heterogeneous phase. The proposed reaction mechanism was validated, confirming that it is consistent with the photocatalytic and photolytic formation of nitrogen gas, on the one hand, and the formation of nitrate, on the other hand. At the optimal conditions, the rate constants were k3 = 0.154 h−1 for the disappearance of ammonia and k1 = 3.3 ± 0.2 10−5 h−1 and k2 = 1.54 ± 0.07 10−1 h−1 for the appearance of nitrate and nitrogen gas, respectively

Kinetic Study and Modeling of the Degradation of Aqueous Ammonium/Ammonia Solutions by Heterogeneous Photocatalysis with TiO₂ in a UV-C Pilot Photoreactor

The degradation mechanism of NH4+/NH3 in aqueous solutions by heterogeneous photocatalysis (TiO2/SiO2) and photolysis in UV-C pilot photoreactor has been studied. Under the conditions used, NH4+/NH3 can be decomposed both by photolytically and photocatalytically, without disregarding stripping processes. The greatest degradation is achieved at the highest pH studied (pH 11.0) and at higher lamp irradiation power used (25 W) with degradation performances of 44.1% (photolysis) and 59.7% (photocatalysis). The experimental kinetic data fit well with a two parallel reactions mechanism. A low affinity of ammonia for adsorption and surface reaction on the photocatalytic fiber was observed (coverage not higher than 10%), indicating a low influence of surface phenomena on the reaction rate, the homogeneous phase being predominant over the heterogeneous phase. The proposed reaction mechanism was validated, confirming that it is consistent with the photocatalytic and photolytic formation of nitrogen gas, on the one hand, and the formation of nitrate, on the other hand. At the optimal conditions, the rate constants were k3 = 0.154 h−1 for the disappearance of ammonia and k1 = 3.3 ± 0.2 10−5 h−1 and k2 = 1.54 ± 0.07 10−1 h−1 for the appearance of nitrate and nitrogen gas, respectively

Solar Heterogenous Photocatalytic Degradation of Methylthionine Chloride on a Flat Plate Reactor: Effect of pH and H₂O₂ Addition

Methylthionine chloride (MTC) is a compound with several applications both in the clinical and medical industries. Nevertheless, such compounds can become an environmental problem, as they are not properly treated by wastewater treatment plants. This objective of this work was to study MTC degradation in a flat plate reactor through solar photolysis and heterogeneous photocatalysis processes with TiO2 as a catalyst. In addition to the processes, three pH (3.5, 6.5, and 9) and the effect of H2O2 addition (no dose, 0.5, and 1 mM/L) were tested. The results show that acidic pH is the most appropriate for MTC degradation, which ranged between 56% and 68.7% for photolysis and between 76% and 86.7% in photocatalysis. The H2O2 addition resulted in lower degradation in all cases, leading the authors to conclude that the presence of peroxide actually hinders degradation in solar photolysis and photocatalysis processes. Statistical analysis showed that the constant rate reactions calculated for every process, under the same conditions of pH and H2O2 addition, are significantly different from one another, and the three factors considered for experimental design (process, pH, and H2O2) have a statistically significant effect on MTC degradation. The collector area per order confirmed higher efficiency for photocatalysis when compared to photolysis processes

Characterization and Comparative Performance of TiO2 Photocatalysts on 6-Mercaptopurine Degradation by Solar Heterogeneous Photocatalysis

The crystallographic properties of two titanium dioxide (TiO2) photocatalysts, P25, and commercial C1-TiO2 reactive grade, were analyzed by X-ray diffraction (XRD) and the band-gap was calculated with UV–Vis spectrometry with integration sphere. Then, their performance was tested in the degradation of 6-mercaptopurine (6-MP) by heterogeneous photocatalysis with solar radiation under different pH conditions and the addition of hydrogen peroxide (H2O2); the degradation efficiency was monitored by UV–Vis spectrophotometry. The XRD analysis showed that both photocatalysts studied have anatase phase, while only P25 contains rutile; the band gap values were lower, in both catalysts, than those reported for catalysts obtained by the sol-gel method. With both photocatalysts, degradation experiments showed efficiency greater than 98% in experiments in the presence of H2O2 regardless of pH. The properties of the photocatalysts, along with the data obtained from the experimentation, helped determine the best semiconductor for the degradation of 6-MP with these operating conditions in this work

Platelet Membrane: An Outstanding Factor in Cancer Metastasis

In addition to being biological barriers where the internalization or release of biomolecules is decided, cell membranes are contact structures between the interior and exterior of the cell. Here, the processes of cell signaling mediated by receptors, ions, hormones, cytokines, enzymes, growth factors, extracellular matrix (ECM), and vesicles begin. They triggering several responses from the cell membrane that include rearranging its components according to the immediate needs of the cell, for example, in the membrane of platelets, the formation of filopodia and lamellipodia as a tissue repair response. In cancer, the cancer cells must adapt to the new tumor microenvironment (TME) and acquire capacities in the cell membrane to transform their shape, such as in the case of epithelial−mesenchymal transition (EMT) in the metastatic process. The cancer cells must also attract allies in this challenging process, such as platelets, fibroblasts associated with cancer (CAF), stromal cells, adipocytes, and the extracellular matrix itself, which limits tumor growth. The platelets are enucleated cells with fairly interesting growth factors, proangiogenic factors, cytokines, mRNA, and proteins, which support the development of a tumor microenvironment and support the metastatic process. This review will discuss the different actions that platelet membranes and cancer cell membranes carry out during their relationship in the tumor microenvironment and metastasis

Do the Naica giant crystals deteriorate due to human sction?

Resumen del trabajo presentado al 25th international Congress on X-ray optic and microanalysis (ICXOM), celebrado en EE.UU. del 5 al 9 de agosto de 2019.The support given by CONACYT Project No. 183706 and by SSRL, ELETTRA, ESRF synchrotron facilities is acknowledged. Authors are thankful to Cia. Peñoles and Naica Mine for providing samples

A snapshot of antimicrobial resistance in Mexico. Results from 47 centers from 20 states during a six-month period.

AIM:We aimed to assess the resistance rates of antimicrobial-resistant, in bacterial pathogens of epidemiological importance in 47 Mexican centers. MATERIAL AND METHODS:In this retrospective study, we included a stratified sample of 47 centers, covering 20 Mexican states. Selected isolates considered as potential causatives of disease collected over a 6-month period were included. Laboratories employed their usual methods to perform microbiological studies. The results were deposited into a database and analyzed with the WHONET 5.6 software. RESULTS:In this 6-month study, a total of 22,943 strains were included. Regarding Gram-negatives, carbapenem resistance was detected in ≤ 3% in Escherichia coli, 12.5% in Klebsiella sp. and Enterobacter sp., and up to 40% in Pseudomonas aeruginosa; in the latter, the resistance rate for piperacillin-tazobactam (TZP) was as high as 19.1%. In Acinetobacter sp., resistance rates for cefepime, ciprofloxacin, meropenem, and TZP were higher than 50%. Regarding Gram-positives, methicillin resistance in Staphylococcus aureus (MRSA) was as high as 21.4%, and vancomycin (VAN) resistance reached up to 21% in Enterococcus faecium. Acinetobacter sp. presented the highest multidrug resistance (53%) followed by Klebsiella sp. (22.6%) and E. coli (19.4%). CONCLUSION:The multidrug resistance of Acinetobacter sp., Klebsiella sp. and E. coli and the carbapenem resistance in specific groups of enterobacteria deserve special attention in Mexico. Vancomycin-resistant enterococci (VRE) and MRSA are common in our hospitals. Our results present valuable information for the implementation of measures to control drug resistance

Drug resistance phenotypes and genotypes in Mexico in representative gram-negative species: Results from the infivar network.

AimThis report presents phenotypic and genetic data on the prevalence and characteristics of extended-spectrum β-lactamases (ESBLs) and representative carbapenemases-producing Gram-negative species in Mexico.Material and methodsA total of 52 centers participated, 43 hospital-based laboratories and 9 external laboratories. The distribution of antimicrobial resistance data for Escherichia coli, Klebsiella pneumoniae, Enterobacter cloacae complex, Acinetobacter baumannii complex, and Pseudomonas aeruginosa in selected clinical specimens from January 1 to March 31, 2020 was analyzed using the WHONET 5.6 platform. The following clinical isolates recovered from selected specimens were included: carbapenem-resistant Enterobacteriaceae, ESBL or carbapenem-resistant E. coli, and K. pneumoniae, carbapenem-resistant A. baumannii complex, and P. aeruginosa. Strains were genotyped to detect ESBL and/or carbapenemase-encoding genes.ResultsAmong blood isolates, A. baumannii complex showed more than 68% resistance for all antibiotics tested, and among Enterobacteria, E. cloacae complex showed higher resistance to carbapenems. A. baumannii complex showed a higher resistance pattern for respiratory specimens, with only amikacin having a resistance lower than 70%. Among K. pneumoniae isolates, blaTEM, blaSHV, and blaCTX were detected in 68.79%, 72.3%, and 91.9% of isolates, respectively. Among E. coli isolates, blaTEM, blaSHV, and blaCTX were detected in 20.8%, 4.53%, and 85.7% isolates, respectively. For both species, the most frequent genotype was blaCTX-M-15. Among Enterobacteriaceae, the most frequently detected carbapenemase-encoding gene was blaNDM-1 (81.5%), followed by blaOXA-232 (14.8%) and blaoxa-181(7.4%), in A. baumannii was blaOXA-24 (76%) and in P. aeruginosa, was blaIMP (25.3%), followed by blaGES and blaVIM (13.1% each).ConclusionOur study reports that NDM-1 is the most frequent carbapenemase-encoding gene in Mexico in Enterobacteriaceae with the circulation of the oxacillinase genes 181 and 232. KPC, in contrast to other countries in Latin America and the USA, is a rare occurrence. Additionally, a high circulation of ESBL blaCTX-M-15 exists in both E. coli and K. pneumoniae