Betavoltaics using scandium tritide and contact potential difference

Tritium-powered betavoltaic micropower sources using contact potential difference (CPD) are demonstrated. Thermally stable scandium tritide thin films with a surface activity of 15 mCi cm2 were used as the beta particle source. The electrical field created by the work function difference between the ScT film and a platinum or copper electrode was used to separate the beta-generated electrical charge carriers. Open circuit voltages of 0.5 and 0.16 V and short circuit current densities of 2.7 and 5.3 nA cm2 were achieved for gaseous and solid dielectric media-based CPD cells, respectively. © 2008 American Institute of Physics

Self-irradiation enhanced tritium solubility in hydrogenated amorphous and crystalline silicon

Experimental results on tritium effusion, along with the tritium depth profiles, from hydrogenated amorphous silicon (a-Si:H) and crystalline silicon (c-Si) tritiated in tritium (T2) gas at various temperatures and pressures are presented. The results indicate that tritium incorporation is a function of the material microstructure of the as-grown films, rather than the tritium exposure condition. The highest tritium concentration obtained is for a-Si:H deposited at a substrate temperature of 200°C. The tritium content is about 20 at. % on average with a penetration depth of about 50 nm. In contrast, tritium occluded in the c-Si is about 4 at. % with penetration depth of about 10 nm. The tritium concentration observed in a-Si:H and c-Si is much higher than the reported results for the post-hydrogenation process. β irradiation appears to catalyze the tritiation process and enhance tritium dissolution in the silicon matrix. The combination of tritium decay and β-induced ionizations results in formation of reactive species of tritium (tritium atoms, radicals, and ions) that readily adsorb on silicon. The electron bombardment of the silicon surface and subsurface renders it chemically active thereby promoting surface adsorption and subsurface diffusion of tritium, thus leading to tritium occlusion in the silicon matrix. Gaussian deconvolution of tritium effusion spectra yields two peaks for a-Si:H films tritiated at high temperature (250°C), one low temperature (LT) peak which is attributed to tritiated clusters and higher order tritides, and another high temperature peak which is attributed to monotritides. Activation energy of 2.6-4.0 eV for the LT peak was found. © 2011 American Institute of Physics

Comparison of embedded and added motor imagery training in patients after stroke: Results of a randomised controlled pilot trial

Copyright @ 2012 Schuster et al; licensee BioMed Central Ltd. This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.Background: Motor imagery (MI) when combined with physiotherapy can offer functional benefits after stroke. Two MI integration strategies exist: added and embedded MI. Both approaches were compared when learning a complex motor task (MT): ‘Going down, laying on the floor, and getting up again’. Methods: Outpatients after first stroke participated in a single-blinded, randomised controlled trial with MI embedded into physiotherapy (EG1), MI added to physiotherapy (EG2), and a control group (CG). All groups participated in six physiotherapy sessions. Primary study outcome was time (sec) to perform the motor task at pre and post-intervention. Secondary outcomes: level of help needed, stages of MT-completion, independence, balance, fear of falling (FOF), MI ability. Data were collected four times: twice during one week baseline phase (BL, T0), following the two week intervention (T1), after a two week follow-up (FU). Analysis of variance was performed. Results: Thirty nine outpatients were included (12 females, age: 63.4 ± 10 years; time since stroke: 3.5 ± 2 years; 29 with an ischemic event). All were able to complete the motor task using the standardised 7-step procedure and reduced FOF at T0, T1, and FU. Times to perform the MT at baseline were 44.2 ± 22s, 64.6 ± 50s, and 118.3 ± 93s for EG1 (N = 13), EG2 (N = 12), and CG (N = 14). All groups showed significant improvement in time to complete the MT (p < 0.001) and degree of help needed to perform the task: minimal assistance to supervision (CG) and independent performance (EG1+2). No between group differences were found. Only EG1 demonstrated changes in MI ability over time with the visual indicator increasing from T0 to T1 and decreasing from T1 to FU. The kinaesthetic indicator increased from T1 to FU. Patients indicated to value the MI training and continued using MI for other difficult-to-perform tasks. Conclusions: Embedded or added MI training combined with physiotherapy seem to be feasible and benefi-cial to learn the MT with emphasis on getting up independently. Based on their baseline level CG had the highest potential to improve outcomes. A patient study with 35 patients per group could give a conclusive answer of a superior MI integration strategy.The research project was partially funded by the Gottfried und Julia Bangerter-Rhyner Foundation

A motor imagery based brain-computer interface system via swarm-optimized fuzzy integral and its application

© 2016 IEEE. A brain-computer interface (BCI) system provides a convenient means of communication between the human brain and a computer, which is applied not only to healthy people but also for people that suffer from motor neuron diseases (MNDs). Motor imagery (MI) is one well-known basis for designing Electroencephalography (EEG)-based real-life BCI systems. However, EEG signals are often contaminated with severe noise and various uncertainties, imprecise and incomplete information streams. Therefore, this study proposes spectrum ensemble based on swam-optimized fuzzy integral for integrating decisions from sub-band classifiers that are established by a sub-band common spatial pattern (SBCSP) method. Firstly, the SBCSP effectively extracts features from EEG signals, and thereby the multiple linear discriminant analysis (MLDA) is employed during a MI classification task. Subsequently, particle swarm optimization (PSO) is used to regulate the subject-specific parameters for assigning optimal confidence levels for classifiers used in the fuzzy integral during the fuzzy fusion stage of the proposed system. Moreover, BCI systems usually tend to have complex architectures, be bulky in size, and require time-consuming processing. To overcome this drawback, a wireless and wearable EEG measurement system is investigated in this study. Finally, in our experimental result, the proposed system is found to produce significant improvement in terms of the receiver operating characteristic (ROC) curve. Furthermore, we demonstrate that a robotic arm can be reliably controlled using the proposed BCI system. This paper presents novel insights regarding the possibility of using the proposed MI-based BCI system in real-life applications

Observation of An Evolving Magnetic Flux Rope Prior To and During A Solar Eruption

Explosive energy release is a common phenomenon occurring in magnetized plasma systems ranging from laboratories, Earth's magnetosphere, the solar corona and astrophysical environments. Its physical explanation is usually attributed to magnetic reconnection in a thin current sheet. Here we report the important role of magnetic flux rope structure, a volumetric current channel, in producing explosive events. The flux rope is observed as a hot channel prior to and during a solar eruption from the Atmospheric Imaging Assembly (AIA) telescope on board the Solar Dynamic Observatory (SDO). It initially appears as a twisted and writhed sigmoidal structure with a temperature as high as 10 MK and then transforms toward a semi-circular shape during a slow rise phase, which is followed by fast acceleration and onset of a flare. The observations suggest that the instability of the magnetic flux rope trigger the eruption, thus making a major addition to the traditional magnetic-reconnection paradigm.Comment: 13 pages, 3 figure

Tuberculosis incidence correlates with sunshine : an ecological 28-year time series study

Birmingham is the largest UK city after London, and central Birmingham has an annual tuberculosis incidence of 80 per 100,000. We examined seasonality and sunlight as drivers of tuberculosis incidence. Hours of sunshine are seasonal, sunshine exposure is necessary for the production of vitamin D by the body and vitamin D plays a role in the host response to tuberculosis. Methods: We performed an ecological study that examined tuberculosis incidence in Birmingham from Dec 1981 to Nov 2009, using publicly-available data from statutory tuberculosis notifications, and related this to the seasons and hours of sunshine (UK Meteorological Office data) using unmeasured component models. Results: There were 9,739 tuberculosis cases over the study period. There was strong evidence for seasonality, with notifications being 24.1% higher in summer than winter (p<0.001). Winter dips in sunshine correlated with peaks in tuberculosis incidence six months later (4.7% increase in incidence for each 100 hours decrease in sunshine, p<0.001). Discussion and Conclusion: A potential mechanism for these associations includes decreased vitamin D levels with consequent impaired host defence arising from reduced sunshine exposure in winter. This is the longest time series of any published study and our use of statutory notifications means this data is essentially complete. We cannot, however, exclude the possibility that another factor closely correlated with the seasons, other than sunshine, is responsible. Furthermore, exposure to sunlight depends not only on total hours of sunshine but also on multiple individual factors. Our results should therefore be considered hypothesis-generating. Confirmation of a potential causal relationship between winter vitamin D deficiency and summer peaks in tuberculosis incidence would require a randomized-controlled trial of the effect of vitamin D supplementation on future tuberculosis incidence

ISRM-Suggested Method for Determining the Mode I Static Fracture Toughness Using Semi-Circular Bend Specimen

The International Society for Rock Mechanics has so far developed two standard methods for the determination of static fracture toughness of rock. They used three different core based specimens and tests were to be performed on a typical laboratory compression or tension load frame. Another method to determine the mode I fracture toughness of rock using semicircular bend specimen is herein presented. The specimen is semicircular in shape and made from typical cores taken from the rock with any relative material directions noted. The specimens are tested in three-point bending using a laboratory compression test instrument. The failure load along with its dimensions is used to determine the fracture toughness. Most sedimentary rocks which are layered in structure may exhibit fracture properties that depend on the orientation and therefore measurements in more than one material direction may be necessary. The fracture toughness measurements are expected to yield a size-independent material property if certain minimum specimen size requirements are satisfied