1,122 research outputs found
Hydrostatic Compression Behavior and High-Pressure Stabilized β-Phase in γ-Based Titanium Aluminide Intermetallics
Titanium aluminides find application in modern light-weight, high-temperature turbines, such as aircraft engines, but suffer from poor plasticity during manufacturing and processing. Huge forging presses enable materials processing in the 10-GPa range, and hence, it is necessary to investigate the phase diagrams of candidate materials under these extreme conditions. Here, we report on an in situ synchrotron X-ray diffraction study in a large-volume press of a modern (α2 + γ) two-phase material, Ti-45Al-7.5Nb-0.25C, under pressures up to 9.6 GPa and temperatures up to 1686 K. At room temperature, the volume response to pressure is accommodated by the transformation γ → α2, rather than volumetric strain, expressed by the apparently high bulk moduli of both constituent phases. Crystallographic aspects, specifically lattice strain and atomic order, are discussed in detail. It is interesting to note that this transformation takes place despite an increase in atomic volume, which is due to the high ordering energy of γ. Upon heating under high pressure, both the eutectoid and γ-solvus transition temperatures are elevated, and a third, cubic β-phase is stabilized above 1350 K. Earlier research has shown that this β-phase is very ductile during plastic deformation, essential in near-conventional forging processes. Here, we were able to identify an ideal processing window for near-conventional forging, while the presence of the detrimental β-phase is not present under operating conditions. Novel processing routes can be defined from these findings. © 2016, Creative Commons
Evolution of composition and grain correlations upon phase transitions and micro-structural rearrangement processes followed in-situ by high energy x-ray diffraction.
Two-dimensional powder diffraction using high-energy synchrotron x-rays is a powerful tool for bulk studies of materials and a short introduction of its advantages is given here.Australian Ceramic Societ
Towards the thermodynamic equilibrium of titanium aluminides after consolidation by back pressure equal channel angular pressing.
Australian Research Counci
Search for a Technicolor omega_T Particle in Events with a Photon and a b-quark Jet at CDF
If the Technicolor omega_T particle exists, a likely decay mode is omega_T ->
gamma pi_T, followed by pi_T -> bb-bar, yielding the signature gamma bb-bar. We
have searched 85 pb^-1 of data collected by the CDF experiment at the Fermilab
Tevatron for events with a photon and two jets, where one of the jets must
contain a secondary vertex implying the presence of a b quark. We find no
excess of events above standard model expectations. We express the result of an
exclusion region in the M_omega_T - M_pi_T mass plane.Comment: 14 pages, 2 figures. Available from the CDF server (PS with figs):
http://www-cdf.fnal.gov/physics/pub98/cdf4674_omega_t_prl_4.ps
FERMILAB-PUB-98/321-
Measurement of the B0 anti-B0 oscillation frequency using l- D*+ pairs and lepton flavor tags
The oscillation frequency Delta-md of B0 anti-B0 mixing is measured using the
partially reconstructed semileptonic decay anti-B0 -> l- nubar D*+ X. The data
sample was collected with the CDF detector at the Fermilab Tevatron collider
during 1992 - 1995 by triggering on the existence of two lepton candidates in
an event, and corresponds to about 110 pb-1 of pbar p collisions at sqrt(s) =
1.8 TeV. We estimate the proper decay time of the anti-B0 meson from the
measured decay length and reconstructed momentum of the l- D*+ system. The
charge of the lepton in the final state identifies the flavor of the anti-B0
meson at its decay. The second lepton in the event is used to infer the flavor
of the anti-B0 meson at production. We measure the oscillation frequency to be
Delta-md = 0.516 +/- 0.099 +0.029 -0.035 ps-1, where the first uncertainty is
statistical and the second is systematic.Comment: 30 pages, 7 figures. Submitted to Physical Review
Search for New Particles Decaying to top-antitop in proton-antiproton collisions at squareroot(s)=1.8 TeV
We use 106 \ipb of data collected with the Collider Detector at Fermilab to
search for narrow-width, vector particles decaying to a top and an anti-top
quark. Model independent upper limits on the cross section for narrow, vector
resonances decaying to \ttbar are presented. At the 95% confidence level, we
exclude the existence of a leptophobic \zpr boson in a model of
topcolor-assisted technicolor with mass M_{\zpr} 480 \gev for natural
width = 0.012 M_{\zpr}, and M_{\zpr} 780 \gev for =
0.04 M_{\zpr}.Comment: The CDF Collaboration, submitted to PRL 25-Feb-200
Double Diffraction Dissociation at the Fermilab Tevatron Collider
We present results from a measurement of double diffraction dissociation in
collisions at the Fermilab Tevatron collider. The production cross
section for events with a central pseudorapidity gap of width
(overlapping ) is found to be [] at [630]
GeV. Our results are compared with previous measurements and with predictions
based on Regge theory and factorization.Comment: 10 pages, 4 figures, using RevTeX. Submitted to Physical Review
Letter
A Measurement of the Differential Dijet Mass Cross Section in p-pbar Collisions at sqrt{s}=1.8 TeV
We present a measurement of the cross section for production of two or more
jets as a function of dijet mass, based on an integrated luminosity of 86 pb^-1
collected with the Collider Detector at Fermilab. Our dijet mass spectrum is
described within errors by next-to-leading order QCD predictions using CTEQ4HJ
parton distributions, and is in good agreement with a similar measurement from
the D0 experiment.Comment: 18 pages including 2 figures and 3 tables. Submitted to Phys. Rev. D
Rapid Communication
Search for Gluinos and Scalar Quarks in Collisions at TeV using the Missing Energy plus Multijets Signature
We have performed a search for gluinos (\gls) and squarks (\sq) in a data
sample of 84 pb of \ppb collisions at = 1.8 TeV, recorded by
the Collider Detector at Fermilab, by investigating the final state of large
missing transverse energy and 3 or more jets, a characteristic signature in
R-parity-conserving supersymmetric models. The analysis has been performed
`blind', in that the inspection of the signal region is made only after the
predictions from Standard Model backgrounds have been calculated. Comparing the
data with predictions of constrained supersymmetric models, we exclude gluino
masses below 195 \gev (95% C.L.), independent of the squark mass. For the case
\msq \approx \mgls, gluino masses below 300 \gev are excluded.Comment: 7 pages, 3 figure
Diffractive Dijet Production at sqrt(s)=630 and 1800 GeV at the Fermilab Tevatron
We report a measurement of the diffractive structure function of
the antiproton obtained from a study of dijet events produced in association
with a leading antiproton in collisions at GeV at the
Fermilab Tevatron. The ratio of at GeV to
obtained from a similar measurement at GeV is compared with
expectations from QCD factorization and with theoretical predictions. We also
report a measurement of the (-Pomeron) and ( of parton in
Pomeron) dependence of at GeV. In the region
, GeV and , is
found to be of the form , which obeys
- factorization.Comment: LaTeX, 9 pages, Submitted to Phys. Rev. Letter
- …