161,656 research outputs found
X-Ray Spectral Variability in Cygnus X-1
Spectral variability in different energy bands of X-rays from Cyg X-1 in
different states is studied with RXTE observations and time domain approaches.
In the hard tail of energy spectrum above keV, average peak aligned
shots are softer than the average steady emission and the hardness ratio
decreases when the flux increases during a shot for all states. In regard to a
soft band lower keV, the hardness in the soft state varies in an
opposite way: it peaks when the flux of the shot peaks. For the hard and
transition states, the hardness ratio in respect to a soft band during a shot
is in general lower than that of the steady component and a sharp rise is
observed at about the shot peak. For the soft state, the correlation
coefficient between the intensity and hardness ratio in the hard tail is
negative and decreases monotonically as the timescale increases from 0.01 s to
50 s, which is opposite to that in regard to a soft band. For the hard and
transition states, the correlation coefficients are in general negative and
have a trend of decrease with increasing timescale.Comment: 14 pages, 3 figures, accepted by Ap
Covariant description of shape evolution and shape coexistence in neutron-rich nuclei at N\approx60
The shape evolution and shape coexistence phenomena in neutron-rich nuclei at
, including Kr, Sr, Zr, and Mo isotopes, are studied in the
covariant density functional theory (DFT) with the new parameter set PC-PK1.
Pairing correlations are treated using the BCS approximation with a separable
pairing force. Sharp rising in the charge radii of Sr and Zr isotopes at N=60
is observed and shown to be related to the rapid changing in nuclear shapes.
The shape evolution is moderate in neighboring Kr and Mo isotopes. Similar as
the results of previous Hartree-Fock-Bogogliubov (HFB) calculations with the
Gogny force, triaxiality is observed in Mo isotopes and shown to be essential
to reproduce quantitatively the corresponding charge radii. In addition, the
coexistence of prolate and oblate shapes is found in both Sr and
Zr. The observed oblate and prolate minima are related to the low
single-particle energy level density around the Fermi surfaces of neutron and
proton respectively. Furthermore, the 5-dimensional (5D) collective Hamiltonian
determined by the calculations of the PC-PK1 energy functional is solved for
Sr and Zr. The resultant excitation energy of state and
E0 transition strength are in rather good
agreement with the data. It is found that the lower barrier height separating
the two competing minima along the deformation in Zr gives
rise to the larger than that in Sr.Comment: 1 table, 11 figures, 23 page
Positivity-preserving H∞ model reduction for positive systems
This is the post-print version of the Article - Copyright @ 2011 ElevierThis paper is concerned with the model reduction of positive systems. For a given stable positive system, our attention is focused on the construction of a reduced-order model in such a way that the positivity of the original system is preserved and the error system is stable with a prescribed H∞ performance. Based upon a system augmentation approach, a novel characterization on the stability with H∞ performance of the error system is first obtained in terms of linear matrix inequality (LMI). Then, a necessary and sufficient condition for the existence of a desired reduced-order model is derived accordingly. Furthermore, iterative LMI approaches with primal and dual forms are developed to solve the positivity-preserving H∞ model reduction problem. Finally, a compartmental network is provided to show the effectiveness of the proposed techniques.The work was partially supported by GRF HKU 7137/09E
Anisotropy of the in-plane angular magnetoresistance of electron-doed Sr1-xLaxCuO2 thin films
Signatures of antiferromagnetism (AF) in the underdoped Ln2-xCexCuO4 (Ln =
Nd, Pr,...) family are observed even for doping levels for which
superconductivity exists. We have looked for a similar property in a different
electron-doped cuprate family, Sr1-xLaxCuO2, which consists of CuO2 planes
separated by Sr/La atoms, and is exempt of the possible influence of magnetic
rare earth ions. We report in-plane magnetoresistance measurements in the
normal state of underdoped, superconducting, c-axis oriented, epitaxial
Sr1-xLaxCuO2 thin films. This probe is sensitive to spin arrangement and we
find that the in-plane magnetoresistance, which is negative and does not
saturate for T, exhibits an angular dependence when measured upon rotating a
magnetic field within the CuO2 planes. The analysis reveals a superposition of
fourfold and twofold angular oscillations. Both of these increase in amplitude
with increasing field and decreasing and appear below a temperature, which gets
higher with decreasing doping levels. Our results demonstrate that these
magnetoresistance oscillations, also observed for the Ln2-xCexCuO4 (Ln = Nd,
Pr,...) family and attributed to an AF signature, are, without ambiguity, a
property of CuO2 planes. Besides, these oscillations vary with doping in an
unusual way compared to previous results: fourfold oscillations are essentially
present in the more underdoped samples while only twofold oscillations are
visible in the less underdoped ones. This intriguing observation appears to be
a consequence of spin dilution with increasing doping level.Comment: 25 pages, 6 figure
Evaluation of ASTER GDEM ver2 using GPS measurements and SRTM ver4.1 in China
The freely available ASTER GDEM ver2 was released by NASA and METI on October 17, 2011. As one of the most complete high resolution digital topographic data sets of the world to date, the ASTER GDEM covers land surfaces between 83°N and 83°S at a spatial resolution of 1 arc-second and will be a useful product for many applications, such as relief analysis, hydrological studies and radar interferometry. The stated improvements in the second version of ASTER GDEM benefit from finer horizontal resolution, offset adjustment and water body detection in addition to new observed ASTER scenes. This study investigates the absolute vertical accuracy of the ASTER GDEM ver2 at five study sites in China using ground control points (GCPs) from high accuracy GPS benchmarks, and also using a DEM-to-DEM comparison with the Consultative Group for International Agriculture Research Consortium for Spatial Information (CGIAR-CSI) SRTM DEM (Version 4.1). And then, the results are separated into GlobCover land cover classes to derive the spatial pattern of error. It is demonstrated that the RMSE (19m) and mean (-13m) values of ASTER GDEM ver2 against GPS-GCPs in the five study areas is lower than its first version ASTER GDEM ver1 (26m and -21m) as a result of the adjustment of the elevation offsets in the new version. It should be noted that the five study areas in this study are representative in terms of terrain types and land covers in China, and even for most of mid-latitude zones. It is believed that the ASTER GDEM offers a major alternative in accessibility to high quality elevation data
The IT performance evaluation in the construction industry
To date there has been limited published work in
the construction management and engineering
literature that has provided empirical evidence to
demonstrate that IT can improve organizational
performance. Without an explicit understanding
about how IT can be effectively used to improve
organizational performance, its justification will
remain to be weak for managers. To ensure the
continuous increase in IT based applications in the
construction industry, sufficient evidence has to be
provided for management in various professions of
the construction industry to evaluate, allocate and
utilize appropriate IT systems. In an attempt to
explore the relationship between IT and
productivity, an empirical investigation of 60
Professional Consulting Firms (PCF) from the
Hong Kong construction industry was undertaken.
A model for determining the organizational
productivity of IT is proposed, and the
methodology used to test the model is described.
The findings are analyzed and a cross-profession
comparison of the results indicated the differences
in the use of IT. The research findings are discussed
with similarities being drawn. The limitations of the
research are then presented and discussed. The
implications of the findings and conclusions then
fully presented
- …