Frequency-Selective PAPR Reduction for OFDM

We study the peak-to-average power ratio (PAPR) problem in orthogonal frequency-division multiplexing (OFDM) systems. In conventional clipping and filtering based PAPR reduction techniques, clipping noise is allowed to spread over the whole active passband, thus degrading the transmit signal quality similarly at all active subcarriers. However, since modern radio networks support frequency-multiplexing of users and services with highly different quality-of-service expectations, clipping noise from PAPR reduction should be distributed unequally over the corresponding physical resource blocks (PRBs). To facilitate this, we present an efficient PAPR reduction technique, where clipping noise can be flexibly controlled and filtered inside the transmitter passband, allowing to control the transmitted signal quality per PRB. Numerical results are provided in 5G New Radio (NR) mobile network context, demonstrating the flexibility and efficiency of the proposed method.Comment: Accepted for publication as a Correspondence in the IEEE Transactions on Vehicular Technology in March 2019. This is the revised version of original manuscript, and it is in press at the momen

Mobile Communications Beyond 52.6 GHz: Waveforms, Numerology, and Phase Noise Challenge

In this article, the first considerations for the 5G New Radio (NR) physical layer evolution to support beyond 52.6GHz communications are provided. In addition, the performance of both OFDM based and DFT-s-OFDM based networks are evaluated with special emphasis on the phase noise (PN) induced distortion. It is shown that DFT-s-OFDM is more robust against PN under 5G NR Release 15 assumptions, namely regarding the supported phase tracking reference signal (PTRS) designs, since it enables more effective PN mitigation directly in the time domain. To further improve the PN compensation capabilities, the PTRS design for DFT-s-OFDM is revised, while for the OFDM waveform a novel block PTRS structure is introduced, providing similar link performance as DFT-s-OFDM with enhanced PTRS design. We demonstrate that the existing 5G NR Release 15 solutions can be extended to support efficient mobile communications at 60GHz carrier frequency with the enhanced PTRS structures. In addition, DFT-s-OFDM based downlink for user data could be considered for beyond 52.6GHz communications to further improve system power efficiency and performance with higher order modulation and coding schemes. Finally, network link budget and cell size considerations are provided, showing that at certain bands with specific transmit power regulation, the cell size can eventually be downlink limited.Comment: This manuscript has been submitted to IEEE Wireless Communications Magazine (WCM). 8 pages, 4 figures, and 2 table

Generalized Fast-Convolution-based Filtered-OFDM: Techniques and Application to 5G New Radio

This paper proposes a generalized model and methods for fast-convolution (FC)-based waveform generation and processing with specific applications to fifth generation new radio (5G-NR). Following the progress of 5G-NR standardization in 3rd generation partnership project (3GPP), the main focus is on subband-filtered cyclic prefix (CP) orthogonal frequency-division multiplexing (OFDM) processing with specific emphasis on spectrally well localized transmitter processing. Subband filtering is able to suppress the interference leakage between adjacent subbands, thus supporting different numerologies for so-called bandwidth parts as well as asynchronous multiple access. The proposed generalized FC scheme effectively combines overlapped block processing with time- and frequency-domain windowing to provide highly selective subband filtering with very low intrinsic interference level. Jointly optimized multi-window designs with different allocation sizes and design parameters are compared in terms of interference levels and implementation complexity. The proposed methods are shown to clearly outperform the existing state-of-the-art windowing and filtering-based methods.Comment: To appear in IEEE Transactions on Signal Processin

Positioning of High-speed Trains using 5G New Radio Synchronization Signals

We study positioning of high-speed trains in 5G new radio (NR) networks by utilizing specific NR synchronization signals. The studies are based on simulations with 3GPP-specified radio channel models including path loss, shadowing and fast fading effects. The considered positioning approach exploits measurement of Time-Of-Arrival (TOA) and Angle-Of-Departure (AOD), which are estimated from beamformed NR synchronization signals. Based on the given measurements and the assumed train movement model, the train position is tracked by using an Extended Kalman Filter (EKF), which is able to handle the non-linear relationship between the TOA and AOD measurements, and the estimated train position parameters. It is shown that in the considered scenario the TOA measurements are able to achieve better accuracy compared to the AOD measurements. However, as shown by the results, the best tracking performance is achieved, when both of the measurements are considered. In this case, a very high, sub-meter, tracking accuracy can be achieved for most (>75%) of the tracking time, thus achieving the positioning accuracy requirements envisioned for the 5G NR. The pursued high-accuracy and high-availability positioning technology is considered to be in a key role in several envisioned HST use cases, such as mission-critical autonomous train systems.Comment: 6 pages, 5 figures, IEEE WCNC 2018 (Wireless Communications and Networking Conference

Efficient Fast-Convolution-Based Waveform Processing for 5G Physical Layer

This paper investigates the application of fast-convolution (FC) filtering schemes for flexible and effective waveform generation and processing in the fifth generation (5G) systems. FC-based filtering is presented as a generic multimode waveform processing engine while, following the progress of 5G new radio standardization in the Third-Generation Partnership Project, the main focus is on efficient generation and processing of subband-filtered cyclic prefix orthogonal frequency-division multiplexing (CP-OFDM) signals. First, a matrix model for analyzing FC filter processing responses is presented and used for designing optimized multiplexing of filtered groups of CP-OFDM physical resource blocks (PRBs) in a spectrally well-localized manner, i.e., with narrow guardbands. Subband filtering is able to suppress interference leakage between adjacent subbands, thus supporting independent waveform parametrization and different numerologies for different groups of PRBs, as well as asynchronous multiuser operation in uplink. These are central ingredients in the 5G waveform developments, particularly at sub-6-GHz bands. The FC filter optimization criterion is passband error vector magnitude minimization subject to a given subband band-limitation constraint. Optimized designs with different guardband widths, PRB group sizes, and essential design parameters are compared in terms of interference levels and implementation complexity. Finally, extensive coded 5G radio link simulation results are presented to compare the proposed approach with other subband-filtered CP-OFDM schemes and time-domain windowing methods, considering cases with different numerologies or asynchronous transmissions in adjacent subbands. Also the feasibility of using independent transmitter and receiver processing for CP-OFDM spectrum control is demonstrated

Superimposed training for single carrier transmission in future mobile communications

The amount of wireless devices and wireless traffic has been increasing exponentially for the last ten years. It is forecasted that the exponential growth will continue without saturation till 2020 and probably further. So far, network vendors and operators have tackled the problem by introducing new evolutions of cellular macro networks, where each evolution has increased the physical layer spectral efficiency. Unfortunately, the spectral efficiency of the physical layer is achieving the Shannon-Hartley limit and does not provide much room for improvement anymore. However, considering the overhead due to synchronization and channel estimation reference symbols in the context of physical layer spectral efficiency, we believe that there is room for improvement. In this thesis, we will study the potentiality of superimposed training methods, especially data-dependent superimposed training, to boost the spectral efficiency of wideband single carrier communications even further. The main idea is that with superimposed training we can transmit more data symbols in the same time duration as compared to traditional time domain multiplexed training. In theory, more data symbols means more data bits which indicates higher throughput for the end user. In practice, nothing is free. With superimposed training we encounter self-interference between the training signal and the data signal. Therefore, we have to look for iterative receiver structures to separate these two or to estimate both, the desired data signal and the interfering component. In this thesis, we initiate the studies to find out if we truly can improve the existing systems by introducing the superimposed training scheme. We show that in certain scenarios we can achieve higher spectral efficiency, which maps directly to higher user throughput, but with the cost of higher signal processing burden in the receiver. In addition, we provide analytical tools for estimating the symbol or bit error ratio in the receiver with a given parametrization. The discussion leads us to the conclusion that there still remains several open topics for further study when looking for new ways of optimizing the overhead of reference symbols in wireless communications. Superimposed training with data-dependent components may prove to provide extra throughput gain. Furthermore, the superimposed component may be used for, e.g., improved synchronization, low bit-rate signaling or continuous tracking of neighbor cells. We believe that the current systems could be improved by using the superimposed training collectively with time domain multiplexed training

5G New Radio Evolution Towards Sub-THz Communications

In this paper, the potential of extending 5G New Radio physical layer solutions to support communications in sub-THz frequencies is studied. More specifically, we introduce the status of third generation partnership project studies related to operation on frequencies beyond 52.6 GHz and note also the recent proposal on spectrum horizons provided by federal communications commission (FCC) related to experimental licenses on 95 GHz - 3 THz frequency band. Then, we review the power amplifier (PA) efficiency and output power challenge together with the increased phase noise (PN) distortion effect in terms of the supported waveforms. As a practical example on the waveform and numerology design from the perspective of the PN robustness, link performance results using 90 GHz carrier frequency are provided. The numerical results demonstrate that new, higher subcarrier spacings are required to support high throughput, which requires larger changes in the physical layer design. It is also observed that new phase-tracking reference signal designs are required to make the system robust against PN. The results illustrate that single-carrier frequency division multiple access is significantly more robust against PN and can provide clearly larger PA output power than cyclic-prefix orthogonal frequency division multiplexing, and is therefore a highly potential waveform for sub-THz communications.Comment: This manuscript has been accepted for publication to IEEE 6G Wireless Summit 2020, 6 pages, 4 figure

Developing an Auditory and Visual Cross-Modal Continuous Performance Task for Evaluating Concussion

Neurocognitive tests like the SCAT3 and ImPACT have become standard concussion assessment tools. Although these tests have adequate sensitivity, specificity, and reliability, they are unimodal in nature. Consequently, the tests do not fully assess the range of processing that can be affected by concussion (Thompson, 2012). Therefore, we developed a cross-modal continuous performance task to examine cognitive processing post-concussion. Forty-three middle school school lacrosse players, college students, and physical therapy graduate students participated in the study. Twelve of these participants had been previously diagnosed with a concussion. Participants completed a symptom checklist from SCAT3 along with other demographic information (e.g., previously concussed, last concussion). They then completed the continuous performance task starting with visual detection followed by visual inhibition, auditory detection, and auditory inhibition. Older subjects were more accurate than younger subjects on the detection task (F(1, 84) = 20.61, p \u3c .001). Subjects were also more accurate on the visual task than the auditory task (F(1, 84) = 21.47, p \u3c .001). Both age (F(1, 84) = 5.65, p \u3c .02) and previous concussion (F(1, 84) = 4.49, p \u3c .04) interacted with test modality. College and graduate students who had previously been concussed performed the same as those who had not been concussed. However, middle schoolers who had been concussed did significantly worse on the auditory task than those who had not been concussed. Similarly, older subjects were more accurate than younger subjects on the inhibition task (F(1, 84) = 4.91, p \u3c .03). Older subjects were also significantly more accurate on the visual task than the middle schoolers (F(1, 84) = 5.33, p \u3c .03; Figure 2). However, no differences were found based on previous concussion

Frequency-Domain Signal Processing for Spectrally-Enhanced CP-OFDM Waveforms in 5G New Radio

Orthogonal frequency-division multiplexing (OFDM) has been selected as the basis for the fifth-generation new radio (5G-NR) waveform developments. However, effective signal processing tools are needed for enhancing the OFDM spectrum in various advanced transmission scenarios. In earlier work, we have shown that fast-convolution (FC) processing is a very flexible and efficient tool for filtered-OFDM signal generation and receiver-side subband filtering, e.g., for the mixed-numerology scenarios of the 5G-NR. FC filtering approximates linear convolution through effective fast Fourier transform (FFT)-based circular convolutions using partly overlapping processing blocks. However, with the continuous overlap-and-save and overlap-and-add processing models with fixed block-size and fixed overlap, the FC-processing blocks cannot be aligned with all OFDM symbols of a transmission frame. Furthermore, 5G-NR numerology does not allow to use transform lengths shorter than 128 because this would lead to non-integer cyclic prefix (CP) lengths. In this article, we present new FC-processing schemes which solve the mentioned limitations. These schemes are based on dynamically adjusting the overlap periods and extrapolating the CP samples, which make it possible to align the FC blocks with each OFDM symbol, even in case of variable CP lengths. This reduces complexity and latency, e.g., in mini-slot transmissions and, as an example, allows to use 16-point transforms in case of a 12-subcarrier-wide subband allocation, greatly reducing the implementation complexity. On the receiver side, the proposed scheme makes it possible to effectively combine cascaded inverse and forward FFT units in FC-filtered OFDM processing. Transform decomposition is used to simplify these computations. Very extensive set of numerical results is also provided, in terms of radio-link performance and associated processing complexity.Comment: This work has been submitted to the IEEE Transactions on Wireless Communications for possible publication. Copyright may be transferred without notice, after which this version may no longer be accessibl