9 research outputs found
Moho depth across the Trans-European Suture Zone from P-and S-receiver functions
The Mohorovicic discontinuity, Moho for short, which marks the boundary between crust and mantle, is the main first-order structure within the lithosphere. Geodynamics and tectonic evolution determine its depth level and properties. Here, we present a map of the Moho in central Europe across the Teisseyre-Tornquist Zone, a region for which a number of previous studies are available. Our results are based on homogeneous and consistent processing of P- and S-receiver functions for the largest passive seismological data set in this region yet, consisting of more than 40 000 receiver functions from almost 500 station. Besides, we also provide new results for the crustal Vp/Vs ratio for the whole area. Our results are in good agreement with previous, more localized receiver function studies, as well as with the interpretation of seismic profiles, while at the same time resolving a higher level of detail than previous maps covering the area, for example regarding the Eifel Plume region, Rhine Graben and northern Alps. The close correspondence with the seismic data regarding crustal structure also increases confidence in use of the data in crustal corrections and the imaging of deeper structure, for which no independent seismic information is available. In addition to the pronounced, stepwise transition from crustal thicknesses of 30km in Phanerozoic Europe to more than 45 beneath the East European Craton, we can distinguish other terrane boundaries based on Moho depth as well as average crustal Vp/Vsratio and Moho phase amplitudes. The terranes with distinct crustal properties span a wide range of ages, from Palaeoproterozoic in Lithuania to Cenozoic in the Alps, reflecting the complex tectonic history of Europe. Crustal thickness and properties in the study area are also markedly influenced by tectonic overprinting, for example the formation of the Central European Basin System, and the European Cenozoic Rift System. In the areas affected by Cenozoic rifting and volcanism, thinning of the crust corresponds to lithospheric updoming reported in recent surface wave and S-receiver function studies, as expected for thermally induced deformation. The same correlation applies for crustal thickening, not only across the Trans-European Suture Zone, but also within the southern part of the Bohemian Massif. A high Poisson’s ratio of 0.27 is obtained for the craton, which is consistent with a thick mafic lower crust. In contrast, we typically find Poisson’s ratios around 0.25 for Phanerozoic Europe outside of deep sedimentary basins. Mapping of the thickness of the shallowest crustal layer, that is low-velocity sediments or weathered rock, indicates values in excess of 6km for the most pronounced basins in the study area, while thicknesses of less than 4km are found within the craton, central Germany and most of the Czech Republic.Peer reviewe
Late Vendian-Early Palaeozoic tectonic evolution of the Baltic Basin: regional tectonic implications from subsidence analysis.
Subsidence analysis was performed on 43 boreholes penetrating the Upper Vendian-Lower Palaeozoic sedimentary succession of the Baltic Basin. The results were related to lithofacial and structural data to elucidate subsidence mechanisms and the regional tectonic setting of basin development. Tectonic subsidence patterns are consistent throughout the basin for the time period studied. An extensional tectonic subsidence event, possibly of two phases, is indicated from the Late Vendian to the beginning of the Middle Cambrian. This event is seen in the southwestern part of the Baltic Basin (Peri-Tornquist zone) until the earliest Cambrian after which it is also observed in the SW-NE-trending Baltic Depression part of the basin. Basin development during this time is interpreted as recording the latest stages of break-up of the Precambrian super-continent Rodinia and ultimately the formation of the Tornquist Sea. The late Middle Cambrian to Middle Ordovician tectonic subsidence pattern of the Baltic Basin is characteristic of post-rift thermal subsidence of the newly formed passive continental margin of Baltica, developed along its southwestern edge. A gradual increase in subsidence rate is observed from the (Middle?) Late Ordovician and throughout the Silurian (particularly for Ludlow and Pridoli times) creating subsidence curves with convex shapes typical of foreland basin development. The rate of Late Silurian tectonic subsidence increases significantly towards the southwest margin of the Baltic basin, adjacent to the present location of the North German-Polish Caledonides. The Baltic Basin therefore appears to have developed primarily as a flexural foreland basin during Silurian oblique collision of Baltica and Eastern Avalonia. A foreland setting is supported by the influx of distal turbidites into the basin from southwest sources in the Late Silurian. Compressional deformation structures of Early Devonian (Lochkovian) age are seen in seismic sections in the central part of the Baltic Basin (Lithuania). These, together with a change in subsidence pattern, mark the end of the Caledonian stage of basin development of the Baltic Basin. (C) 1999 Elsevier Science B.V. All rights reserved
The Vendian-Early Palaeozoic sedimentary basins of the East European Craton
Vendian-Early Palaeozoic sedimentation on the East European Craton (EEC) was confined to the cratonic margins with limited intracratonic subsidence. Generally, there are two geodynamic stages involved: in stage 1, basins formed in response to continental break-up processes; in stage 2, basins formed in response to the reassembly of continental lithosphere fragments and associated continental accretionary processes. The establishment of the Peri-Tornquist passive margin was a polyphase process that commenced in the Early Vendian in the SW and ended in the Cambrian in the NW. Neoproterozoic rifting along the Scandinavian margin was essentially a long process (250 Ma), whereas the fragmentation of the continent along the earlier Timanian orogen in the east and establishment of Peri-Uralian basins took place in a rather short time span. A similar scenario is suggested for the basement of the Peri-Caspian Basin. The rift-to-drift transition is expressed differently on the various EEC margins and this could be a reflection of the relative strengths of the underlying lithosphere. The change to a convergent margin setting is recorded in Peri-Tornquist basins in the Late Ordovician, climaxing with high rates of subsidence during Late Silurian time. Subsidence rates on the cratonic margins were governed by the emplacement of orogenic loads. Where there was a short time span between Stages 1 and 2, continuing thermal subsidence from the former was superimposed onto the flexural subsidence of the latter, such as on the Dnestr margin. Other processes, such as dynamic loading related to mantle flow, are implied for the anomalously broad Stage 2 Baltic Basin. Peri-Uralian basins developed as passive continental margin basins throughout the Early Palaeozoic. Stress regime changes generated at the craton margins are reflected in the structure and subsidence patterns recorded in the intracratonic Moscow Basin. © The Geological Society of London 2006
New IGCP Project 499: "Devonian land-sea interaction: evolution of ecosystems and climate" (DEVEC)
, Flexural model of the Silurian Baltic Basin on the western marginof the East European Craton.
Phase velocities of Rayleigh and Love waves in central and northern Europe from automated, broad-band, interstation measurements
The increasingly dense coverage of Europe with broad-band seismic stations makes it possible to image its lithospheric structure in great detail, provided that structural information can be extracted effectively from the very large volumes of data. We develop an automated technique for the measurement of interstation phase velocities of (earthquake-excited) fundamental-mode surface waves in very broad period ranges. We then apply the technique to all available broad-band data from permanent and temporary networks across Europe. In a new implementation of the classical two-station method, Rayleigh and Love dispersion curves are determined by cross-correlation of seismograms from a pair of stations. An elaborate filtering and windowing scheme is employed to enhance the target signal and makes possible a significantly broader frequency band of the measurements, compared to previous implementations of the method. The selection of acceptable phase-velocity measurements for each event is performed in the frequency domain, based on a number of fine-tuned quality criteria including a smoothness requirement. Between 5 and 3000 single-event dispersion measurements are averaged per interstation path in order to obtain robust, broad-band dispersion curves with error estimates. In total, around 63,000 Rayleigh- and 27,500 Love-wave dispersion curves between 10 and 350 s have been determined, with standard deviations lower than 2 per cent and standard errors lower than 0.5 per cent. Comparisons of phase-velocity measurements using events at opposite backazimuths and the examination of the variance of the phase-velocity curves are parts of the quality control. With the automated procedure, large data sets can be consistently and repeatedly measured using varying selection parameters. Comparison of average interstation dispersion curves obtained with different degrees of smoothness shows that rough perturbations do not systematically bias the average dispersion measurement. They can, therefore, be treated as random but they do need to be removed in order to reduce random errors of the measurements. Using our large new data set, we construct phase-velocity maps for central and northern Europe. According to checkerboard tests, the lateral resolution in central Europe is ≤150 km. Comparison of regional surface-wave tomography with independent data on sediment thickness in North-German Basin and Polish Trough confirms the high-resolution potential of our phase-velocity measurements. At longer periods, the structure of the lithosphere and asthenosphere around the Trans-European Suture Zone (TESZ) is seen clearly. The region of the Tornquist-Teisseyre-Zone in the southeast is associated with a stronger lateral contrast in lithospheric thickness, across the TESZ compared to the region across the Sorgenfrei-Tornquist-Zone in the northwest