12,441 research outputs found
Entanglement of remote atomic qubits
We report observations of entanglement of two remote atomic qubits, achieved
by generating an entangled state of an atomic qubit and a single photon at Site
A, transmitting the photon to Site B in an adjacent laboratory through an
optical fiber, and converting the photon into an atomic qubit. Entanglement of
the two remote atomic qubits is inferred by performing, locally, quantum state
transfer of each of the atomic qubits onto a photonic qubit and subsequent
measurement of polarization correlations in violation of the Bell inequality
|S| <2. We experimentally determine S =2.16 +/- 0.03. Entanglement of two
remote atomic qubits, each qubit consisting of two independent spin wave
excitations, and reversible, coherent transfer of entanglement between matter
and light, represent important advances in quantum information science.Comment: 5 pages, 3 figure
Quantum interference of electromagnetic fields from remote quantum memories
We observe quantum, Hong-Ou-Mandel, interference of fields produced by two
remote atomic memories. High-visibility interference is obtained by utilizing
the finite atomic memory time in four-photon delayed coincidence measurements.
Interference of fields from remote atomic memories is a crucial element in
protocols for scalable generation of multi-node remote qubit entanglement.Comment: 4 pages, 3 figure
A comparison of ground-based and space flight data: Atomic oxygen reactions with boron nitride and silicon nitride
The effects of atomic oxygen on boron nitride (BN) and silicon nitride (Si3N4) have been studied in low Earth orbit (LEO) flight experiments and in a ground-based simulation facility at Los Alamos National Laboratory. Both the in-flight and ground-based experiments employed the materials coated over thin (approx 250 Angstrom) silver films whose electrical resistance was measured in situ to detect penetration of atomic oxygen through the BN and Si3N4 materials. In the presence of atomic oxygen, silver oxidizes to form silver oxide, which has a much higher electrical resistance than pure silver. Permeation of atomic oxygen through BN, as indicated by an increase in the electrical resistance of the silver underneath, was observed in both the in-flight and ground-based experiments. In contrast, no permeation of atomic oxygen through Si3N4 was observed in either the in-flight or ground-based experiments. The ground-based results show good qualitative correlation with the LEO flight results, thus validating the simulation fidelity of the ground-based facility in terms of reproducing LEO flight results
Chemistry of fuel deposits and sediments and their predursors
The mechanism of solid deposit formation on hot engine parts from turbine fuels is investigated. Deposit formation is associated with oxidation of the hydrocarbon fuel. Therefore, oxidation rates and soluble gum formation were measured for several jet turbine fuels and pure hydrocarbon mixtures. Experiments were performed at 130 C using thermal initiation and at 100 C using ditertiary butyl peroxide as a chemical initiator. Correlation of the data shows that the ratio of rate of oxidation to rate of gum formation for a single fuel is not much affected by experimental conditions, even though there are differences in the abilities of different hydrocarbons to initiate and continue the oxidation. This indicates a close association of gum formation with the oxidation process. Oxidations of n-dodecane, tetralin and the more unstable jet fuels are autocatalytic, while those of 2-ethylnaphthalene and a stable jet fuel are self-retarding. However, the ratio of oxidation rate to gum formation rate appear to be nearly constant for each substrate. The effect of oxygen pressure on gum and oxidation formation was also studied. Dependence of gum formation on the concentration of initiator at 100 C is discussed and problems for future study are suggested
Oxidation and formation of deposit precursors in hydrocarbon fuels
The oxidation of two jet turbine fuels and some pure hydrocarbons was studied at 130 C with and without the presence of small amounts of N-methyl pyrrole (NMP) or indene. Tendency to form solid-deposit precursors was studied by measuring soluble gum formation as well as dimer and trimer formation using field ionization mass spectrometry. Pure n-dodecane oxidized fastest and gave the smallest amount of procursors. An unstable fuel oil oxidized much slower but formed large amounts of precursors. Stable Jet A fuel oxidized slowest and gave little precursors. Indene either retarded or accelerated the oxidation of n-dodecane, depending on its concentration, but always caused more gum formation. The NMP greatly retarded n-dodecane oxidation but accelerated Jet A oxidation and greatly increased the latter's gum formation. In general, the additive reacted faster and formed most of the gum. Results are interpreted in terms of classical cooxidation theory. The effect of oxygen pressure on gum formation is also reported
HID-1 controls formation of large dense core vesicles by influencing cargo sorting and trans-Golgi network acidification
Large dense core vesicles (LDCVs) mediate the regulated release of neuropeptides and peptide hormones. They form at the trans-Golgi network (TGN), where their soluble content aggregates to form a dense core, but the mechanisms controlling biogenesis are still not completely understood. Recent studies have implicated the peripheral membrane protein HID-1 in neuropeptide sorting and insulin secretion. Using CRISPR/Cas9, we generated HID-1 KO rat neuroendocrine cells, and we show that the absence of HID-1 results in specific defects in peptide hormone and monoamine storage and regulated secretion. Loss of HID-1 causes a reduction in the number of LDCVs and affects their morphology and biochemical properties, due to impaired cargo sorting and dense core formation. HID-1 KO cells also exhibit defects in TGN acidification together with mislocalization of the Golgi-enriched vacuolar H+-ATPase subunit isoform a2. We propose that HID-1 influences early steps in LDCV formation by controlling dense core formation at the TGN.</jats:p
Functional cartography of complex metabolic networks
High-throughput techniques are leading to an explosive growth in the size of
biological databases and creating the opportunity to revolutionize our
understanding of life and disease. Interpretation of these data remains,
however, a major scientific challenge. Here, we propose a methodology that
enables us to extract and display information contained in complex networks.
Specifically, we demonstrate that one can (i) find functional modules in
complex networks, and (ii) classify nodes into universal roles according to
their pattern of intra- and inter-module connections. The method thus yields a
``cartographic representation'' of complex networks. Metabolic networks are
among the most challenging biological networks and, arguably, the ones with
more potential for immediate applicability. We use our method to analyze the
metabolic networks of twelve organisms from three different super-kingdoms. We
find that, typically, 80% of the nodes are only connected to other nodes within
their respective modules, and that nodes with different roles are affected by
different evolutionary constraints and pressures. Remarkably, we find that
low-degree metabolites that connect different modules are more conserved than
hubs whose links are mostly within a single module.Comment: 17 pages, 4 figures. Go to http://amaral.northwestern.edu for the PDF
file of the reprin
- …