A Cadaveric Pilot Study

This study investigates the adhesion capacity of a polyglycolic acid- (PGA-) hyaluronan scaffold with a structural modification based on a planar polymer (PM) surface in a cadaver cartilage defect model. Two cadaver specimens were used to serially test multiple chondral matrices. In a cadaver hip model, cell free polymer-based cartilage implants with a planar bioinspired PM surface (PGA-PM-scaffolds) were implanted arthroscopically on 10 mm × 15 mm full- thickness femoral hip cartilage lesions. Unprocessed cartilage implants without a bioinspired PM surface were used as control group. The cartilage implants were fixed without and with the use of fibrin glue on femoral hip cartilage defects. After 50 movement cycles and removal of the distraction, a rearthroscopy was performed to assess the outline attachment and integrity of the scaffold. The fixation techniques without and with fibrin fixation showed marginal differences for outline attachment, area coverage, scaffold integrity, and endpoint fixation after 50 cycles. The PGA-PM-scaffolds with fibrin fixation achieved a higher score in terms of the attachment, integrity, and endpoint fixation than the PGA-scaffold on the cartilage defect. Relating to the outline attachment, area coverage, scaffold integrity, and endpoint fixation, the fixation with PGA-PM-scaffolds accomplished significantly better results compared to the PGA-scaffolds . PGA-PM-scaffolds demonstrate increased observed initial fixation strength in cadaver femoral head defects relative to PGA-scaffold, particularly when fibrin glue is used for fixation

Arthroscopic Fixation of Cell Free Polymer-Based Cartilage Implants with a Bioinspired Polymer Surface on the Hip Joint: A Cadaveric Pilot Study

This study investigates the adhesion capacity of a polyglycolic acid-(PGA-) hyaluronan scaffold with a structural modification based on a planar polymer (PM) surface in a cadaver cartilage defect model. Two cadaver specimens were used to serially test multiple chondral matrices. In a cadaver hip model, cell free polymer-based cartilage implants with a planar bioinspired PM surface (PGA-PM-scaffolds) were implanted arthroscopically on 10 mm x 15 mm full-thickness femoral hip cartilage lesions. Unprocessed cartilage implants without a bioinspired PM surface were used as control group. The cartilage implants were fixed without and with the use of fibrin glue on femoral hip cartilage defects. After 50 movement cycles and removal of the distraction, a rearthroscopy was performed to assess the outline attachment and integrity of the scaffold. The fixation techniques without and with fibrin fixation showed marginal differences for outline attachment, area coverage, scaffold integrity, and endpoint fixation after 50 cycles. The PGA-PM-scaffolds with fibrin fixation achieved a higher score in terms of the attachment, integrity, and endpoint fixation than the PGA-scaffold on the cartilage defect. Relating to the outline attachment, area coverage, scaffold integrity, and endpoint fixation, the fixation with PGA-PM-scaffolds accomplished significantly better results compared to the PGA-scaffolds (P = 0.03752, P = 0.03078, P = 0.00512, P = 0.00512). PGA-PM-scaffolds demonstrate increased observed initial fixation strength in cadaver femoral head defects relative to PGA-scaffold, particularly when fibrin glue is used for fixation

The influence of different footprint preparation techniques on tissue regeneration in rotator cuff repair in an animal model

Introduction: Rotator cuff tears are common diseases of the upper extremity. There are no recommendations to the surgeon on how to prepare the footprint to ensure optimal tendon-to-bone healing. However, biologic augmentation using stem cells and growth factors is considered to encourage the healing process of the tendon. The aim of the study was to investigate the biomechanical and histological outcome of different footprint preparations in rotator cuff repair. Material and methods: One hundred and eighty-nine Sprague-Dawley rats were randomly assigned to either spongialization, radiofrequency ablation or an untreated control group. Rats were killed after 1 or 7 weeks for histological evaluation or after 7 weeks for biomechanical testing. Results: Histological evaluation showed better tissue organization in the control and spongialization group compared to the radiofrequency ablation group. The highest collagen I to collagen III quotient was found in the control group, followed closely by the spongialization group. Measured quotients showed a decrease in the values after 1 week compared to the values after 7 weeks, except in the radiofrequency ablation group, where an increase was detected. A significant difference was found in the load to failure test comparing the radiofrequency ablation group to the spongialization group (p = 0.0409) and control group (p = 0.014), but not comparing the spongialization group to the control group (p = 0.2456). Conclusions: The results of this study suggest that spongialization of the footprint before attaching the torn supraspinatus tendon can lead to better structural properties and higher quality of tendon-to-bone restoration at the insertion area when compared with radiofrequency ablation

Does osteoporosis reduce the primary tilting stability of cementless acetabular cups?

Background: Cementless hip cups need sufficient primary tilting stability to achieve osseointegration. The aim of the study was to assess differences of the primary implant stability in osteoporotic bone and in bone with normal bone density. To assess the influence of different cup designs, two types of threaded and two types of press-fit cups were tested. Methods: The maximum tilting moment for two different cementless threaded cups and two different cementless press-fit cups was determined in macerated human hip acetabuli with reduced (n=20) and normal bone density (n=20),determined using Q-CT. The tilting moments for each cup were determined five times in the group with reduced bone density and five times in the group with normal bone density, and the respective average values were calculated. Results: The mean maximum extrusion force of the threaded cup Zintra was 5670.5 N (max. tilting moment 141.8 Nm) in bone with normal density and. 5748.3 N (max. tilting moment 143.7 Nm) in osteoporotic bone. For the Hofer Imhof (HI) threaded cup it was 7681.5 N (192.0 Nm) in bone with normal density and 6828.9 N (max. tilting moment 170.7 Nm) in the group with osteoporotic bone. The mean maximum extrusion force of the macro-textured press-fit cup Metallsockel CL was 3824.6 N (max. tilting moment 95.6 Nm) in bone with normal and 2246.2 N (max. tilting moment 56.2 Nm) in osteoporotic bone. For the Monoblock it was 1303.8 N (max. tilting moment 32.6 Nm) in normal and 1317 N (max. tilting moment 32.9 Nm) in osteoporotic bone. There was no significance. A reduction of the maximum tilting moment in osteoporotic bone of the ESKA press-fit cup Metallsockel CL was noticed. Conclusion: Results on macerated bone specimens showed no statistically significant reduction of the maximum tilting moment in specimens with osteoporotic bone density compared to normal bone, neither for threaded nor for the press-fit cups. With the limitation that the results were obtained using macerated bone, we could not detect any restrictions for the clinical indication of the examined cementless cups in osteoporotic bone

Arthroscopy vs. MRI for a detailed assessment of cartilage disease in osteoarthritis: diagnostic value of MRI in clinical practice

<p>Abstract</p> <p>Background</p> <p>In patients with osteoarthritis, a detailed assessment of degenerative cartilage disease is important to recommend adequate treatment. Using a representative sample of patients, this study investigated whether MRI is reliable for a detailed cartilage assessment in patients with osteoarthritis of the knee.</p> <p>Methods</p> <p>In a cross sectional-study as a part of a retrospective case-control study, 36 patients (mean age 53.1 years) with clinically relevant osteoarthritis received standardized MRI (sag. T1-TSE, cor. STIR-TSE, trans. fat-suppressed PD-TSE, sag. fat-suppressed PD-TSE, Siemens Magnetom Avanto syngo MR B 15) on a 1.5 Tesla unit. Within a maximum of three months later, arthroscopic grading of the articular surfaces was performed. MRI grading by two blinded observers was compared to arthroscopic findings. Diagnostic values as well as intra- and inter-observer values were assessed.</p> <p>Results</p> <p>Inter-observer agreement between readers 1 and 2 was good (kappa = 0.65) within all compartments. Intra-observer agreement comparing MRI grading to arthroscopic grading showed moderate to good values for readers 1 and 2 (kappa = 0.50 and 0.62, respectively), the poorest being within the patellofemoral joint (kappa = 0.32 and 0.52). Sensitivities were relatively low at all grades, particularly for grade 3 cartilage lesions. A tendency to underestimate cartilage disorders on MR images was not noticed.</p> <p>Conclusions</p> <p>According to our results, the use of MRI for precise grading of the cartilage in osteoarthritis is limited. Even if the practical benefit of MRI in pretreatment diagnostics is unequivocal, a diagnostic arthroscopy is of outstanding value when a grading of the cartilage is crucial for a definitive decision regarding therapeutic options in patients with osteoarthritis.</p

Cartilage Surgery in Overweight Patients: Clinical and MRI Results after the Autologous Matrix-Induced Chondrogenesis Procedure

Modern orthopaedic surgery provides a variety of techniques for cartilage repair. The Autologous Matrix-Induced Chondrogenesis (AMIC) procedure is a single-step technique with a collagen I/III scaffold for the treatment of full-thickness cartilage lesions. The aim of the study was to analyze the outcome of the AMIC procedure in overweight patients with knee cartilage defects. Overweight patients treated with AMIC surgery were followed up by clinical and MRI examination. 9 patients with a cartilage defect of the knee with a mean lesion size of 2.1±1.2 cm2 and an average body mass index (BMI) of 29.3 were available for the follow-up. The Lysholm Score was significantly improved by the AMIC procedure (38 to 67, p≤0.008). The VAS Score was significantly lower after the procedure (9 to 3, p≤0.018). In the postoperative MOCART Scale, the scaffold reached defect covering of 80%. However, 2 patients had to be revised due to persisting knee pain. The AMIC procedure enhances pain reduction and gain of knee function for cartilage defects of overweight patients. However, in cases of an increased BMI, the patient had to be informed that success rate is reduced despite good defect covering

Shank muscle strength training changes foot behaviour during a sudden ankle supination

Background: The peroneal muscles are the most effective lateral stabilisers whose tension braces the ankle joint complex against excessive supination. The purpose of this study was to identify the morphological and biomechanical effects of two machine-based shank muscle training methods. Methods: Twenty-two healthy male recreationally active sports students performed ten weeks of single-set high resistance strength training with 3 training sessions per week. The subjects conducted subtalar pronator/supinator muscle training (ST) with the right leg by using a custom-made apparatus; the left foot muscles were exercised with machine-based talocrural plantar and dorsiflexor training (TT). Muscle strength (MVIC), muscle volume and foot biomechanics (rearfoot motion, ground reaction forces, muscle reaction times) during a sudden ankle supination were recorded before and after the intervention. Results: Compared to TT, ST resulted in significantly higher pronator (14% vs. 8%, P<0.01) and supinator MVIC (25% vs. 12%, P<0.01). During sudden foot inversions, both ST and TT resulted in reduced supination velocity (-12%; P<0.01). The muscle reaction onset time was faster after the training in peroneus longus (PL) (P<0.01). Muscle volume of PL (P<0.01) and TA (P<0.01) increased significantly after both ST and TT. Conclusion: After both ST and TT, the ankle joint complex is mechanically more stabilised against sudden supinations due to the muscle volume increase of PL and TA. As the reduced supination velocities indicate, the strength training effects are already present during free-fall. According to a sudden ankle supination in standing position, both machine-based dorsiflexor and pronator strength training is recommended for enhancing the mechanical stability of the ankle

Validation of a German version of the International Hip Outcome Tool (G-iHOT33) according to the COSMIN checklist: how much improvement is clinically relevant?

The evaluation of the subjective health-related quality of life is especially for young, active patients with hip joint disorders important. The MAHORN study group has recently developed the "International Hip Outcome Tool" (iHOT33), a self-administered patient-reported outcome tool, which includes questions on the patient's symptoms, functional and sports limitations as well as social, emotional, and occupational limitations. The purpose of this study was to adapt and validate a German version of the iHOT33 according to the COSMIN checklist. To validate the G-iHOT33, we conducted a prospective multicenter cohort study on patients with hip disorders and a score a parts per thousand yen4 on the modified Tegner Activity Scale. The patients completed the G-iHOT33 questionnaire twice at intervals of at least 2 weeks. In addition, we recorded the Hip Outcome Score (HOS), a modified Tegner Activity Scale (TAS), the EuroQol-5D (EQ5-D), and a subjective assessment of the limitations. Evaluation of psychometric properties was conducted following the COSMIN checklist for validation of health status measurement instruments. The methodical testing for reliability included internal consistency, test-retest reliability, and measurement error. For testing of validity, we analyzed construct validity, hypotheses testing, interpretability, and responsiveness. Between December 2013 and December 2014, eighty-three consecutive patients completed both questionnaires and were available for data analysis. Cronbach's alpha was 0.97 (95 % CI 0.96, 0.99) confirming internal consistency and test-retest reliability of the G-iHOT-33 was high with an ICC = 0.88 (95 % CI 0.80, 0.99). All a priori hypotheses were confirmed, further, no floor- or ceiling-effects occurred. The G-iHOT33 showed good responsiveness with a minimal important change (MIC) of 10 points. The German translation of the iHOT-33 (G-iHOT-33) is a viable tool for the evaluation of active patients with a hip disorder. Following the complete COSMIN checklist, we could prove that G-iHOT33 is a reliable, valid, and responsive PRO measurement tool. We could show that the minimal important change, a change of health condition the patient discerns is 10 points in the G-iHOT33 scale. This is the first study providing results on psychometric properties of the iHOT33 subscales. Level of evidence 1b validating cohort study

Additional file 1: of Angle-torque relationship of the subtalar pronators and supinators in younger and elderly males and females

Summary of the strength results of all groups (mean Âą SD). (PDF 220 kb