1,952 research outputs found
Thermomechanical Behavior of the HL-LHC 11 Tesla Nb3Sn Magnet Coil Constituents during Reaction Heat Treatment
The knowledge of the temperature induced changes of the superconductor
volume, and of the thermo-mechanical behaviour of the different coil and
tooling materials is required for predicting the coil geometry and the stress
distribution in the coil after the Nb3Sn reaction heat treatment. In the
present study we have measured the Young's and shear moduli of the HL-LHC 11 T
Nb3Sn dipole magnet coil and reaction tool constituents during in situ heat
cycles with the dynamic resonance method. The thermal expansion behaviours of
the coil components and of a free standing Nb3Sn wire were compared based on
dilation experiments.Comment: 6 pages, 12 figures, presented at MT25 conferenc
Biomechanical properties of the thin PVD coatings defined by red blood cells
The measurement of the strength of bonds between biomaterials and cells is a major challenge in biotribology since it allows
for the identification of different species in adhesion phenomena. Biomaterials, such as diamond-like carbon (DLC), titanium, and titanium
nitride, seem to be good candidates for future blood-contact applications. These materials were deposited as thin films by the hybrid pulsed
laser deposition (PLD) technique to examine the influence of such surfaces on cell behavior. The biomaterial examinations were performed
in static conditions with red blood cells and then subjected to a dynamical test to observe the cell detachment kinetics. The tests revealed
differences in behavior with respect to the applied coating material. The strongest cell-biomaterial interaction was observed for the carbonbased
materials compared to the titanium and titanium nitride. Among many tests, a radial flow interaction analysis gives the opportunity to
analyze cell adhesion to the applied material with the high accuracy. Analysis of concentrates helped to select materials for further dynamic
tests on blood using an aortic flow simulator. In this case, the platelet adhesion to the surface and their degree of activation was analyzed.
The quality of the selected coating was tested using a scratch test. The analyses of the microstructure were done using high resolution
transmission electron microscopy. The phase composition and the residual stress were analyzed using X-ray diffraction methods
Where to see climate change best in radio occultation variables – study using GCMs and ECMWF reanalyses
Radio occultation (RO) is a new technique to observe the upper troposphere and
lower stratosphere (UTLS), a region that reacts particularly sensitive to climate
change. Featuring characteristics such as long-term stability, SI traceability, all-weather
capability, global coverage, and high accuracy and vertical resolution, RO data fulfill the
requirements for climate monitoring in the UTLS. However, while a range of studies has shown the
climate utility of RO it has not yet been explored sytematically where to see climate change best
in RO variables. Therefore we perform here a systematic trend study for the RO variables
refractivity, pressure, and temperature (bending angle, not depending on height but impact
parameter, is left for separate study). The trends, given at geopotential height levels and for
layer gradients, are explored to determine seasons, geographic regions, and height domains, which
show a significant trend signal. Because continuous RO data are available since 2001 only,
reanalyses (ERA-40 and ERA-Interim) and global circulation model simulations of the
Intergovernmental Panel on Climate Change Assessment Report 4 (CCSM3, ECHAM5, HadCM3) are used as
proxy data for RO. It is shown that RO data are sensitive at different height ranges and that thus
several indicators of climate change can be retrieved. Refractivity emerges as indicator in the
lower stratosphere (LS) and tropopause region at about 14 km to 24 km, pressure over the whole
UTLS, and both in all large-scale regions except the polar caps. Temperature qualifies as
indicator in the upper troposphere below about 16 km and in the LS above about 21 km. Overall,
refractivity and pressure alone are adequate indicators for the UTLS, but temperature as commonly
used variable facilitates easy interpretation of results. Layer gradients were found to be further
sensitive indicators providing additional information. Besides large-scale global and hemispheric
means the tropics and the mid-latitudes appear as regions suitable to track climate change with RO
data. The results also point to the value of utilizing in addition to annual means specific
seasons, such as northern hemispheric fall and summer, for early climate signal detection. Since
RO data feature much better vertical resolution than the proxy data of this study, more detailed
insights can be expected when a longer RO record will be available
- …