Novel metallic and insulating states at a bent quantum Hall junction

A non-planar geometry for the quantum Hall (QH) effect is studied, whereby two quantum Hall (QH) systems are joined at a sharp right angle. When both facets are at equal filling factor nu the junction hosts a channel with non-quantized conductance, dependent on nu. The state is metallic at nu = 1/3, with conductance along the junction increasing as the temperature T drops. At nu = 1, 2 it is strongly insulating, and at nu = 3, 4 shows only weak T dependence. Upon applying a dc voltage bias along the junction, the differential conductance again shows three different behaviors. Hartree calculations of the dispersion at the junction illustrate possible explanations, and differences from planar QH structures are highlighted.Comment: 5 pages, 4 figures, text + figs revised for clarit

Interface affected zone for optimal strength and ductility in heterogeneous laminate

Interfaces have been reported to significantly strengthen and toughen metallic materials. However, there has been a long-standing question on whether interface-affected-zone (IAZ) exists, and how it might behave. Here we report in situ high-resolution strain mapping near interfaces in a copper-bronze heterogeneous laminate, which revealed the existence of IAZs. Defined as the zone with strain gradient, the IAZ was found to form by the dislocations emitted from the interface. The IAZ width remained largely constant with a magnitude of a few micrometers with increasing applied strain. Interfaces produced both back stress strengthening and work hardening, which led to both higher strength and higher ductility with decreasing interface spacing until adjacent IAZs started to overlap, after which a tradeoff between strength and ductility occurred, indicating the existence of an optimum interface spacing for the best mechanical properties. These findings are expected to help with designing laminates and other heterogeneous metals and alloys for superior mechanical properties

Influence of the carbon/nitrogen/phosphorus ratio on polycyclic aromatic hydrocarbon degradation by Mycobacterium and Sphingomonas in soil

Biodegradation of polycyclic aromatic hydrocarbons (PAHs) in the environment is often limited due to unfavorable nutrient conditions for the bacteria that use these PAHs as sole source of carbon and energy. Mycobacterium and Sphingomonas are 2 PAH-degrading specialists commonly present in PAH-polluted soil, but not much is known about their specific nutrient requirements. By adding different inorganic supplements of nitrogen (N) and phosphorus (P), affecting the overall carbon/nitrogen/phosphorus ratio of soil in soil slurry degradation tests, we investigated the impact of soil inorganic N and P nutrient conditions on PAH degradation by PAH-degrading Sphingomonas and Mycobacterium strains. The general theoretically calculated C/N/P ratio of 100/10/1 (expressed in moles) allowed rapid PAH metabolization by Sphingomonas and Mycobacterium strains without limitation. In addition, PAH-degradation rate and extent was not affected when ca. ten times lower concentrations of N and P were provided, indicating that Sphingomonas and Mycobacterium strains are capable of metabolizing PAHs under low nutrient conditions. Nor does PAH-degradation seem to be affected by excesses of N and P creating an imbalanced C/N/P ratio. However, supplements of N and P salts increased the salinity of soil slurry solutions and seriously limited or even completely blocked biodegradation

Kinetic constraints on the In-situ remediation of soils contaminated with organic chemicals.

Cleanup of contaminated soils to comply with soil quality limits currently receives much interest.In-situ remediation of contaminated soils relies on the ability of the techniques employed to enhance the rate of release of contaminants from the soil-sorbed and nonaqueous phase liquid (NAPL) phases into the aqueous or gaseous phases from which they can be more readily removed and treated. Contaminant concentrations in these “environmentally mobile” forms usually decline over time so that the economic efficiency and the overall success of remediation technologies are subject to the “law of diminishing returns”. In this paper we consider the “state of the art” in our understanding of NAPL dissolution and transport, desorption of soilsorbed contaminants and fluid flow in porous media. The extent to which these processes may constrain the success of bioremediation, pump-and-treat remediation and soil venting in relation to established soil quality limits is addressed. Finally, we suggest directions for future research and comment on legislative considerations