Signatures of a Noise-Induced Quantum Phase Transition in a Mesoscopic Metal Ring

We study a mesoscopic ring with an in-line quantum dot threaded by an Aharonov-Bohm flux. Zero-point fluctuations of the electromagnetic environment capacitively coupled to the ring, with $\omega^s$ spectral density, can suppress tunneling through the dot, resulting in a quantum phase transition from an unpolarized to a polarized phase. We show that robust signatures of such a transition can be found in the response of the persistent current in the ring to the external flux as well as to the bias between the dot and the arm. Particular attention is paid to the experimentally relevant cases of ohmic ($s=1$) and subohmic ($s=1/2$) noise.Comment: 4 pages, 4 figures, realistic parameters estimated, reference update

Compositional redistribution during casting of Hg sub 0.8 Cd sub 0.2 Te alloys

A series of Hg(0.8)Cd(0.2)Te ingots was cast both vertically and horizontally under well-defined thermal conditions by using a two-zone furnace with isothermal heat-pipe liners. The main objective of the experiments was to establish correlations between casting parameters and compositional redistribution and to develop ground-based data for a proposed flight experiment of casting of Hg(1-x)Cd(x)Te alloys under reduced gravity conditions. The compositional variations along the axial and radial directions were determined by precision density measurements, infrared transmission spectra, and X-ray energy dispersion spectrometry. Comparison between the experimental results and a numerical simulation of the solidification process of Hg(0.8)Cd(0.2)Te is described

The instantaneous shear modulus in the shoving model

We point out that the instantaneous shear modulus of the shoving model for the non-Arrhenius temperature dependence of viscous liquids' relaxation time is the experimentally accessible high-frequency plateau modulus, not the idealized instantaneous affine shear modulus that cannot be measured. Data for a large selection of metallic glasses are compared to three different versions of the shoving model. The original shear-modulus based version shows a slight correlation to the Poisson ratio, which is eliminated by the energy-landscape formulation of the model in which the bulk modulus plays a minor role

A new model for the double well potential

A new model for the double well potential is presented in the paper. In the new potential, the exchanging rate could be easily calculated by the perturbation method in supersymmetric quantum mechanics. It gives good results whether the barrier is high or sallow. The new model have many merits and may be used in the double well problem.Comment: 3pages, 3figure

Two-photon interference with two independent pseudo-thermal sources

The nature of two-photon interference is a subject that has aroused renewed interest in recent years and is still under debate. In this paper we report the first observation of two-photon interference with independent pseudo-thermal sources in which sub-wavelength interference is observed. The phenomenon may be described in terms of the classical statistical distribution of the two sources and their optical transfer functions.Comment: Phys. Rev. A 74, 053807 (2006

Transient stability analysis and enhancement of renewable energy conversion system during LVRT

Grid-connected renewable energy conversion systems (RECSs) are usually required by grid codes to possess the low voltage ride through (LVRT) and reactive power support capabilities so as to cope with grid voltage sags. During LVRT, RECS's terminal voltage becomes sensitive and changeable with its output current, which brings a great challenge for the RECS to resynchronize with the grid by means of phase-locked loops (PLLs). This paper indicates that loss of synchronism (LOS) of PLLs is responsible for the transient instability of grid-connected RECSs during LVRT, and the LOS is essentially due to the transient interaction between the PLL and the weak terminal voltage. For achieving a quantitative analysis, an equivalent swing equation model is developed to describe the transient interaction. Based on the model, the transient instability mechanism of RECSs during LVRT is clarified. Furthermore, a transient stability enhancement method is proposed to avoid the possibility of transient instability. Simulations performed on the New England 39-bus test system verify the effectiveness of the method

An integrating factor matrix method to find first integrals

In this paper we developed an integrating factor matrix method to derive conditions for the existence of first integrals. We use this novel method to obtain first integrals, along with the conditions for their existence, for two and three dimensional Lotka-Volterra systems with constant terms. The results are compared to previous results obtained by other methods

Transport critical current density in Fe-sheathed nano-SiC doped MgB2 wires

The nano-SiC doped MgB2/Fe wires were fabricated using a powder-in-tube method and an in-situ reaction process. The depression of Tc with increasing SiC doping level remained rather small due to the counterbalanced effect of Si and C co-doping. The high level SiC co-doping allowed creation of the intra-grain defects and nano-inclusions, which act as effective pinning centers, resulting in a substantial enhancement in the Jc(H) performance. The transport Jc for all the wires is comparable to the magnetic Jc at higher fields despite the low density of the samples and percolative nature of current. The transport Ic for the 10wt% SiC doped MgB2/Fe reached 660A at 5K and 4.5T (Jc = 133,000A/cm2) and 540A at 20K and 2T (Jc = 108,000A/cm2). The transport Jc for the 10wt% SiC doped MgB2 wire is more than an order of magnitude higher than for the state-the-art Fe-sheathed MgB2 wire reported to date at 5K and 10T and 20K and 5T respectively. There is a plenty of room for further improvement in Jc as the density of the current samples is only 50%.Comment: 4 pages, 7 figures, presented at ASC 2002, Housto