Constraining the nuclear equation of state at subsaturation densities

Only one third of the nucleons in $^{208}$Pb occupy the saturation density area. Consequently nuclear observables related to average properties of nuclei, such as masses or radii, constrain the equation of state (EOS) not at saturation density but rather around the so-called crossing density, localised close to the mean value of the density of nuclei: $\rho\simeq$0.11 fm$^{-3}$. This provides an explanation for the empirical fact that several EOS quantities calculated with various functionals cross at a density significantly lower than the saturation one. The third derivative M of the energy at the crossing density is constrained by the giant monopole resonance (GMR) measurements in an isotopic chain rather than the incompressibility at saturation density. The GMR measurements provide M=1110 $\pm$ 70 MeV (6% uncertainty), whose extrapolation gives K$_\infty$=230 $\pm$ 40 MeV (17% uncertainty).Comment: 4 pages, 4 figure

Increased hazard of myocardial infarction with insulin‐provision therapy in actively smoking patients with diabetes mellitus and stable ischemic heart disease: The BARI 2D (Bypass Angioplasty Revascularization Investigation 2 Diabetes) trial

Background In the BARI 2D (Bypass Angioplasty Revascularization Investigation 2 Diabetes) trial, randomization of diabetic patients with stable ischemic heart disease to insulin provision ( IP ) therapy, as opposed to insulin sensitization ( IS ) therapy, resulted in biochemical evidence of impaired fibrinolysis but no increase in adverse clinical outcomes. We hypothesized that the prothrombotic effect of IP therapy in combination with the hypercoagulable state induced by active smoking would result in an increased risk of myocardial infarction ( MI ). Methods and Results We analyzed BARI 2D patients who were active smokers randomized to IP or IS therapy. The primary end point was fatal or nonfatal MI . PAI ‐1 (plasminogen activator inhibitor 1) activity was analyzed at 1, 3, and 5 years. Of 295 active smokers, MI occurred in 15.4% randomized to IP and in 6.8% randomized to IS over the 5.3 years ( P =0.023). IP therapy was associated with a 3.2‐fold increase in the hazard of MI compared with IS therapy (hazard ratio: 3.23; 95% confidence interval, 1.43–7.28; P =0.005). Baseline PAI ‐1 activity (19.0 versus 17.5 Au/mL, P =0.70) was similar in actively smoking patients randomized to IP or IS therapy. However, IP therapy resulted in significantly increased PAI ‐1 activity at 1 year (23.0 versus 16.0 Au/mL, P =0.001), 3 years (24.0 versus 18.0 Au/mL, P =0.049), and 5 years (29.0 versus 15.0 Au/mL, P =0.004) compared with IS therapy. Conclusions Among diabetic patients with stable ischemic heart disease who were actively smoking, IP therapy was independently associated with a significantly increased hazard of MI . This finding may be explained by higher PAI ‐1 activity in active smokers treated with IP therapy. Clinical Trial Registration URL : http://www.clinicaltrials.gov . Unique identifier: NCT 00006305. </jats:sec

Characterization of dentine to assess bond strength of dental composites

This study was performed to develop alternating dentine adhesion models that could help in the evaluation of a self-bonding dental composite. For this purpose dentine from human and ivory was characterized chemically and microscopically before and after acid etching using Raman and SEM. Mechanical properties of dentine were determined using 3 point bend test. Composite bonding to dentine, with and without use of acid pre-treatment and/or the adhesive, were assessed using a shear bond test. Furthermore, micro gap formation after restoration of 3 mm diameter cavities in dentine was assessed by SEM. Initial hydroxyapatite level in ivory was half that in human dentine. Surface hydroxyapatites decreased by approximately half with every 23 s of acid etch. The human dentine strength (56 MPa) was approximately double that of ivory, while the modulus was almost comparable to that of ivory. With adhesive use, average shear bond strengths were 30 and 26 MPa with and without acid etching. With no adhesive, average bond strength was 6 MPa for conventional composites. This, however, increased to 14 MPa with a commercial flowable "self-bonding" composite or upon addition of low levels of an acidic monomer to the experimental composite. The acidic monomer additionally reduced micro-gap formation with the experimental composite. Improved bonding and mechanical properties should reduce composite failures due to recurrent caries or fracture respectively

Economical comparison of CHP systems for industrial user with large steam demand

In this paper cogeneration benefits applied to a user with a high steam demand are analyzed. The methodology for the feasibility study and the economical analysis of the investment is presented under the Italian legislative framework. The methodology is applied to an actual case and a detailed description and discussion of all data input is provided. Especially this last key point will be faced using starting data usually available in these kind of studies (i.e., not very detailed for thermal consumption). Finally a comparison of different CHP technologies and a sensitivity analysis is done

A convex selective segmentation model based on a piece-wise constant metric guided edge detector function

The challenge of segmentation for noisy images, especially those that have light in their backgrounds, is still exists in many advanced state-of-the-art segmentation models. Furthermore, it is significantly difficult to segment such images. In this article, we provide a novel variational model for the simultaneous restoration and segmentation of noisy images that have intensity inhomogeneity and high contrast background illumination and light. The suggested concept combines the multi-phase segmentation technology with the statistical approach in terms of local region knowledge and details of circular regions that are, in fact, centered at every pixel to enable in-homogeneous image restoration. The suggested model is expressed as a fuzzy set and is resolved using the multiplier alternating direction minimization approach. Through several tests and numerical simulations with plausible assumptions, we have evaluated the accuracy and resilience of the proposed approach over various kinds of real and synthesized images in the existence of intensity inhomogeneity and light in the background. Additionally, the findings are contrasted with those from cutting-edge two-phase and multi-phase methods, proving the superiority of our proposed approach for images with noise, background light, and inhomogeneity