418 research outputs found
Dislocation patterns and the similitude principle: 2.5D mesoscale simulations
During plastic flow of crystalline solids, dislocations self-organize in the form of patterns, with a wavelength that is inversely proportional to stress. After four decades of investigations, the origin of this property is still under discussion. We show that dislocation patterns verifying the principle of similitude can be obtained from dynamics simulations of double slip. These patterns are formed in the presence of long- and short-range interactions, but they are not significantly modified when only short-range interactions are present. This new insight into dislocation patterning phenomena has important implications regarding current models
Missing physics in stick-slip dynamics of a model for peeling of an adhesive tape
It is now known that the equations of motion for the contact point during
peeling of an adhesive tape mounted on a roll introduced earlier are singular
and do not support dynamical jumps across the two stable branches of the peel
force function. By including the kinetic energy of the tape in the Lagrangian,
we derive equations of motion that support stick-slip jumps as a natural
consequence of the inherent dynamics. In the low mass limit, these equations
reproduce solutions obtained using a differential-algebraic algorithm
introduced for the earlier equations. Our analysis also shows that mass of the
ribbon has a strong influence on the nature of the dynamics.Comment: Accepted for publication in Phys. Rev. E (Rapid Communication
The hidden order behind jerky flow
Jerky flow, or the Portevin-Le Chatelier effect, is investigated at room temperature by applying statistical, multifractal and dynamical analyses to the unstable plastic flow of polycrystalline Al-Mg alloys with different initial microstructures. It is shown that a chaotic regime is found at medium strain rates, whereas a self-organized critical dynamics is observed at high strain rates. The cross-over between these two regimes is signified by a large spread in the multifractal spectrum. Possible physical mechanisms leading to this wealth of patterning behavior and their dependence on the strain rate and the initial microstructure are discussed
Relaxation oscillations and negative strain rate sensitivity in the Portevin - Le Chatelier effect
A characteristic feature of the Portevin - Le Chatelier effect or the jerky
flow is the stick-slip nature of stress-strain curves which is believed to
result from the negative strain rate dependence of the flow stress. The latter
is assumed to result from the competition of a few relevant time scales
controlling the dynamics of jerky flow. We address the issue of time scales and
its connection to the negative strain rate sensitivity of the flow stress
within the framework of a model for the jerky flow which is known to reproduce
several experimentally observed features including the negative strain rate
sensitivity of the flow stress. We attempt to understand the above issues by
analyzing the geometry of the slow manifold underlying the relaxational
oscillations in the model. We show that the nature of the relaxational
oscillations is a result of the atypical bent geometry of the slow manifold.
The analysis of the slow manifold structure helps us to understand the time
scales operating in different regions of the slow manifold. Using this
information we are able to establish connection with the strain rate
sensitivity of the flow stress. The analysis also helps us to provide a proper
dynamical interpretation for the negative branch of the strain rate
sensitivity.Comment: 7 figures, To appear in Phys. Rev.
Modelización de las inestabilidades en la deformación plástica de monocristales de circona estabilizada con itria (YCSZ)
En este trabajo se presenta un modelo para explicar las inestabilidades dinámicas observadas durante la deformación
plástica a alta temperatura de monocristales de circona estabilizada con itria, (YCSZ, yttria cubic stabilized zirconia) con
alto contenido en itria. El modelo se basa en el fenómeno Portevin-Le Chatelier (PLC), que consiste en episodios sucesivos
de anclaje y desanclaje de dislocaciones cuando éstas se mueven con una velocidad del mismo orden que los defectos
que obstaculizan su movimiento. La evaluación numérica de los parámetros implicados en el modelo muestra que las
inestabilidades plásticas son totalmente compatibles con el efecto Portevin- Le Chatelie
High order amplitude equation for steps on creep curve
We consider a model proposed by one of the authors for a type of plastic
instability found in creep experiments which reproduces a number of
experimentally observed features. The model consists of three coupled
non-linear differential equations describing the evolution of three types of
dislocations. The transition to the instability has been shown to be via Hopf
bifurcation leading to limit cycle solutions with respect to physically
relevant drive parameters. Here we use reductive perturbative method to extract
an amplitude equation of up to seventh order to obtain an approximate analytic
expression for the order parameter. The analysis also enables us to obtain the
bifurcation (phase) diagram of the instability. We find that while
supercritical bifurcation dominates the major part of the instability region,
subcritical bifurcation gradually takes over at one end of the region. These
results are compared with the known experimental results. Approximate analytic
expressions for the limit cycles for different types of bifurcations are shown
to agree with their corresponding numerical solutions of the equations
describing the model. The analysis also shows that high order nonlinearities
are important in the problem. This approach further allows us to map the
theoretical parameters to the experimentally observed macroscopic quantities.Comment: LaTex file and eps figures; Communicated to Phys. Rev.
PVDF/BaTiO3 composite foams with high content of β phase by thermally induced phase separation (TIPS)
Poly(vinylidene fluoride) (PVDF) displays ferroelectric, piezoelectric and pyroelectric behavior and it is widely used in high-tech applications including sensors, transducers, energy harvesting devices and actuators. The crystallization of this polymer into highly polar β phase is desirable but is hard to achieve without applying specific thermo-mechanical treatments. Indeed, fabrication processes directly affect PVDF molecular chain conformation, inducing distinct polymorphs. In this paper, we present the fabrication of PVDF/BaTiO3 composite foams by thermally induced phase separation method (TIPS). Different compositions are tested and characterized. The crystallinity, and in particular the development of electroactive β crystal phase is monitored by FTIR, DSC and XRD measurements. Dielectric properties are also evaluated. It turns out that TIPS is a straightforward method that clearly promotes the spontaneous growth of the β phase in PVDF and its composite foams, without the need to apply additional treatments, and also significantly improves the degree of crystallinity. BaTiO3 content gives additional value to the development of β phase and total crystallinity of the systems. The low permittivity values (between 2 and 3), combined with the cellular morphology makes these materials suitable as lightweight components of microelectronic circuits
Dynamics of stick-slip in peeling of an adhesive tape
We investigate the dynamics of peeling of an adhesive tape subjected to a
constant pull speed. We derive the equations of motion for the angular speed of
the roller tape, the peel angle and the pull force used in earlier
investigations using a Lagrangian. Due to the constraint between the pull
force, peel angle and the peel force, it falls into the category of
differential-algebraic equations requiring an appropriate algorithm for its
numerical solution. Using such a scheme, we show that stick-slip jumps emerge
in a purely dynamical manner. Our detailed numerical study shows that these set
of equations exhibit rich dynamics hitherto not reported. In particular, our
analysis shows that inertia has considerable influence on the nature of the
dynamics. Following studies in the Portevin-Le Chatelier effect, we suggest a
phenomenological peel force function which includes the influence of the pull
speed. This reproduces the decreasing nature of the rupture force with the pull
speed observed in experiments. This rich dynamics is made transparent by using
a set of approximations valid in different regimes of the parameter space. The
approximate solutions capture major features of the exact numerical solutions
and also produce reasonably accurate values for the various quantities of
interest.Comment: 12 pages, 9 figures. Minor modifications as suggested by refere
Fingering Instability of Dislocations and Related Defects
We identify a fundamental morphological instability of mobile dislocations in
crystals and related line defects. A positive gradient in the local driving
force along the direction of defect motion destabilizes long-wavelength
vibrational modes, producing a ``fingering'' pattern. The minimum unstable
wavelength scales as the inverse square root of the force gradient. We
demonstrate the instability's onset in simulations of a screw dislocation in Al
(via molecular dynamics) and of a vortex in a 3-d XY ``rotator'' model.Comment: 4 pages, 3 figure
- …