Influence of heat treatment and nickel content on the properties of GX4CrNi13-4 steel

For the EN GX4CrNi13-4 martensitic stainless steel, research was conducted to investigate the impact of the quenching intensity and the content of nickel on the mechanical properties and amount of retained austenite. It was found that the amount of retained austenite significantly increases with growing nickel concentration. On the other hand, the cooling rate at quenching makes a difference only if the cooling is intensive, then amount of retained austenite decrease. A higher nickel content improves the mechanical properties. With more intensive cooling, the tensile strength decreases while the yield strength increases. The ductility is not significantly affected by the cooling intensity

The Influence of Foundry Scrap Returns on Chemical Composition and Microstructure Development of AlSi9Cu3 Alloy

Recycling is now, more than ever, an important part of any foundry process due to the high cost of energy. The basis of the work presented here is a study of the addition of foundry scrap returns to the melt in order to reduce material and energy costs. The most important issue in such a process is the quality of both the prepared melt and final product. In this work, scrap returns were added to the AlSi9Cu3 base alloy in different proportions. Chemical composition was monitored, the solidification path was predicted by CALPHAD calculations and monitored by thermal analysis, and the formed microstructure was studied. The mechanical properties were also determined. The results showed that as the amount of scrap returns increased, elements such as Fe, Ni, Pb, Sr, etc. were more built up and elements such as Mg, Mn, Cr, etc. were decreased due to oxidation. The different chemical composition led to a reduced Mn:Fe ratio, resulting in the formation of needle-like Fe-rich phases and a decrease in mechanical properties

Improvement of Mechanical Properties of Cast Ceramic Cores Based on Ethyl Silicate

The aim of the paper is experimental verification of the influence of the composition of the ceramic mixture on the mechanical properties of cast ethyl silicate cores. Cast ceramic cores have a great potential in the production of complex castings, especially in the field of hydropower. However, the disadvantage of the cast ceramic cores is their low strength during cores removing from the core box and handling with them. The research is focused mainly on the possibilities of increasing the handling strength of the cores during removal from the core box and after their ignition. The paper investigates different ways of increasing the strength of cast ceramic cores by adjusting the composition of the ceramic mixture. Further, the research verifies the possibility of increasing the strength of ceramic cores by adding synthetic fibers to the ceramic mixture. The paper also contains the results of measuring the strength of the cores after impregnation with a solution of phosphorous binder and subsequent annealing

Requirements for Hybrid Technology Enabling the Production of High-Precision Thin-Wall Castings

Prototypes and small series production of metal thin-walled components is a field for the use of a number of additive technologies. This method has certain limits related to the size and price of the parts, productivity, or the type of requested material. On the other hand, conventional production methods encounter the limits of shape, which are currently associated with the implementation of optimization methods such as topological optimization or generative design. An effective solution is employing hybrid technology, which combines the advantages of 3D model printing and conventional casting production methods. This paper describes the design of aluminum casting using topological optimization and technological co-design for the purpose of switching to new manufacturing technology. It characterizes the requirements of hybrid technology for the material and properties of the model in relation to the production operations of the investment casting technology. Optical roughness measurement compares the surface quality in a standard wax model and a model obtained by additive manufacturing (AM) of polymethyl methacrylate (PMMA) using the binder jetting method. The surface quality results of the 3D printed model evaluated by measuring the surface roughness are lower than for the standard wax model; however, they still meet the requirements of prototype production technology. The measurements proved that the PMMA model has half the thermal expansion in the measured interval compared to the wax model, which was confirmed by minimal shape deviations in the dimensional analysis

Přenos tepla při odlévání do skořepinových forem

Vydáno chybně pod ISSN 1210-047