Isolation and partial characterization of two porcine spleen ferritin fractions with different electrophoretic mobility

Ferritin isolated from porcine spleen could routinely be separated in two fractions on nondenaturating gradient gels. Both fractions could be isolated with a purity of 96% when applied to two serially linked columns, each 200 cm in length, packed respectively with Sepharose 4B and Sepharose 6B. Both fractions were similar as judged by electron microscopy. Assessed biochemically fractions were equal with respect to subunit composition, iron and phosphorus content, as well as amino acid composition (with the exception of N-acetylglucosamine). Carbohydrate analysis showed that the fraction with an apparent mass of 440 kDa (=FFL) contained 1.8% (w/w) glycans, whereas the fraction with an apparent mass of 670 kDa (=FFH) contained nearly five times as much (neutral) sugar residues (8.9%, w/w) and 10 times as much sialic acid. This difference in amount of carbohydrate side chains might explain the dissimilarity in electrophoretic mobility of the two fractions

Visible spectroscopy in the DIII-D divertor

Spectroscopy measurements in the DIII-D divertor have been carried out with a survey spectrometer which provides simultaneous registration of the visible spectrum over the region 400--900 nm with a resolution of 0.2 nm. Broad spectral coverage is achieved through use of a fiberoptic transformer assembly to map the curved focal plane of a fast (f/3) Rowland-circle spectrograph into a rastered format on the rectangular sensor area of a two-dimensional CCD camera. Vertical grouping of pixels during CCD readout integrates the signal intensity over the height of each spectral segment in the rastered image, minimizing readout time. For the full visible spectrum, readout time is 50 ms. Faster response time (< 10 ms) may be obtained by selecting for readout just a small number of the twenty spectral segments in the image on the CCD. Simultaneous recording of low charge states of carbon, oxygen and injected impurities has yielded information about gas recycling and impurity behavior at the divertor strike points. Transport of lithium to the divertor region during lithium pellet injection has been studied, as well as cumulative deposition of lithium on the divertor targets from pellet injection over many successive discharges

Characterization of atomic and molecular impurity sources and transport at the tokamak edge

The characterization of impurity sources in the tokamak edge is challenging because of the highly localized nature of impurity generation. Detailed, spatially resolved, diagnostic information is needed, and three-dimensional (3-D) modeling is required for interpretation. There is also a need for a more extensive atomic and molecular data base for the conditions encountered in this region. The availability of new measurements of photon efficiencies for some relevant hydrocarbon molecules for plasma conditions typical for the tokamak edge and the development of a 3-D Monte Carlo impurities code have enabled the successful modeling of spatially resolved measurements in the vicinity of the pump limiter neutralizer plate and near the inner wall of Tore Supra

Patent Pools: Intellectual Property Rights and Competition

Patent pools do not correct all problems associated with patent thickets. In this respect, patent pools might not stop the outsider problem from striking pools. Moreover, patent pools can be expensive to negotiate, can exclude patent holders with smaller numbers of patents or enable a group of major players to form a cartel that excludes new competitors. For all the above reasons, patent pools are subject to regulatory clearance because they could result in a monopoly. The aim of this article is to present the relationship between patents and competition in a broad context