38 research outputs found
Reply to Comment by W. Kurz on "Tectonic map and overall architecture of the Alpine orogenâ
No Abstrac
A map-view restoration of the Alpine-Carpathian-Dinaridic system for the Early Miocene
A map-view palinspastic restoration of tectonic units in the Alps, Carpathians and Dinarides reveals the plate tectonic configuration before the onset of Miocene to recent deformations. Estimates of shortening and extension from the entire orogenic system allow for a semi-quantitative restoration of translations and rotations of tectonic units during the last 20Ma. Our restoration yielded the following results: (1) The Balaton Fault and its eastern extension along the northern margin of the Mid-Hungarian Fault Zone align with the Periadriatic Fault, a geometry that allows for the eastward lateral extrusion of the Alpine-Carpathian-Pannonian (ALCAPA) Mega-Unit. The Mid-Hungarian Fault Zone accommodated simultaneous strike-perpendicular shortening and strike-slip movements, concomitant with strike-parallel extension. (2) The Mid-Hungarian Fault Zone is also the locus of a former plate boundary transforming opposed subduction polarities between Alps (including Western Carpathians) and Dinarides. (3) The ALCAPA Mega-Unit was affected by 290km extension and fits into an area W of present-day Budapest in its restored position, while the Tisza-Dacia Mega-Unit was affected by up to 180km extension during its emplacement into the Carpathian embayment. (4) The external Dinarides experienced Neogene shortening of over 200km in the south, contemporaneous with dextral wrench movements in the internal Dinarides and the easterly adjacent Carpatho-Balkan orogen. (5) N-S convergence between the European and Adriatic plates amounts to some 200km at a longitude of 14° E, in line with post-20Ma subduction of Adriatic lithosphere underneath the Eastern Alps, corroborating the discussion of results based on high-resolution teleseismic tomography. The displacement of the Adriatic Plate indenter led to a change in subduction polarity along a transect through the easternmost Alps and to substantial Neogene shortening in the eastern Southern Alps and external Dinarides. While we confirm that slab-pull and rollback of oceanic lithosphere subducted beneath the Carpathians triggered back-arc extension in the Pannonian Basin and much of the concomitant folding and thrusting in the Carpathians, we propose that the rotational displacement of this indenter provided a second important driving force for the severe Neogene modifications of the Alpine-Carpathian-Dinaridic orogenic syste
NEW MOHO MAP OF ITALY
In complex tectonics regions, seismological, geophysical, and geodynamic modeling require accurate definition of the Moho geometry. Various active and passive seismic experiments performed in the central Mediterranean region revealed local information on the Moho depth, in some cases used to produce interpolated maps. In this paper, we present a new and original map of the 3-D Moho geometry obtained by integrating selected high-quality controlled source seismic and teleseismic receiver function data. The very small cell size makes the retrieved model suitable for detailed regional studies, crustal corrections in teleseismic tomography, advanced 3-D ray tracing in regional earthquake location, and local earthquake tomography. Our results show the geometry of three different Moho interfaces: the European, Adriatic-Ionian, and Tyrrhenian. The three distinct Moho are fashioned following the Alpine and Apennines subduction, collision, and back-arc spreading and show medium- to high-frequency topographic undulations reflecting the complexity of the geodynamic evolution
SAPHYR: Swiss Atlas of Physical Properties of Rocks: the continental crust in a database
The Swiss Atlas of Physical Properties of Rocks (SAPHYR) project aims at centralize, uniform, and digitize dispersed and often hardly accessible laboratory data on physical properties of rocks from Switzerland and surrounding regions. The goal of SAPHYR is to make the quality-controlled and homogenized data digitally accessible to an open public, including industrial, engineering, land and resource planning companies as well as governmental and academic institutions, or simply common people interested in rock physics. The physical properties, derived from pre-existing literature or newly measured, are density, porosity and permeability as well as seismic, magnetic, thermal and electrical properties. The data were collected on samples either from outcrops or from tunnels and boreholes. At present, data from literature have been collected extensively for density, porosity, seismic and thermal properties. In the past years, effort has been placed especially on collecting samples and measuring the physical properties of rock types that were poorly documented in literature. A workflow for quality control on reliability and completeness of the data was established. We made the attempt to quantify the variability and the uncertainty of the data. The database has been recently transferred to the Federal Office of Topography swisstopo with the aim to develop the necessary tools to query the database and open it to the public. Laboratory measurements are continuously collected, therefore the database is ongoing and in continuous development. The spatial distribution of the physical properties can be visualized as maps using simple GIS tools. Here the distribution of bulk density and velocity at room conditions are presented as examples of data representation; the methodology to produce these maps is described in detail. Moreover we also present an exemplification of the use of specific datasets, for which pressure and temperatures derivatives are available, to develop crustal models.ISSN:1661-8734ISSN:1661-872
Slab rollback orogeny in the Alps and evolution of the Swiss Molasse basin
The stratigraphies of foreland basins have been related to orogeny, where continentâcontinent collision causes the construction of topography and the downwarping of the foreland plate. These mechanisms have been inferred for the Molasse basin, stretching along the northern margin of the European Alps. Continuous flexural bending of the subducting European lithosphere as a consequence of topographic loads alone would imply that the Alpine topography would have increased at least between 30âMa and ca. 5â10âMa when the basin accumulated the erosional detritus. This, however, is neither consistent with observations nor with isostatic mass balancing models because paleoaltimetry estimates suggest that the topography has not increased since 20âMa. Here we show that a rollback mechanism for the European plate is capable of explaining the construction of thick sedimentary successions in the Molasse foreland basin where the extra slab load has maintained the Alpine surface at low, but constant, elevations
Slab rollback orogeny in the Alps and evolution of the Swiss Molasse basin
The stratigraphies of foreland basins have been related to orogeny, where continentâcontinent collision causes the construction of topography and the downwarping of the foreland plate. These mechanisms have been inferred for the Molasse basin, stretching along the northern margin of the European Alps. Continuous flexural bending of the subducting European lithosphere as a consequence of topographic loads alone would imply that the Alpine topography would have increased at least between 30âMa and ca. 5â10âMa when the basin accumulated the erosional detritus. This, however, is neither consistent with observations nor with isostatic mass balancing models because paleoaltimetry estimates suggest that the topography has not increased since 20âMa. Here we show that a rollback mechanism for the European plate is capable of explaining the construction of thick sedimentary successions in the Molasse foreland basin where the extra slab load has maintained the Alpine surface at low, but constant, elevations.ISSN:2041-172
Regional 3-D lithosphere structure of the northern half of Iran by local earthquake tomography
ISSN:0956-540XISSN:1365-246
Slab Load Controls Beneath the Alps on the Source-to-Sink Sedimentary Pathways in the Molasse Basin
The stratigraphic development of foreland basins has mainly been related to surface loading in the adjacent orogens, whereas the control of slab loads on these basins has received much less attention. This has also been the case for interpreting the relationships between the Oligocene to Micoene evolution of the European Alps and the North Alpine foreland basin or Molasse basin. In this trough, periods of rapid subsidence have generally been considered as a response to the growth of the Alpine topography, and thus to the construction of larger surface loads. However, such views conflict with observations where the surface growth in the Alps has been partly decoupled from the subsidence history in the basin. In addition, surface loads alone are not capable of explaining the contrasts in the stratigraphic development particularly between its central and eastern portions. Here, we present an alternative view on the evolution of the Molasse basin. We focus on the time interval between c. 30 and 15 Ma and relate the basin-scale development of this trough to the subduction processes, and thus to the development of slab loads beneath the European Alps. At 30 Ma, the western and central portions of this basin experienced a change from deep marine underfilled (Flysch stage) to overfilled terrestrial conditions (Molasse stage). During this time, however, a deep marine Flysch-type environment prevailed in the eastern part of the basin. This was also the final sedimentary sink as sediment was routed along the topographic axis from the western/central to the eastern part of this trough. We interpret the change from basin underfill to overfill in the western and central basin as a response to oceanic lithosphere slab-breakoff beneath the Central and Western Alps. This is considered to have resulted in a growth of the Alpine topography in these portions of the Alps, an increase in surface erosion and an augmentation in sediment supply to the basin, and thus in the observed change from basin underfill to overfill. In the eastern part of the basin, however, underfilled Flysch-type conditions prevailed until 20 Ma, and subsidence rates were higher than in the western and central parts. We interpret that high subsidence rates in the eastern Molasse occurred in response to slab loads beneath the Eastern Alps, where the subducted oceanic slab remained attached to the European plate and downwarped the plate in the East. Accordingly, in the central and western parts, the growth of the Alpine topography, the increase in sediment flux and the change from basin underfill to overfill most likely reflect the response to slab delamination beneath the Central Alps. In contrast, in the eastern part, the possibly subdued topography in the Eastern Alps, the low sediment flux and the maintenance of a deep marine Flysch-type basin records a situation where the oceanic slab was still attached to the European plate. The situation changed at 20 Ma, when the eastern part of the basin chronicled a change from deep marine (underfilled) to shallow marine and then terrestrial (overfilled conditions). During the same time, subsidence rates in the eastern basin decreased, deformation at the Alpine front came to a halt and sediment supply to the basin increased possibly in response to a growth of the topography in the Eastern Alps. This was also the time when the sediment routing in the basin axis changed from an east-directed sediment dispersal prior to 20 Ma, to a west-oriented sediment transport thereafter and thus to the opposite direction. We relate these changes to the occurrence of oceanic slab breakoff beneath the Eastern Alps, which most likely resulted in a rebound of the plate, a growth of the topography in the Eastern Alps and a larger sediment flux to the eastern portion of the basin. Beneath the Central and Western Alps, however, the continental lithosphere slab remained attached to the European plate, thereby resulting in a continued downwarping of the plate in its central and western portions. This plate downwarping beneath the central and western Molasse together with the rebound of the foreland plate in the East possibly explains the inversion of the drainage direction. We thus propose that slab loads beneath the Alps were presumably the most important drivers for the development of the Molasse basin at the basin scale.ISSN:2076-326
POLENET/LAPNET teleseismic P wave travel time tomography model of the upper mantle beneath northern Fennoscandia
The POLENET/LAPNET (Polar Earth Observing Network) broadband seismic network was deployed in northern Fennoscandia (Finland, Sweden, Norway, and Russia) during the third International Polar Year 2007â2009. The array consisted of roughly 60 seismic stations. In our study, we estimate the 3-D architecture of the upper mantle beneath the northern Fennoscandian Shield using high-resolution teleseismic P wave tomography. The P wave tomography method can complement previous studies in the area by efficiently mapping lateral velocity variations in the mantle. For this purpose 111 clearly recorded teleseismic events were selected and the data from the stations hand-picked and analysed. Our study reveals a highly heterogeneous lithospheric mantle beneath the northern Fennoscandian Shield though without any large high P wave velocity area that may indicate the presence of thick depleted lithospheric âkeelâ. The most significant feature seen in the velocity model is a large elongated negative velocity anomaly (up to â3.5%) in depth range 100â150km in the central part of our study area that can be followed down to a depth of 200km in some local areas. This low-velocity area separates three high-velocity regions corresponding to the cratonic units forming the area.ISSN:1869-9510ISSN:1869-952