24,098 research outputs found
Influence of disk leakage path on labyrinth seal inlet swirl ratio
The results of numerous investigators have shown the importance of labyrinth seal inlet swirl on the calculated dynamic stiffness of labyrinth seals. These results have not included any calculation of inlet leakage swirl as a function of geometry and sealing conditions of the given seal. This paper outlines a method of calculating the inlet swirl at a given seal by introducing a radial chamber to predict the gas swirl as it goes from the stage tip down to the seal location. For a centrifugal compressor, this amounts to including the flow path from the impeller discharge, down the back of the disk or front of the cover, then into the shaft seal or eye packing, respectively. The solution includes the friction factors of both the disk and stationary wall with account for mass flow rate and calculation of radial pressure gradients by a free vortex solution. The results of various configurations are discussed and comparisons made to other published results of disk swirl
Instabilities of geared couplings: Theory and practice
The use of couplings for high speed turbocompressors or pumps is essential to transmit power from the driver. Typical couplings are either of the lubricated gear or dry diaphragm type design. Gear couplings have been the standard design for many years and recent advances in power and speed requirements have pushed the standard design criteria to the limit. Recent test stand and field data on continuous lube gear type couplings have forced a closer examination of design tolerances and concepts to avoid operational instabilities. Two types of mechanical instabilities are reviewed in this paper: (1) entrapped fluid, and (2) gear mesh instability resulting in spacer throw-out onset. Test stand results of these types of instabilities and other directly related problems are presented together with criteria for proper coupling design to avoid these conditions. An additional test case discussed shows the importance of proper material selection and processing and what can happen to an otherwise good design
Negative Group Velocity
The group velocity for pulses in an optical medium can be negative at
frequencies between those of a pair of laser-pumped spectral lines. The gain
medium then can amplify the leading edge of a pulse resulting in a time advance
of the pulse when it exits the medium, as has been recently demonstrated in the
laboratory. This effect has been called superluminal, but, as a classical
analysis shows, it cannot result in signal propgation at speeds greater than
that of light in vacuum.Comment: v3 adds discussion of "rephasing", and adds a figure. v4 adds
references to the early history of negative group velocity, and adds a
figure; thanks to Alex Grani
Triton: A hot potato
The effect of sunlight on the surface of Triton was studied. Widely disparate models of the active geysers observed during Voyager 2 flyby were proposed, with a solar energy source almost their only feature. Yet Triton derives more of its heat from internal sources (energy released by the radioactive decay) than any other icy satellite. The effect of this relatively large internal heat on the observable behavior of volatiles on Triton's surface is investigated. The following subject areas are covered: the Global Energy Budget; insulation polar caps; effect on frost stability; mantle convection; and cryovolcanism
Multiple Media Interfaces for Music Therapy
This article describes interfaces (and the supporting technological infrastructure) to create audiovisual instruments for use in music therapy. In considering how the multidimensional nature of sound requires multidimensional input control, we propose a model to help designers manage the complex mapping between input devices and multiple media software. We also itemize a research agenda
The role of nonuniform internal heating in Triton's energy budget
Triton's large heliocentric distance and high albedo, combined with its unusually large silicate mass fraction, make internal heating more important in its energy budget than in that of any other icy satellite. Brown et al. have recently estimated that the average radiogenic heat flux (which is probably between 3.3 and 6.6 mW/sq m depending on core size and composition) may equal 5 to 20 pct. of the average absorbed insolation. On a global scale, this additional energy input appreciably increases the thermal emissivity required to be consistent with the observed surface temperature. Brown et al. also speculated that spatial variations of the internal flux may change the local sublimation deposition balance enough to lead to observable modifications of the distribution of volatiles on Triton's surface. An attempt is made to estimate the magnitude of internal heat flux variations due to the insulating effect of the polar caps, to mantle convection, and to cryovolcanism; the importance is evaluated of these variations in modifying the volatile distribution
Full load shop testing of 18,000-hp gas turbine driven centrifugal compressor for offshore platform service: Evaluation of rotor dynamics performance
The results for in-plant full load testing of a 13.4 MW (18000 HP) gas turbine driven centrifugal compressor are presented and compared to analytical predictions of compressor rotor stability. Unique problems from both oil seals and labyrinth gas seals were encountered during the testing. The successful resolution of these problems are summarized
- …