Effects on NOx and SO2 Emissions During Co-Firing of Coal with Woody Biomass in Air Staging and Reburning

Co-firing coal with different types of biomass is increasingly being applied in thermal power plants in Europe. The main motive for the use of biomass as the second fuel in coal-fired power plants is the reduction of CO2 emissions, and related financial benefits in accordance with the relevant International regulations and agreements. Likewise, the application of primary measures in the combustion chamber, which also includes air staging and/or reburning, results in a significant reduction in emission of polluting components of flue gases, in particular NOx emissions. In addition to being efficient and their application to new and future thermoblocks is practically unavoidable, their application and existing conventional combustion chamber does not require significant constructional interventions and is therefore relatively inexpensive. In this work results of experimental research of co-firing coals from Middle Bosnian basin with waste woody biomass are presented. Previously formed fuel test matrix is subjected to pulverized combustion under various temperatures and various technical and technological conditions. First of all it refers to the different mass ratio of fuel components in the mixture, the overall coefficient of excess air and to the application of air staging and/or reburning. Analysis of the emissions of components of the flue gases are presented and discussed. The impact of fuel composition and process temperature on the values of the emissions of components of the flue gas is determined. Additionally, it is shown that other primary measures in the combustion chamber are resulting in more or less positive effects in terms of reducing emissions of certain components of the flue gases into the environment. Thus, for example, the emission of NOx of 989 mg/ measured in conventional combustion, with the simultaneous application of air staging and reburning is reduced to 782 mg/, or by about 21%. The effects of the primary measures applied in the combustion chamber are compared and quantified with regard to conventional combustion of coals from Middle Bosnian basin.Article History: Received: November 5th 2017; Revised: Januari 6th 2018; Accepted: February 1st 2018; Available onlineHow to Cite This Article: Hodžić, N., Kazagić, A., and Metović, S. (2018) Experimental Investigation of Co-Firing of Coal with Woody Biomass in Air Staging and Reburning. International Journal of Renewable Energy Development, 7(1), 1-6.https://doi.org/10.14710/ijred.7.1.1-

Co-firing Bosnian coals with woody biomass: Experimental studies on a laboratory-scale furnace and 110 MWe power unit

This paper presents the findings of research into cofiring two Bosnian cola types, brown coal and lignite, with woody biomass, in this case spruce sawdust. The aim of the research was to find the optimal blend of coal and sawdust that may be substituted for 100% coal in large coal-fired power stations in Bosnia and Herzegovina. Two groups of experimental tests were performed in this study: laboratory testing of co-firing and trial runs on a large-scale plant based on the laboratory research results. A laboratory experiment was carried out in an electrically heated and entrained pulverized-fuel flow furnace. Coal-sawdust blends of 93:7% by weight and 80:20% by weight were tested. Co-firing trials were conducted over a range of the following process variables: process temperature, excess air ratio and air distribution. Neither of the two coal-sawdust blends used produced any significant ash-related problems provided the blend volume was 7% by weight sawdust and the process temperature did not exceed 1250ºC. It was observed that in addition to the nitrogen content in the co-fired blend, the volatile content and particle size distribution of the mixture also influenced the level of NOx emissions. The brown coal-sawdust blend generated a further reduction of SO2 due to the higher sulphur capture rate than for coal alone. Based on and following the laboratory research findings, a trial run was carried out in a large-scale utility - the Kakanj power station, Unit 5 (110 MWe), using two mixtures; one in which 5%/wt and one in which 7%/wt of brown coal was replaced with sawdust. Compared to a reference firing process with 100% coal, these co-firing trials produced a more intensive redistribution of the alkaline components in the slag in the melting chamber, with a consequential beneficial effect on the deposition of ash on the superheater surfaces of the boiler. The outcome of the tests confirms the feasibility of using 7%wt of sawdust in combination with coal without risk to the efficiency of the unit, its combustion process and with the benefits of emissions reductions. Furthermore, they show that no modification to the existing coal transport system and boiler equipment is necessary to achieve this outcome

Co-Combustion of Low-Rank Coal with Woody Biomass and Miscanthus: An Experimental Study

This paper presents a research on ash-related problems and emissions during co-firing low-rank Bosnian coals with different kinds of biomass; in this case woody sawdust and herbaceous energy crops Miscanthus. An entrained-flow drop tube furnace was used for the tests, varying fuel portions at a high co-firing ratio up to 30%wt woody sawdust and 10%wt Miscanthus in a fuel blend. The tests were supposed to optimize the process temperature, air distribution (including OFA) and fuel distributions (reburning) as function of SO2 and NOx emissions as well as efficiency of combustion process estimated through the ash deposits behaviors, CO emissions and unburnt. The results for 12 co-firing fuel combinations impose a reasonable expectation that the coal/biomass/Miscanthus blends could be successfully run under certain conditions not producing any serious ash-related problems. SO2 emissions were slightly higher when higher content of woody biomass was used. Oppositely, higher Miscanthus percentage in the fuel mix slightly decreases SO2 emissions. NOx emissions generally decrease with an increase of biomass co-firing rate. The study suggests that co-firing Bosnian coals with woody sawdust and Miscanthus shows promise at higher co-firing ratios for pulverized combustion, giving some directions for further works in co-firing similar multi-fuel combinations

Emissions of flue gas during pulverized combustion of coal and waste woody biomass

In this paper results of research of co-firing coals from Middle Bosnian basin with waste woody biomass are presented. The research was conducted in the laboratory at the Faculty of Mechanical Engineering in Sarajevo. Tested fuels were subjected to pulverized combustion under various temperatures and various technical and technological conditions: different mass ratio of fuel components in the mixture, different coefficient of excess air for combustion, classic and staged air supply, and fuel staged into the reaction zone. The results are related to the emission of flue gas components with respect to the technological conditions of combustion. In addition to the valorization of the influence of the primary fuel composition and process temperature on the emission values of the flue gas components, it has been shown that the application of primary measures in the combustion chamber results in lower or higher positive effects in terms of reducing the emissions of individual components -e.g. the NOx emission is reduced from 837 mg/mn3 in conventional combustion to 710 mg/mn3 using air staging, while during combustion with fuel staging, the NOx emission is reduced in proportion to the part of the fuel that is introduced into the reaction zone subsequently

Mapping the potential for decentralized energy generation based on RES in Western Balkans

Although the countries of the Western Balkans are mostly electrified, there are still regions which do not have access to the electricity network or where the network capacity is insufficient. For the most part such areas are under special care of the state (i.e. underdeveloped, devastated by war, depopulated), on islands or in mountainous regions. Since the decentralized energy generation covers a broad range of technologies, including many renewable energy technologies that provide small-scale power at sites close to the users, such concept could be of interest for these locations. This paper identfies the areas in Western Balkans where such systems could be applied Consideration is given to geographical locations as well as possible applications. Wind hydro, solar photovoltaic, and biomass conversion systems were taken into consideration. Since the renewable energy sources data for Western Balkans region are rather scarce, the intention was to give a survey of the present situation and an estimate of future polential for decentralized energy generation based on renewable energy sources. The decentralized energy generation based on renewable energy sources in Western Balkans will find its niche easier for the users that will produce electricity for their own needs and for the users located in remote rural areas (off-grid applications)