Not All Responses Are the Same: How CEO Cognitions Impact Strategy When Performance Falls Below Aspirations

This study integrates research on managerial discretion within the behavioral theory of the firm to examine how four CEO psychological traits serving as antecedents of managerial discretion—ambiguity tolerance, cognitive complexity, locus of control, and commitment to the status quo—moderate firm responses to poor performance. Using CEOs’ responses to questionnaires, CEO ambiguity tolerance is found to positively moderate the relationship between negative attainment discrepancy and strategic change when performance is slightly below aspirations, defined as average market return for the firm’s industry. Further, CEOs with greater cognitive complexity are found to engage in more strategic change when performance is farther below aspirations. Thus, this study begins to unpack the role of CEOs’ cognitive makeup on firm responses to performance shortfalls

Alloying of Surface Layers of the Fuel Claddings from Sponge Based E110 Alloy to Increase High Temperature Oxidation Resistance

The results of experiments of parts of cladding tubes from sponge based zirconium E110 alloy near-surface layers doping by means of ion-plasma technologies are presented in this paper. Alloying of material by method of pre-deposited Fe, Y, Mo, Al, Mg, Cr films ion mixing is performed on installation ILUR-03 by means of radialAr+ion beam 3-4 keV average energy. State of modified material layer and oxides, grown on the modified samples in argon-water steam mixture at 1200 ∘C studied by scanning electron and ion microscopy methods, X-ray analysis and secondary ion mass spectroscopy. It is shown that treating modes defined contribute to the barrier for oxygen penetration and material oxidation formation near ion-doped surface

Helium Porosity Formation in Vanadium Alloys of V-Ti-Cr, V-W-Zr and V-W-Ta Systems in Comparison with Binary Alloys

Vanadium alloys are considered candidates for use as structural materials of fusion reactors. A large amount of helium will be accumulated in such materials. The presence of helium in the materials may result in gas swelling. This paper presents the results on helium porosity formation researches in V–Ti–Cr, V–W–Zr and V–W–Ta alloys obtained by means of TEM. Samples were irradiated by 40 keV Не+ ions up to dose of 5 ⋅ 1020m−2 at 923 K. Alloy V–4%Ti–4%Cr has a smallest helium swelling among the ternary alloys and its swelling is significantly lower than swelling of dual V–Ti and V–Cr alloys. The swelling of the ternary V–2%W–1%Zr alloy is more than 3 times less than the swelling of vanadium, several times less than that of V–W alloys and slightly lower than the swelling of V– Zr alloys. Swelling increases by a factor of 1.5 with increasing of Zr content to 2% in the ternary V–2%W–1%Zr alloy. Similarly, gas swelling of ternary V–2%W–1%Ta alloy is significantly lower than that for binary V–W and V–Ta alloys. Assumptions are made about the possible mechanisms of the effect of alloying elements in vanadium on helium porosity formation. Keywords: vanadium alloys, swelling, helium, radiation resistance

Board Committees in Corporate Governance: A Cross-Disciplinary Review and Agenda for the Future

The importance of board committees – specialized subgroups that exist to perform many of the board\u27s most critical functions, such as setting executive compensation, identifying potential board members, and overseeing financial reporting – has grown over time due to increased legal requirements and greater complexity of the environment in which firms operate. This has resulted in a large body of work examining board committees across the accounting, finance, and management disciplines. However, this research has developed rather independently within each discipline, preventing scholars and practitioners from developing a comprehensive understanding of board committees. To address this issue, we conduct a comprehensive review of the literature that: 1) summarizes and synthesizes antecedents and outcomes associated with board committees in publicly-traded firms in English common law countries; and 2) offers a critical analysis of existing research, providing recommendations for advancements and new directions in board committee research

Behaviour of Ion-modified Cladding Tubes from E110 Alloy in High-temperature Water Steam

Beryllium materials are widely used in science and technology. They are of importance both for nuclear and thermonuclear energy applications. Additionally, metallic beryllium is transparent to x-ray radiation and used in the manufacture of X-ray windows and refractive x-ray lenses. SC “VNIINM” has developed beryllium materialsfor various purposes: for coating of the ITER’s first wall, for focusing and controlling X-ray radiation. Porous beryllium is of particular interest as it is an upcoming trend as a temper and neutron multiplier in blankets of thermonuclear facilities. A unique combination of X-ray optical properties also makes it possible to use porous beryllium in imaging devices in a synchrotron radiation beam (speckle suppressor)

Reflecting SDG 6.1 in rural water supply tariffs : considering 'affordability' versus 'operations and maintenance costs' in Malawi

Local tariffs in the form of household contributions are the primary financial mechanism to fund the maintenance of rural water supplies in Malawi. An investigation was conducted into the tariffs set by rural service providers to sustain drilled boreholes equipped with Afridev handpumps. A binary logistic regression analysis identified significant explanatory variables for the most common identified considerations when setting tariffs, ‘affordability’ and ‘operations and maintenance (O&M) costs’. The results demonstrate tariffs collected less frequently and usage above the design limit of the Afridev (300 users) had lower odds of considering affordability and higher odds of considering O&M costs, than those collected per month and within the design limit. The results further suggest a recognition by service providers of an increased maintenance challenge. High usage, acquiring spare parts, and the collection of tariffs when repairs are required indicate an increased likelihood of considering O&M costs, conversely to considering affordability. The balance of affordability and sustainable maintenance is a perpetual challenge under decentralised service delivery. Investment into ongoing support and supply chains is required for the financial and operational requirements of water supply, to ensure payments for services does not prevent access to clean water at the local level and to achieve the 2030 agenda

Wild pig removal reduces pathogenic bacteria in low-order streams

Invasive wild pig populations have undergone enormous increases in the United States and particularly across the southern U.S. in recent years. High fecundity rates and abilities to adapt quickly to varied habitats have enabled pig populations to become entrenched and difficult to eliminate. The pigs cause many negative impacts on ecosystems including degradation of water quality through infusion of fecal contamination and other non-point source pollutants. Our goal was to determine the effects of pig removal on water quality in streams that were known to be significantly polluted by pig activity Bolds (J Environ Qual 50: 441–453, 2021). We compared e. coli and fecal coliform concentrations and loads in streams between a pre-removal period with those that occurred during the removal activities. Results suggest that e. coli and fecal coliform concentrations were reduced by 75 and 50% respectively through pig removal efforts. Questions remain concerning the longevity of the reduction especially once pig removal activities decrease in intensity

Fate and transport of volatile organic compounds in glacial till and groundwater at an industrial site in Northern Ireland

Volatile organic compound (VOC) contamination of subsurface geological material and groundwater was discovered on the Nortel Monkstown industrial site, Belfast, Northern Ireland. The objectives of this study were to (1) investigate the characteristics of the geological material and its influences on contaminated groundwater flow across the site using borehole logs and hydrological evaluations, and (2) identify the contaminants and examine their distribution in the subsurface geological material and groundwater using chemical analysis. This report focuses on the eastern car park (ECP) which was a former storage area associated with trichloroethene (TCE) degreasing operations. This is where the greatest amount of volatile organic compounds (VOCs), particularly TCE, were detected. The study site is on a complex deposit of clayey glacial till with discontinuous coarser grained lenses, mainly silts, sands and gravel, which occur at 0.45-7.82 m below ground level (bgl). The lenses overall form an elongated formation that acts as a small unconfined shallow aquifer. There is a continuous low permeable stiff clayey till layer beneath the lenses that performs as an aquitard to the groundwater. Highest concentrations of VOCs, mainly TCE, in the geological material and groundwater are in these coarser lenses at similar to 4.5-7 m bgl. Highest TCE measurements at 390,000 mu g L-1 for groundwater and at 39,000 mu g kg(-1) at 5.7 m for geological material were in borehole GA19 in the coarse lens zone. It is assumed that TCE gained entrance to the subsurface near this borehole where the clayey till was thin to absent above coarse lenses which provided little retardation to the vertical migration of this dense non-aqueous phase liquid (DNAPL) into the groundwater. However, TCE is present in low concentrations in the geological material overlying the coarse lens zone. Additionally, VOCs appear to be associated with poorly drained layers and in peat < 3.0 m bgl in the ECP. Some indication of natural attenuation as VOCs degradation products vinyl chloride (VC) and dichloromethane (DCM) also occur on the site