Effect of sterilization by gamma radiation on nano-mechanical properties of teeth

NOTICE: this is the author’s version of a work that was accepted for publication in Dental Materials. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Dental Materials, [VOL 24, ISSUE 8, (2008)] DOI: 10.1016/j.dental.2008.02.016.Objectives: Extracted teeth used in dental research need to be considered infective and hence be sterilized without the materials' properties being altered. This study examined the effect of gamma radiation on the nano-mechanical properties of dentin and enamel of extracted human third molars. Methods: Whole teeth were sterilized using gamma radiation doses of 7kGy and 35kGy, respectively; teeth of the control group were not treated with gamma radiation. Crowns were sectioned occlusally and polished. Elastic modulus and hardness were tested using atomic force microscopy with nano-indentations under wet conditions. Results: The authors found no significant dose-response relationship in elastic modulus or hardness in either dentin or enamel. Significance: Nano-indentation is a common technique for the determination of local mechanical properties in biological hard tissues. Gamma radiation is an efficient way to sterilize extracted teeth while alteration of dentin and enamel mechanical properties are minimized

Spectrum of the Intensity of Modulated Noisy Light After Propagation in Dispersive Fiber

The spectral density of the optical intensity which results after modulated noisy light is propagated in dispersive single-mode fiber is investigated theoretically and experimentally. An exact general result is obtained for the case of lowest-order-only group velocity dispersion and is applied to light from a 1550-nm distributed-feedback semiconductor laser which is large-signal phase modulated and then propagated through 50 km of standard single-mode fiber. Experimental results demonstrate the effect of dispersion on the intensity spectrum (and thus, on lightwave system characteristics such as modulation response, relative intensity noise, carrier-to-noise ratio, and harmonic distortion) in this situation and provide confirmation of the theoretical results

Performance of efficient Q-switched diode-laser-pumped Nd:YAG and Ho:YLF lasers for space applications

Solid-state lasers pumped by continuous-wave diode lasers can be Q-switched to obtain high peak power output pulses. The dependence of laser-pulse energy, average output power, peak power, and pulse width on pulse-repetition frequency in Q-switched Nd:YAG and Ho:YLF lasers is determined and compared. At low pulse repetition rates, the much longer upper-stage lifetime in Ho:YLF gives a distinct advantage. At higher pulse rates, the overall laser efficiency and the stimulated emission cross section are more important parameters, leading to an advantage for Nd:YAG. The results are of significance for designing lasers for use in space optical communications and remote sensing systems

Laser phase noise to intensity noise conversion by lowest-order group-velocity dispersion in optical fiber: exact theory

An exact result for the spectral density of intensity variations that occur after propagation of ergodic light in a medium having lowest-order-only group-velocity dispersion is obtained and applied to the problem of semiconductor laser phase noise to intensity noise conversion in a single-mode optical fiber. It is shown that the intensity spectrum after propagation formally approaches, for a large laser linewidth or a long (or high-dispersion) fiber, the intensity spectrum of a thermal source having the same line shape as the laser

Precise measurement of semiconductor laser chirp using effect of propagation in dispersive fiber and application to simulation of transmission through fiber gratings

Measurements of small-signal intensity modulation from direct-modulated distributed feedback (DFB) semiconductor lasers after propagation in dispersive fiber have previously been used to extract intrinsic laser chirp parameters such as linewidth enhancement factor and crossover frequency. Here, we demonstrate that the simple rate equations do not satisfactorily account for the frequency response of real DFB lasers and describe some experimental techniques that conveniently determiner the precise laser chirp. Implications for simulation of high-speed lightwave systems are also considered

Reduction of relative intensity noise of the output field of semiconductor lasers due to propagation in dispersive optical fiber

The effect of dispersive, linear propagation (e.g., in single-mode optical fiber) on the intensity noise from semiconductor lasers is investigated. Relations between the frequency and amplitude noise variations of semiconductor lasers are obtained from the laser rate equations and used to calculate the change in the relative intensity noise (RIN) spectrum that occurs during dispersive propagation. Propagation in fiber with positive dispersion (D>0) over moderate distances (several km for standard single-mode fiber at 1.55 mu m) is found to reduce the RIN over a wide range of frequencies. Measurements with a 1.56 mu m distributed feedback laser confirm the main theoretical results and demonstrate reductions in RIN of up to II dB with 4 km of standard fiber

Use of ordination and classification procedures to evaluate phytoplankton communities during Superflux II

Cluster analysis and an ordination procedure were performed on two data matrices to investigate real and environmental spatial relationships. Multiple regression analysis was used to relate the measured environmental variables to the phytoplankton community changes. Qualitative type phytoplankton data proved to be less structured in both of these spaces, relative to the biomass data. The salinity gradients of the northern transects covaried significantly with the phytoplankton association changes. In the southern transects the light variable was most important in explaining the variance in the ordination axes. These data suggest the close relationships between phytoplankton community changes and the physical hydrology of the area

A simple method for designing or analyzing an optical communication link

A simple method is described for determining the performance of a free space optical communication link. The method can be used either in the system design (synthesis) mode or in the performance evaluation (analysis) mode. Although restricted to photo counting based detection of pulse position modulated signals, the method is still sufficiently general to accommodate space-based, as well as ground-based, reception

Dependence of volume FEL (VFEL) threshold conditions on undulator parameters

The idea and principles of volume free electron lasers were proposed in [1-4]. It was shown there that volume distributed feedback (VDFB) can essentially reduce the threshold current of generation and provide the possibility of smooth frequency tuning. The present work considers an undulator VFEL with multiwave VDFB. It is shown that dependence of threshold current on the interaction length changes in the point of roots degeneration. This leads to the sharp decrease of start current if condition of dynamical diffraction is fulfilled. The dependence of amplification coefficient changes, too. So the interaction length for generation appears shorter. The proposed scheme can be used for generation in wide spectral range from microwaves to X-rays. The operating features of undulator VFEL is considered.Comment: Latex, 6 pages with 2 Postscript figure