35,207 research outputs found
Scalable squeezed light source for continuous variable quantum sampling
We propose a novel squeezed light source capable of meeting the stringent
requirements of continuous variable quantum sampling. Using the effective
interaction induced by a strong driving beam in the presence of the
response in an integrated microresonator, our device is compatible
with established nanophotonic fabrication platforms. With typical realistic
parameters, squeezed states with a mean photon number of 10 or higher can be
generated in a single consistent temporal mode at repetition rates in excess of
100MHz. Over 15dB of squeezing is achievable in existing ultra-low loss
platforms
A re-evaluation of finite-element models and stress-intensity factors for surface cracks emanating from stress concentrations
A re-evaluation of the 3-D finite-element models and methods used to analyze surface crack at stress concentrations is presented. Previous finite-element models used by Raju and Newman for surface and corner cracks at holes were shown to have ill-shaped elements at the intersection of the hole and crack boundaries. These ill-shaped elements tended to make the model too stiff and, hence, gave lower stress-intensity factors near the hole-crack intersection than models without these elements. Improved models, without these ill-shaped elements, were developed for a surface crack at a circular hole and at a semi-circular edge notch. Stress-intensity factors were calculated by both the nodal-force and virtual-crack-closure methods. Both methods and different models gave essentially the same results. Comparisons made between the previously developed stress-intensity factor equations and the results from the improved models agreed well except for configurations with large notch-radii-to-plate-thickness ratios. Stress-intensity factors for a semi-elliptical surface crack located at the center of a semi-circular edge notch in a plate subjected to remote tensile loadings were calculated using the improved models. The ratio of crack depth to crack length ranged form 0.4 to 2; the ratio of crack depth to plate thickness ranged from 0.2 to 0.8; and the ratio of notch radius to the plate thickness ranged from 1 to 3. The models had about 15,000 degrees-of-freedom. Stress-intensity factors were calculated by using the nodal-force method
- …