Impact of liquid metal surface on plasma-surface interaction in experiments with lithium and tin capillary porous systems

The lithium and tin capillary-porous systems (CPSs) were tested with steady-state plasma in the PLM plasma device which is the divertor simulator with plasma parameters relevant to divertor and SOL plasma of tokamaks. The CPS consists of tin/lithium tile fixed between two molybdenum meshs constructed in the module faced to plasma. Steady-state plasma load of 0.1 - 1 MW/m(2) on the CPS during more than 200 min was achieved in experiments on PLM which is a modeling far scrapeoff- layer and far zone of divertor plasma of a large tokamak. The heating of the CPS was controlled remotely including biasing technique which allows to regulate evaporated metal influx to plasma. After exposure, the materials of the tin and lithium CPSs were inspected and analyzed with optic and scanning electron micriscopy. Experiments have demonstrated sustainability of the tin and lithium CPSs to the high heat steady state plasma load expected in a large scale tokamak. The effect of evaporated lithium and tin on the plasma transport/radiation was studied with spectroscopy to evaluate changes of plasma properties and plasma-surface interaction

Power handling of a liquid-metal based CPS structure under high steady-state heat and particle fluxes

Liquid metal infused capillary porous structures (CPSs) are considered as a potential divertor solution for DEMO due to their potential power handling capability and resilience to long term damage. In this work the power handling and performance of such Sn-based CPS systems is assessed both experimentally and via modelling. A Sn-CPS target was exposed to heat fluxes of up to 18.1 MW m−2 in He plasma in the Pilot-PSI linear device. Post-mortem the target showed no damage to nor any surface exposure of the underlying W-CPS felt. The small pore size (∼40 µm) employed resulted in no droplet formation from the target in agreement with calculated Rayleigh-Taylor and Kelvin-Helmoholtz instability thresholds. The temperature response of the Sn-target was used to determine the thermal conductivity of the mixed Sn-CPS material using COMSOL modelling. These values were then used via further finite element analysis to extrapolate to DEMO relevant monoblock designs and estimate the maximum power handling achievable based on estimated temperature windows for all component elements of the design. For an optimized design a heat-load of up to 20 MW m−2 may be received while the use of CPS also offers other potential design advantages such as the removal of interlayer requirements

Predictive modelling of liquid metal divertor : from COMPASS tokamak towards Upgrade

Following ELMy H-mode experiments with liquid metal divertor target on the COMPASS tokamak, we predict the behavior of a similar target on COMPASS Upgrade, where it will be exposed to surface heat fluxes even higher than those expected in the future EU DEMO attached divertor. We simulate the heat conduction, sputtering, evaporation, excitation and radiation of lithium and tin in the divertor area. Measured high-resolution data from COMPASS tokamak were rescaled towards the Upgrade based on many established scalings. Our simulation then yields the amount of released metal which ranges from 4 mg s(-1) upto 12 g s(-1) depending mainly on the geometry and Li/Sn choice, quite independently from active cooling or strike point sweeping