104,189 research outputs found

    Swirl can primary combustor

    Get PDF
    A swirl can full annulus combustor, operable over a wide range of exit average temperatures is used in a high performance gas turbine engine for advanced aircraft. A large number of swirl can modules are mounted in an array in each combustor

    Nucleonic coal detector with independent, hydropneumatic suspension

    Get PDF
    The design of a nucleonic, coal interface detector which measures the depth of coal on the roof and floor of a coal mine is presented. The nucleonic source and the nucleonic detector are on independent hydropneumatic suspensions to reduce the measurement errors due to air gap

    Dynamic analysis of a long span, cable-stayed freeway bridge using NASTRAN

    Get PDF
    The dynamic analysis for earthquake- and wind-induced response of a long span, cable-stayed freeway bridge by NASTRAN in conjunction with post-processors is described. Details of the structural modeling, the input data generation, and numerical results are given. The influence of the dynamic analysis on the bridge design is traced from the project initiation to the development of a successful earthquake and wind resistant configuration

    Coal-rock interface detector

    Get PDF
    A coal-rock interface detector is presented which employs a radioactive source and radiation sensor. The source and sensor are separately and independently suspended and positioned against a mine surface of hydraulic pistons, which are biased from an air cushioned source of pressurized hydraulic fluid

    The experimental clean combustor program: Description and status

    Get PDF
    The objectives, program plan, schedule, pollution and performance goals, program approaches to pollution reduction, and status of the project are presented. Advanced supersonic transport and combustion noise programs are also discussed. The phases of the program consist of the following: (1) screening of low pollutant combustors, (2) refinement of the best combustors, and (3) engine demonstration of the best combustors. It is stated that all combustor designs investigated appear capable of achieving the idle pollutant goals with additional development effort

    Experimental Investigation of a Constant-Velocity Traveling Magnetic Wave Plasma Engine

    Get PDF
    The previously reported traveling magnetic wave plasma engine has been redesigned to reduce the high heat loss to the tube walls downstream of the last magnetic-field coil. The present configuration uses a 3-inch-diameter pyrex tube flared out to a 6-inch diameter immediately downstream of the last magnetic-field coil. This configuration has been studied to determine the effects of flared-tube geometry, molecular weight of the propellant, engine length, and use of a ferrite core on the engine performance. Argon and xenon gases were used as propellants. Two engine lengths were tested. One engine was nominally 1-magnetic-wavelength long (4 coils) and the other nominally 2 1/2-magnetic wavelengths long (10 coils). The magnetic wave speed for both of these lengths corresponds to a specific impulse of 4750 seconds. The maximum kinetic efficiency of the 4-coil engine was 10 percent at a specific impulse of 3200 seconds using argon gas and 22.5 percent at 4200 seconds using xenon gas as the propellant

    Vibrational characteristics of linear space frames

    Get PDF
    Digital computer program for determining modes and frequencies of arbitrary linear space frame

    User's guide: SPAR processor MN analysis of inelastic three-dimensional solids, part 2

    Get PDF
    A user's guide to the processor MN is presented. The processor MN is used to analyze systems in which some or all of the three dimensional elements have nonlinear stress-strain relations. Representations of nonlinear material behavior implemented into the system are provided including Von Mises yield criterion, the Prandtl-Reuss flow rule, and the mechanical sublayer method. The primary data sets used to represent the state of the system are presented

    Snap dynamics

    Get PDF
    Computer program calculates normal vibration modes of complex structures elimating excessively large amounts of input data, run time, and core storage. Provision for accuracy improvement is also included
    corecore