52 research outputs found

    Outcomes from elective colorectal cancer surgery during the SARS-CoV-2 pandemic

    Get PDF
    This study aimed to describe the change in surgical practice and the impact of SARS-CoV-2 on mortality after surgical resection of colorectal cancer during the initial phases of the SARS-CoV-2 pandemic

    Global commitment towards sustainable energy

    Get PDF
    Energy is crucial to economic and social development and improves quality of life. However, fossil fuel energy produces greenhouse gases (GHGs) and cannot be sustained for a long time. It is essential to tackle these problems by moving towards renewable and sustainable energy. Some countries, including those in the Arabian Gulf region, are still in the appraisal stage of adopting different forms of renewable energy. This paper reviews the business potential and likely GHG reductions associated with adopting renewable energy in Oman. It is revealed that 1·9 Mt of annual carbon dioxide emissions could be cut by producing 10% of the country’s electricity from renewables. The paper further discusses the global sustainable energy commitment under the UN Framework Convention on Climate Change and reviews the 2030 targets of some countries that are high producers of GHGs. It is anticipated that if all these planned targets are achieved, the total sustainable energy contribution could grow by nearly 11 000 TWh by 2030. These plans provide guidance for those countries still preparing to submit their plans to the UN

    Damage sequence and safety margin assessment of expansion joints by shake table testing

    Get PDF
    The performance of nonstructural components has attracted attention, and previous large earthquakes have resulted in widespread damage to expansion joints. In contrast to the main structural components, for which ductility beyond the design tolerance is ensured, the safety margin of nonstructural components classified as the product of mechanical engineering, such as expansion joints, is uncertain. This paper investigates the damage sequence and safety margin of expansion joints through shake table testing. The expansion joints were installed to connect 2 rigid steel frames with short and long natural periods. Four commonly used types, high‐performance and standard‐performance floor and wall expansion joints, were tested. Seven damage patterns of the 4 expansion joints were observed, and most of the damage patterns were considered displacement dependent. The damage mechanisms and relative displacements at the moment of damage were identified by using strain gauges attached near collision and damage locations. The high‐performance expansion joints showed only minor damage beyond the design motion range, whereas the standard‐performance expansion joints exhibited minor damage below the design motion range and failure at the design motion range or slightly beyond. For each damage state, repair information was obtained through a questionnaire to an expansion joint manufacturer, and the sum of the initial cost and repair cost for high‐performance and standard‐performance expansion joints was compared. The results will be useful for the selection of expansion joints in the design process
    • 

    corecore