241 research outputs found
Microstructural strain energy of α-uranium determined by calorimetry and neutron diffractometry
The microstructural contribution to the heat capacity of α-uranium was determined by measuring the heat-capacity difference between polycrystalline and single-crystal samples from 77 to 320 K. When cooled to 77 K and then heated to about 280 K, the uranium microstructure released (3±1) J/mol of strain energy. On further heating to 300 K, the microstructure absorbed energy as it began to redevelop microstrains. Anisotropic strain-broadening parameters were extracted from neutron-diffraction measurements on polycrystals. Combining the strain-broadening parameters with anisotropic elastic constants from the literature, the microstructural strain energy is predicted in the two limiting cases of statistically isotropic stress and statistically isotropic strain. The result calculated in the limit of statistically isotropic stress was (3.7±0.5) J/mol K at 77 K and (1±0.5) J/mol at room temperature. In the limit of statistically isotropic strain, the values were (7.8±0.5) J/mol K at 77 K and (4.5±0.5) J/mol at room temperature. In both cases the changes in the microstructural strain energy showed good agreement with the calorimetry
Recommended from our members
The effects of beryllium additions on the oxidation of nickel aluminide and titanium aluminide based intermetallics
The effects of Be additions on the oxidation behavior of {beta}-NiAl in moist air at 1,000 C and borderline alumina-forming {gamma} (TiAl) + Laves Ti-Al-Cr based alloys at 800 C and 1,000 C in dry and moist air were investigated. The addition of Be to {beta}-NiAl suppressed the formation of transient alumina, and resulted in the formation of a protective BeAl{sub 2}O{sub 4} spinel phase. In dry air, the addition of Be to the Ti-Al-Cr alloys also resulted in the formation of a protective BeAl{sub 2}O{sub 4} spinel phase. In moist air, only Ti-Al-Cr-Be alloys with a high Cr content (10 to 15 a/o) formed the protective BeAl{sub 2}O{sub 4} scale
Recommended from our members
Measurements of the diffusion of iron and carbon in single crystal NiAl using ion implantation and secondary ion mass spectrometry
Classical diffusion measurements in intermetallic compounds are often complicated by low diffusivities or low solubilities of the elements of interest. Using secondary ion mass spectrometry for measurements over a relatively shallow spatial range may be used to solve the problem of low diffusivity. In order to simultaneously obtain measurements on important impurity elements with low solubilities, the authors have used ion implantation to supersaturate a narrow layer near the surface. Single crystal NiAl was implanted with either {sup 12}C or both {sup 56}Fe and {sup 12}C in order to investigate the measurement of substitutional (Fe) versus interstitial (C) tracer diffusion and the cross effect of both substitutional and interstitial diffusion. When C alone was implanted negligible diffusion was observed over the range of times and temperatures investigated. When both Fe and C were implanted together significantly enhanced diffusion of the C was observed, which is apparently associated with the movement of Fe. This supports one theory of dynamic strain aging in Fe alloys NiAl
Recommended from our members
The influence of surface morphology and oxide microstructure on the nucleation and growth of uranium hydride on alpha uranium
While the bulk kinetics of the uranium-hydrogen reaction are well understood, the mechanisms underlying the initial nucleation of uranium hydride on uranium remain controversial. In this study, the authors have employed environmental cell optical microscopy, Scanning Electron Microscopy (SEM) and Atomic Force Microscopy, (AFM) in an attempt to relate the structure of the surface and the microstructure of the substrate with the susceptibility and site of hydride nucleation. Samples have been investigated with varying grain size, inclusion (carbide) concentration, and thermal history. There is a clear correlation to heat treatment immediately prior to hydrogen exposure. Susceptibility to hydride formation also appears to be related to impurities in the uranium. The oxidized surface is very complex, exhibiting wide variations in thickness and topography between samples, between grains in the same sample, and within individual grains. It is, however, very difficult to relate this fine scale variability to the relatively sparse hydride initiation sites. Therefore, the surface oxide layer itself does not appear to control the sites where hydride attack is initiated, although it must play a role in the induction period prior to hydride initiation
The Influence of Surface Morphology and Oxide Microstructure on the Nucleation and Growth of Uranium Hydride on Alpha Uranium
While the bulk kinetics of the uranium-hydrogen reaction are well understood, the mechanisms underlying the initial nucleation of uranium hydride on uranium remain controversial. In this study, the authors have employed environmental cell optical microscopy, Scanning Electron Microscopy (SEM) and Atomic Force Microscopy, (AFM) in an attempt to relate the structure of the surface and the microstructure of the substrate with the susceptibility and site of hydride nucleation. Samples have been investigated with varying grain size, inclusion (carbide) concentration, and thermal history. There is a clear correlation to heat treatment immediately prior to hydrogen exposure. Susceptibility to hydride formation also appears to be related to impurities in the uranium. The oxidized surface is very complex, exhibiting wide variations in thickness and topography between samples, between grains in the same sample, and within individual grains. It is, however, very difficult to relate this fine scale variability to the relatively sparse hydride initiation sites. Therefore, the surface oxide layer itself does not appear to control the sites where hydride attack is initiated, although it must play a role in the induction period prior to hydride initiation
Recommended from our members
A study of nitride formation during the oxidation of titanium-tantalum alloys
The oxidation rates of Ti rich titanium-tantalum alloys are significantly lower in air than in oxygen. This nitrogen effect has been shown to be associated with the formation of a nitride layer at or near the scale-metal interface. In the present work the authors used transmission electron microscopy and microdiffraction to identify the nitrides formed on Ti5Ta and Ti40Ta (5 and 40 weight percent Ta alloys) during identical exposures. In both alloys the nitride develops in contact with the oxygen stabilized {alpha}-phase in the substrate. In Ti5Ta a continuous layer of TiN forms, while in Ti40Ta a discontinuous layer of Ti{sub 2}N interspersed with Ta{sub 2}O{sub 5} (formed from the Ta rich {beta}-phase) is formed. The nitride layer acts as an oxygen diffusion barrier, reducing the dissolution of oxygen in the substrate
The roles of herbal remedies in survival and quality of life among long-term breast cancer survivors - results of a prospective study
<p>Abstract</p> <p>Background</p> <p>Few data exist on survival or health-related quality of life (QOL) related to herbal remedy use among long-term breast cancer survivors. The objective of this report is to examine whether herbal remedy use is associated with survival or the health-related QOL of these long-term breast cancer survivors.</p> <p>Methods</p> <p>In 1999-2000, we collected the information of herbal remedy use and QOL during a telephone interview with 371 Los Angeles Non-Hispanic/Hispanic white women who had survived more than 10 years after breast cancer diagnosis. QOL was measured using the Medical Outcomes Study Short Form-36 (SF-36) questionnaire. Patients were followed for mortality from the baseline interview through 2007. 299 surviving patients completed a second telephone interview on QOL in 2002-2004. We used multivariable Cox proportional hazards methods to estimate relative risks (RR) and 95% confidence intervals (CI) for mortality and applied multivariable linear regression models to compare average SF-36 change scores (follow-up - baseline) between herbal remedy users and non-users.</p> <p>Results</p> <p>Fifty-nine percent of participants were herbal remedy users at baseline. The most commonly used herbal remedies were echinacea, herbal teas, and ginko biloba. Herbal remedy use was associated with non-statistically significant increases in the risks for all-cause (44 deaths, RR = 1.28, 95% CI = 0.62-2.64) and breast cancer (33 deaths, RR = 1.78, 95% CI = 0.72-4.40) mortality. Both herbal remedy users' and non-users' mental component summary scores on the SF-36 increased similarly from the first survey to the second survey (<it>P </it>= 0.16), but herbal remedy users' physical component summary scores decreased more than those of non-users (-5.7 vs. -3.2, <it>P </it>= 0.02).</p> <p>Conclusions</p> <p>Our data provide some evidence that herbal remedy use is associated with poorer survival and a poorer physical component score for health-related QOL among women who have survived breast cancer for at least 10 years. These conclusions are based on exploratory analyses of data from a prospective study using two-sided statistical tests with no correction for multiple testing and are limited by few deaths for mortality analysis and lack of information on when herbal remedy use was initiated or duration of or reasons for use.</p
- …