2,615 research outputs found
Redundant actuating mechanism Patent
Design and development of release mechanism for spacecraft components, releasable despin weights, and extensible gravity boom
Transfer molding of PMR-15 polyimide resin
Transfer molding is an economically viable method of producing small shapes of PMR-15 polyimide. It is shown that with regard to flexural, compressive, and tribological properties transfer-molded PMR-15 polyimide is essentially equivalent to PMR-15 polyimide produced by the more common method of compression molding. Minor variations in anisotropy are predictable effects of molding design and secondary finishing operations
Effect of filtration on rolling-element-bearing life in contaminated lubricant environment
Fatigue tests were conducted on groups of 65 millimeter-bore ball bearings under four levels of filtration with and without a contaminated MIL-L-23699 lubricant. The baseline series used noncontaminated oil with 49 micron absolute filtration. In the remaining tests contaminants of the composition found in aircraft engine filters were injected into the filter's supply line at a constant rate of 125 milligrams per bearing-hour. The test filters had absolute particle removal ratings of 3, 30, 49, and 105 microns (0.45, 10, 30, and 70 microns nominal), respectively. Bearings were tested at 15,000 rpm under 4580 newtons radial load. Bearing life and running tract condition generally improved with finer filtration. The 3 and 30 micron filter bearings in a contaminated lubricant had statistically equivalent lives, approaching those from the baseline tests. The experimental lives of 49 micron bearings were approximately half the baseline bearing's lives. Bearings tested with the 105 micron filter experienced wear failures. The degree of surface distress, weight loss, and probable failure mode were found to be dependent on filtration level, with finer filtration being clearly beneficial
Including Legumes in Bermudagrass Pastures
Use of legumes in bermudagrass pastures did not affect summer cow gains in 2016. Forage availability was also similar where ladino clover was used in the Legume system compared with where Nitrogen (N) alone was used. Estimated forage crude protein (CP) was greater for the Legume than the Nitrogen system in early summer, but was similar by mid-summer
Effects of Cultivar and Distillers Grains Supplementation on Grazing and Subsequent Finishing Performance of Stocker Steers Grazing Tall Fescue Pasture
Four hundred thirty-two yearling steers grazing tall fescue pastures were used to evaluate the effects of fescue cultivar and dried distillers grains (DDG) supplementation during the grazing phase on available forage, grazing gains, subsequent finishing gains, and carcass characteristics. Fescue cultivars evaluated were high-endophyte ‘Kentucky 31’ and low-endophyte ‘Kentucky 31,’ ‘HM4,’ and ‘MaxQ.’ Steers were either fed no supplement or were supplemented with DDG at 1.0% body weight per head daily in 2009 or 0.75% of body weight per head daily in 2010, 2011, 2012, 2013, and 2014 while grazing. Steers that grazed pastures of low-endophyte ‘Kentucky 31,’ ‘HM4,’ or ‘MaxQ’ gained significantly more (P \u3c 0.05) and produced more (P \u3c 0.05) gain/a than those that grazed high-endophyte ‘Kentucky 31’ pastures. Gains of cattle that grazed low-endophyte ‘Kentucky 31,’ ‘HM4,’ or ‘MaxQ’ were similar (P \u3e 0.05). Subsequent finishing gains were similar (P \u3e 0.05) among fescue cultivars in 2009, 2012, 2013, and 2014; however, steers that previously grazed high-endophyte ‘Kentucky 31’ had greater (P \u3e 0.05) finishing gains than those that had grazed ‘HM4’ or ‘MaxQ’ in 2010 and greater (P \u3c 0.05) finishing gains than those that grazed low-endophyte ‘Kentucky 31’ or ‘HM4’ in 2011. Supplementation of grazing steers with DDG supported a higher stocking rate and resulted in greater (P \u3c 0.05) grazing gain, gain/a, and overall daily gain and reduced the amount of fertilizer needed by providing approximately 60 lb/a, 50 lb/a, 50 lb/a, 30 lb/a, 40 lb/a, and 40 lb/a of nitrogen (N) in 2009, 2010, 2011, 2012, 2013, and 2014, respectively, primarily from urine of grazing cattle
Effects of Supplementation with Corn or Dried Distillers Grains on Gains of Heifer Calves Grazing Smooth Bromegrass Pastures
Thirty heifer calves grazing smooth bromegrass pastures were used to compare supplementation with 0.5% of body weight per head daily of corn or dried distillers grains (DDG). Daily gains of heifers supplemented with corn or DDG were similar (P \u3e 0.05)
Effects of Interseeding Ladino Clover into Tall Fescue Pastures of Varying Endophyte Status on Grazing Performance of Stocker Steers
Sixty-four yearling steers grazing tall fescue pastures were used to evaluate the effects of fescue cultivar and interseeding ladino clover on grazing gains and available forage. Fescue cultivars evaluated were high-endophyte ‘Kentucky 31,’ low-endophyte ‘Kentucky 31,’ ‘HM4,’ and ‘MaxQ.’ Steers that grazed pastures of low-endophyte ‘Kentucky 31,’ ‘HM4,’ or ‘MaxQ’ gained significantly more (P \u3c 0.05) and produced more (P \u3c 0.05) gain/a than those that grazed high-endophyte ‘Kentucky 31’ pastures. Gains of cattle that grazed low-endophyte ‘Kentucky 31,’ ‘HM4,’ or ‘MaxQ’ were similar (P \u3e 0.05). High-endophyte ‘Kentucky 31’ pastures had more (P \u3c 0.05) available forage than lowendophyte ‘Kentucky 31,’ ‘HM4,’ or ‘MaxQ’ pastures
Effects of Various Grazing Systems on Grazing and Subsequent Finishing Performance
A total of 400 mixed black yearling steers were used to compare grazing and subsequent finishing performance from pastures with ‘MaxQ’ tall fescue, a wheat-bermudagrass double-crop system, or a wheat-crabgrass double-crop system in 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, and 2019. Daily gains of steers that grazed MaxQ fescue, wheat-bermudagrass, or wheat-crabgrass were similar (P \u3e 0.05) in 2010, 2016, 2017, and 2018. Daily gains of steers that grazed wheat-bermudagrass or wheat-crabgrass were greater (P \u3e 0.05) than those that grazed MaxQ fescue in 2011, 2012, and 2019. Daily gains of steers that grazed wheat-crabgrass were greater (P \u3e 0.05) than those that grazed wheat-bermudagrass and similar (P \u3e 0.05) to those that grazed MaxQ fescue in 2013. Daily gains of steers that grazed wheat-crabgrass were greater (P \u3e 0.05) than those that grazed wheat-bermudagrass or ‘Max Q’ fescue in 2014. In 2015, daily gains of steers that grazed wheat-crabgrass were greater (P \u3c 0.05) than those that grazed wheat-bermudagrass or Max Q fescue and daily gain of steers grazing wheat-bermudagrass was greater (P \u3c 0.05) than that of those that grazed MaxQ fescue. Finishing gains were similar (P \u3e 0.05) among forage systems in 2010, 2012, 2013, 2014, 2016, and 2018. Finishing gains of steers that grazed MaxQ fescue were greater (P \u3c 0.05) than those that grazed wheat-bermudagrass in 2011 and greater (P \u3c 0.05) than those that grazed wheat-bermudagrass or wheat-crabgrass in 2015. In 2017, finishing gains of steers that grazed wheat-crabgrass were greater (P \u3c 0.05) than those that grazed MaxQ fescue
Effects of Various Forage Systems on Grazing and Subsequent Finishing Performance
A total of 200 mixed black yearling steers were used to compare grazing and subsequent finishing performance from pastures with ‘MaxQ’ tall fescue, a wheat-bermudagrass double-crop system, or a wheat-crabgrass double-crop system in 2010, 2011, 2012, 2013, and 2014. Daily gains of steers that grazed ‘MaxQ’ tall fescue, wheat-bermudagrass, or wheat-crabgrass were similar (P \u3e 0.05) in 2010, daily gains of steers that grazed wheat-bermudagrass or wheat-crabgrass were greater (P \u3e 0.05) than those that grazed ‘MaxQ’ tall fescue in 2011 and 2012, daily gains of steers that grazed wheat-crabgrass were greater (P \u3e 0.05) than those that grazed wheat-bermudagrass and similar (P \u3e 0.05) to those that grazed ‘MaxQ’ fescue in 2013, and daily gains of steers that grazed wheat-crabgrass were greater (P \u3e 0.05) than those that grazed wheat-bermudagrass or ‘MaxQ’ fescue in 2014. Finishing gains were similar (P \u3e 0.05) among forage systems in 2010, 2012, 2013, and 2014. In 2011, finishing gains of steers that grazed ‘MaxQ’ tall fescue were greater (P \u3c 0.05) than those that grazed wheat-bermudagrass
Nitrogen, Phosphorus, and Potassium Fertilization for Newly Established Tall Fescue
First-year spring yields of tall fescue in 2013 responded to phosphorus (P) fertilization, but lodging at the R5 growth stage in the spring with higher P fertilization rates may have influenced subsequent fall harvest yields, which declined with increasing P rates. As N rates increased, R5 yields declined but fall harvest yields increased
- …