1,540 research outputs found
Recommended from our members
Metallic Glass Films with Nanostructured Periodic Density Fluctuations Supported on Si/SiO2 as an Efficient Hydrogen Sorber.
Nanostructured metallic glass films (NMGF) can exhibit surface and intrinsic effects that give rise to unique physical and chemical properties. Here, a facile synthesis and electrochemical, structural, and morphologic characterization of Pd-Au-Si based MGs of approximately 50 nm thickness supported on Si/SiO2 is reported. Impressively, the maximum total hydrogen charge stored in the Pd-Au-Si nanofilm is equal to that in polycrystalline Pd films with 1 μm thickness in 0.1 m H2 SO4 electrolyte. The same NMGF has a volumetric desorption charge that is more than eight times and 25 % higher than that of polycrystalline PdNF and Pd-Cu-Si NMGF with the same thickness supported on Si/SiO2 , respectively. A significant number of nanovoids originating from PdHx crystals, and an increase in the average interatomic spacing is detected in Pd-Au-Si NMGF by high-resolution TEM. Such a high amount of hydrogen sorption is linked to the unique density fluctuations without any chemical segregation exclusively observed for this NMGF
Design of intense nanoscale stray fields and gradients at magnetic nanorod interfaces
We explore electrodeposited ordered arrays of Fe, Ni, and Co nanorods embedded in anodic alumina membranes as a source of intense magnetic stray field gradients localized at the nanoscale. We perform a multiscale characterization of the stray fields using a combination of experimental methods (magnetooptical Kerr effect and virtual bright field differential phase contrast imaging) and micromagnetic simulations and establish a clear correlation between the stray fields and the magnetic configurations of the nanorods. For uniformly magnetized Fe and Ni wires, the field gradients vary following saturation magnetization of the corresponding metal and the diameter of the wires. In the case of Co nanorods, very localized (similar to 10 nm) and intense (>1 T) stray field sources are associated with the cores of magnetic vortexes. Confinement of that strong field at extremely small dimensions leads to exceptionally high field gradients up to 10(8) T/m. These results demonstrate a clear path to design and fine-tune nanoscale magnetic stray field ordered patterns with a broad applicability in key nanotechnologies, such as nanomedicine, nanobiology, nanoplasmonics, and sensors
Magnon mode selective spin transport in compensated ferrimagnets
We investigate the generation of magnonic thermal spin currents and their
mode selective spin transport across interfaces in insulating, compensated
ferrimagnet/normal metal bilayer systems. The spin Seebeck effect signal
exhibits a non-monotonic temperature dependence with two sign changes of the
detected voltage signals. Using different ferrimagnetic garnets, we demonstrate
the universality of the observed complex temperature dependence of the spin
Seebeck effect. To understand its origin, we systematically vary the interface
between the ferrimagnetic garnet and the metallic layer, and by using different
metal layers we establish that interface effects play a dominating role. They
do not only modify the magnitude of the spin Seebeck effect signal but in
particular also alter its temperature dependence. By varying the temperature,
we can select the dominating magnon mode and we analyze our results to reveal
the mode selective interface transmission probabilities for different magnon
modes and interfaces. The comparison of selected systems reveals
semi-quantitative details of the interfacial coupling depending on the
materials involved, supported by the obtained field dependence of the signal
Recommended from our members
Negatively Charged In-Plane and Out-Of-Plane Domain Walls with Oxygen-Vacancy Agglomerations in a Ca-Doped Bismuth-Ferrite Thin Film.
The interaction of oxygen vacancies and ferroelectric domain walls is of great scientific interest because it leads to different domain-structure behaviors. Here, we use high-resolution scanning transmission electron microscopy to study the ferroelectric domain structure and oxygen-vacancy ordering in a compressively strained Bi0.9Ca0.1FeO3-δ thin film. It was found that atomic plates, in which agglomerated oxygen vacancies are ordered, appear without any periodicity between the plates in out-of-plane and in-plane orientation. The oxygen non-stoichiometry with δ ≈ 1 in FeO2-δ planes is identical in both orientations and shows no preference. Within the plates, the oxygen vacancies form 1D channels in a pseudocubic [010] direction with a high number of vacancies that alternate with oxygen columns with few vacancies. These plates of oxygen vacancies always coincide with charged domain walls in a tail-to-tail configuration. Defects such as ordered oxygen vacancies are thereby known to lead to a pinning effect of the ferroelectric domain walls (causing application-critical aspects, such as fatigue mechanisms and countering of retention failure) and to have a critical influence on the domain-wall conductivity. Thus, intentional oxygen vacancy defect engineering could be useful for the design of multiferroic devices with advanced functionality
Recommended from our members
Negatively Charged In-Plane and Out-Of-Plane Domain Walls with Oxygen-Vacancy Agglomerations in a Ca-Doped Bismuth-Ferrite Thin Film.
The interaction of oxygen vacancies and ferroelectric domain walls is of great scientific interest because it leads to different domain-structure behaviors. Here, we use high-resolution scanning transmission electron microscopy to study the ferroelectric domain structure and oxygen-vacancy ordering in a compressively strained Bi0.9Ca0.1FeO3-δ thin film. It was found that atomic plates, in which agglomerated oxygen vacancies are ordered, appear without any periodicity between the plates in out-of-plane and in-plane orientation. The oxygen non-stoichiometry with δ ≈ 1 in FeO2-δ planes is identical in both orientations and shows no preference. Within the plates, the oxygen vacancies form 1D channels in a pseudocubic [010] direction with a high number of vacancies that alternate with oxygen columns with few vacancies. These plates of oxygen vacancies always coincide with charged domain walls in a tail-to-tail configuration. Defects such as ordered oxygen vacancies are thereby known to lead to a pinning effect of the ferroelectric domain walls (causing application-critical aspects, such as fatigue mechanisms and countering of retention failure) and to have a critical influence on the domain-wall conductivity. Thus, intentional oxygen vacancy defect engineering could be useful for the design of multiferroic devices with advanced functionality
Single crystalline cylindrical nanowires – toward dense 3D arrays of magnetic vortices
Magnetic vortex-based media have recently been proposed for several applications of nanotechnology; however, because lithography is typically used for their preparation, their low-cost, large-scale fabrication is a challenge. One solution may be to use arrays of densely packed cobalt nanowires that have been efficiently fabricated by electrodeposition. In this work, we present this type of nanoscale magnetic structures that can hold multiple stable magnetic vortex domains at remanence with different chiralities. The stable vortex state is observed in arrays of monocrystalline cobalt nanowires with diameters as small as 45 nm and lengths longer than 200 nm with vanishing magnetic cross talk between closely packed neighboring wires in the array. Lorentz microscopy, electron holography and magnetic force microscopy, supported by micromagnetic simulations, show that the structure of the vortex state can be adjusted by varying the aspect ratio of the nanowires. The data we present here introduce a route toward the concept of 3-dimensional vortex-based magnetic memories
Recommended from our members
Strain-induced structure and oxygen transport interactions in epitaxial La 0.6 Sr 0.4 CoO 3− δ thin films
Abstract: The possibility to control oxygen transport in one of the most promising solid oxide fuel cell cathode materials, La0.6Sr0.4CoO3−δ, by controlling lattice strain raises questions regarding the contribution of atomic scale effects. Here, high-resolution transmission electron microscopy revealed the different atomic structures in La0.6Sr0.4CoO3−δ thin films grown under tensile and compressive strain conditions. The atomic structure of the tensile-strained film indicated significant local concentration of the oxygen vacancies, with the average value of the oxygen non-stoichiometry being much larger than for the compressive-strained film. In addition to the vacancy concentration differences that are measured by isotope exchange depth profiling, significant vacancy ordering was found in tensile-strained films. This understanding might be useful for tuning the atomic structure of La0.6Sr0.4CoO3−δ thin films to optimize cathode performance
Recommended from our members
Author Correction: Strain-induced structure and oxygen transport interactions in epitaxial La 0.6 Sr 0.4 CoO 3−δ thin films
An amendment to this paper has been published and can be accessed via a link at the top of the paper
- …