32,657 research outputs found

    First-principles investigation of magnetism and electronic structures of substitutional 3d3d transition-metal impurities in bcc Fe

    Get PDF
    The magnetic and electronic structures of 3d3d impurity atoms from Sc to Zn in ferromagnetic body-centered cubic iron are investigated using the all-electron full-potential linearized augmented plane-wave method based on the generalized gradient approximation (GGA). We found that in general, the GGA results are closer to the experimental values than those of the local spin density approximation. The calculated formation enthalpy data indicate the importance of a systematic study on the ternary Fe-C-XX systems rather than the binary Fe-XX systems, in steel design. The lattice parameters are optimized and the conditions for spin polarization at the impurity sites are discussed in terms of the local Stoner model. Our calculations, which are consistent with previous work, imply that the local spin-polarizations at Sc, Ti, V, Cu, and Zn are induced by the host Fe atoms. The early transition-metal atoms couple antiferromagnetically, while the late transition-metal atoms couple ferromagnetically, to the host Fe atoms. The calculated total magnetization (MM) of bcc Fe is reduced by impurity elements from Sc to Cr as a result of the antiferromagnetic interaction, with the opposite effect for solutes which couple ferromagnetically. The changes in MM are attributed to nearest neighbor interactions, mostly between the impurity and host atoms. The atom averaged magnetic moment is shown to follow generally the well-known Slater-Pauling curve, but our results do not follow the linearity of the Slater-Pauling curve. We attribute this discrepancy to the weak ferromagnetic nature of bcc Fe. The calculated Fermi contact hyperfine fields follow the trend of the local magnetic moments. The effect of spin-orbit coupling is found not to be significant although it comes into prominence at locations far from the impurity sites.Comment: 26 pages, 11 figure

    The support of the logarithmic equilibrium measure on sets of revolution in R3\R^3

    Full text link
    For surfaces of revolution BB in R3\R^3, we investigate the limit distribution of minimum energy point masses on BB that interact according to the logarithmic potential log(1/r)\log (1/r), where rr is the Euclidean distance between points. We show that such limit distributions are supported only on the ``out-most'' portion of the surface (e.g., for a torus, only on that portion of the surface with positive curvature). Our analysis proceeds by reducing the problem to the complex plane where a non-singular potential kernel arises whose level lines are ellipses

    Direct solar-pumped iodine laser amplifier

    Get PDF
    A XeCl laser which was developed earlier for an iodine laser oscillator was modified in order to increase the output pulse energy of XeCl laser so that the iodine laser output energy could be increased. The electrical circuit of the XeCl laser was changed from a simple capacitor discharge circuit of the XeCl laser to a Marx system. Because of this improvement the output energy from the XeCl laser was increased from 60 mj to 80 mj. Subsequently, iodine laser output energy was increased from 100 mj to 3 mj. On the other hand, the energy storage capability and amplification characteristics of the Vortek solar simulator-pumped amplifier was calculated expecting the calculated amplification factor is about 2 and the energy extraction efficiency is 26 percent due to the very low input energy density to the amplifier. As a result of an improved kinetic modeling for the iodine solar simulator pumped power amplifier, it is found that the I-2 along the axis of the tube affects seriously the gain profile. For the gas i-C3F7I at the higher pressures, the gain will decrease due to the I-2 as the pumping intensity increases, and at these higher pressures an increase in flow velocity will increase the gain

    Electromechanical Delay of the Dorsiflexors in Young and Old Women

    Get PDF
    PURPOSE: The aim of the current study was to examine the effect on electromechanical delay (EMD) in the dorsiflexors of young and old women during maximal isometric voluntary and electrically evoked contractions, and after a bout of lengthening contractions. METHODS: Nine young (25.1±1.3 years) and nine old (68.3±6.1 years) women performed baseline isometric contractions with evoked twitches followed by a series of dynamic lengthening contractions using a Biodex multi-joint dynamometer. Maximal isometric voluntary and evoked contractions were measured to assess EMD. Time points were recorded at baseline, mid-point of the intervention, post-task termination, and during recovery at 0.5, 2, 10, and 30 minutes. RESULTS: The EMD of the evoked twitches and voluntary contractions were not different in the young and old at baseline. Following the lengthening contractions the EMD of the evoked contractions at the midpoint of fatigue were shorter in the young compared to old, but not different between groups at task termination, or during recovery. No differences in the EMD measured from the voluntary maximal isometric contractions in the young and old at any fatigue or recovery time points. CONCLUSION: Shorter evoked EMD in the young during the midpoint of the intervention was possibly a result of potentiation which dissipated by task-termination as fatigue developed. This did not occur in old women. Results indicate that in the dorsiflexors EMD is not affected by age in women and overall is not affected by fatigue in either group. Recovery in both measures of EMD was not differently affected by age

    The two dimensional Hubbard model:a theoretical tool for molecular electronics

    Full text link
    When speaking about molecular electronics, the obvious question which occurs is how does one study it theoretically. The simplest theoretical model suitable for application in molecular electronics is the two dimensional Hubbard model. The aim of the present paper is to introduce this model, and give some examples of the systems which it can describe. After a short mathematically oriented discussion, it will be shown how to calculate the electrical conductivity of a particular planar system: a rectangular lattice with mutually independent conductivities along the two axes,but without using the 2D Hamiltonian. This system could find applications in high Tc studies. It will finally be shown that the electrical conductivity of graphene can be determined not by using the full formalism of the 2D2D Hubbard model, but by a slight reformulation of the Hamiltonian of the 1D Hubbard modelComment: Lecture given at the 16 Int.School of Cond.Matt.Physics,August 29.,-September 3 2010.,Varna (Bulgaria

    Quantitative Metrics from 20 Years of Terra Data Usage

    Get PDF
    NASA's Terra flagship satellite carries five Earth-observing instruments that have collected data for almost 20 years. NASA's Earth Science Data and Information System (ESDIS) Project makes these data, along with derived products, available to worldwide data users. Since the launch of Terra on December 18, 1999, more than 10,000 data products have been archived and distributed by NASA-funded Distributed Active Archive Centers (DAACs) that are part of NASA's Earth Observing System Data and Information System (EOSDIS). At the end of the 2018 Fiscal Year, about 1,000 Terra data products constituted almost 22% of the entire EOSDIS data archive volume (6 PB out of approximately 27.5 PB), and 6 PB of Terra data were distributed to over half-a-million public users worldwide.By categorizing the Terra data products and their distribution, we can get a quantitative assessment of Terra data usage. NASA's ESDIS Project has collected archive, distribution, and user information from EOSDIS data users since February 2000. These metrics are available through the ESDIS Metrics System (EMS). EMS information is stored in a relational database from which quantitative metrics of Terra data use can be retrieved and analyzed.The purposes of this study are to: 1) perform a comprehensive investigation of the 20-year trend in the archive and distribution of Terra data products; 2) identify and characterize data product usage over the last 20 years; and 3) identify and characterize the global user community for these data. In addition to revealing how Terra data use has evolved over time, the results of this study provide insights on identifying the various user communities for different kinds of Earth science data products. Also, because of the enormous quantity of data handled by EOSDIS DAACs, the study provides guidance of the requirements for future data systems that will be needed to effectively and efficiently handle the ever-increasing amounts of Earth science data produced by future (and ongoing) Earth science missions
    corecore