20 research outputs found

    Periodicity in Volcanic Gas Plumes: A Review and Analysis

    Get PDF
    Persistent non-explosive passive degassing is a common characteristic of active volcanoes. Distinct periodic components in measurable parameters of gas release have been widely identified over timescales ranging from seconds to months. The development and implementation of high temporal resolution gas measurement techniques now enables the robust quantification of high frequency processes operating on timescales comparable to those detectable in geophysical datasets. This review presents an overview of the current state of understanding regarding periodic volcanic degassing, and evaluates the methods available for detecting periodicity, e.g., autocorrelation, variations of the Fast Fourier Transform (FFT), and the continuous wavelet transform (CWT). Periodicities in volcanic degassing from published studies were summarised and statistically analysed together with analyses of literature-derived datasets where periodicity had not previously been investigated. Finally, an overview of current knowledge on drivers of periodicity was presented and discussed in the framework of four main generating categories, including: (1) non-volcanic (e.g., atmospheric or tidally generated); (2) gas-driven, shallow conduit processes; (3) magma movement, intermediate to shallow storage zone; and (4) deep magmatic processes

    Transient degassing events at the lava lake of Erebus volcano, Antarctica: Chemistry and mechanisms

    Get PDF
    We report here on the chemical signature of degassing at Erebus lava lake associated with intermittent explosions and the return to passive conditions. Explosions caused by bubble bursts were frequent during the 2013 field season, providing the first opportunity to observe such activity since 2005-2006. Several of the explosions were captured by multiple instruments including an open-path Fourier transform infrared spectrometer. Explosive bubble bursts and other transient degassing events are associated with gas compositions that are distinct from the usual range of passive degassing compositions. We set out to compare the chemical signature of explosive degassing during the 2005-06 and 2013 episodes, and to characterise the chemistry of gases emitted during the period of lake refilling after explosions. We found little change in the explosive gas chemistry between 2005-06 and 2013, suggesting reactivation of a common mechanism of gas segregation. Bubbles can be distinguished by their size and composition, the ranges of which are likely modified during ascent by gas-melt interaction and adiabatic expansion. The proportions of water, SO2, and HCl in the emitted gas plume increase during the refill of the lake after explosions, as the lake is recharged by a combination of magma that has already partially degassed, and that vesiculates rapidly in response to the drop in magmastatic pressure at the lake.TI acknowledges doctoral grants from the AXA Research Fund and the William Georgetti trust. Fieldwork was carried out with the support of the G-081 Erebus team and the US Antarctic Program, funded by NSF grant ANT1142083. The original FTIR retrieval code was written by Mike Burton with modifications made by Georgina Sawyer. Thermal IR images and lake velocity data were supplied by Nial Peters. Support was also received from grant 202844 from the European Research Council under the European FP7 and the NERC Centre for the Observation and Modelling of Earthquakes, Volcanoes and Tectonics (COMET), part of the NERC-funded National Centre for Earth Observation (http://comet.nerc.ac.uk/).This is the final version. It first appeared at http://www.sciencedirect.com/science/article/pii/S2214242815000327

    Periodicity in volcanic gas plumes: A review and analysis

    Get PDF
    Persistent non-explosive passive degassing is a common characteristic of active volcanoes. Distinct periodic components in measurable parameters of gas release have been widely identified over timescales ranging from seconds to months. The development and implementation of high temporal resolution gas measurement techniques now enables the robust quantification of high frequency processes operating on timescales comparable to those detectable in geophysical datasets. This review presents an overview of the current state of understanding regarding periodic volcanic degassing, and evaluates the methods available for detecting periodicity, e.g., autocorrelation, variations of the Fast Fourier Transform (FFT), and the continuous wavelet transform (CWT). Periodicities in volcanic degassing from published studies were summarised and statistically analysed together with analyses of literature-derived datasets where periodicity had not previously been investigated. Finally, an overview of current knowledge on drivers of periodicity was presented and discussed in the framework of four main generating categories, including: (1) non-volcanic (e.g., atmospheric or tidally generated); (2) gas-driven, shallow conduit processes; (3) magma movement, intermediate to shallow storage zone; and (4) deep magmatic processes.</jats:p

    Gas Emissions From the Western Aleutians Volcanic Arc

    Get PDF
    The Aleutian Arc is remote and highly active volcanically. Its 4,000&nbsp;km extent from mainland Alaska to Russia\u2019s Kamchatka peninsula hosts over 140 volcanic centers of which about 50 have erupted in historic times. We present data of volcanic gas samples and gas emission measurements obtained during an expedition to the western-most segment of the arc in September 2015 in order to extend the sparse knowledge on volatile emissions from this remote but volcanically active region. Some of the volcanoes investigated here have not been sampled for gases before this writing. Our data show that all volcanoes host high-temperature magmatic-hydrothermal systems and have gas discharges typical of volcanoes in oceanic arcs. Based on helium isotopes, the western Aleutian Arc segment has minimal volatile contributions from the overriding crust. Volcanic CO2 fluxes from this arc segment are small, compared to the emissions from volcanoes on the Alaska Peninsula and mainland Alaska. The comparatively low CO2 emissions may be related to the lower sediment flux delivered to the trench in this part of the arc

    Degassing at Sabancaya volcano measured by UV cameras and the NOVAC network

    Get PDF
    We used low-cost Raspberry Pi ultraviolet (UV) cameras to measure sulphur dioxide (SO2) fluxes from Sabancaya volcano, Peru, during eruptive activity on 27 April 2018. Light dilution corrections were made by operating instruments at two distances simultaneously. Estimated SO2 fluxes of 27.1 kgs-1 are higher than previously reported, likely due to the current eruptive episode (ongoing since November 2016). Each eruptive event included frequent (2–3 per minute), ash-rich emissions, forming gas pulses with masses of 3.0–8.2 tonnes SO2. Sustained degassing and lack of overpressure suggest open-vent activity. Mean fluxes are consistent with those measured by a permanent NOVAC station (25.9 kgs-1) located under the plume, with remaining differences likely due to windspeed estimates and sampling rate. Our work highlights the importance of accurate light dilution and windspeed modelling in SO2 retrievals and suggests that co-location of UV cameras with permanent scanning spectrometers may be valuable in providing accurate windspeeds

    Characterization of acoustic infrasound signals at VolcĂĄn de Fuego, Guatemala: a baseline for volcano monitoring

    Get PDF
    Monitoring volcanic unrest and understanding seismic and acoustic signals associated with eruptive activity is key to mitigate its impacts on population and infrastructure. On June 3, 2018, VolcĂĄn de Fuego, Guatemala, produced a violent eruption with very little warning. The paroxysmal phase of this event generated pyroclastic density currents (PDC) that impacted nearby settlements resulting in 169 fatalities, 256 missing, and nearly 13,000 permanently displaced from their homes. Since then, VolcĂĄn de Fuego has been instrumented with an extensive network of seismic and infrasound sensors. Infrasound is a new monitoring tool in Guatemala. A key step toward its effective use in volcano monitoring at VolcĂĄn de Fuego is establishing a baseline for the interpretation of the recorded signals. Here, we present the first comprehensive characterization of acoustic signals at VolcĂĄn de Fuego for the whole range of surface activity observed at the volcano. We use data collected during temporary deployments in 2018 and from the permanent infrasound network. Infrasound at Fuego is dominated by the occurrence of short-duration acoustic transients linked to both ash-rich and gas-rich explosions, at times associated with the generation of shock waves. The rich acoustic record at Fuego includes broadband and harmonic tremor, and episodes of chugging. We explore the occurrence of these signals in relation to visual observations of surface activity, and we investigate their source mechanisms within the shallow conduit system. This study provides a reference for the interpretation of acoustic signals at VolcĂĄn de Fuego and a baseline for real-time monitoring of its eruptive activity using infrasound data. Our results suggest that changes in the style of activity and morphology of the summit crater are reflected in the acoustic signature of eruption; as such our study provides a reference for the interpretation of acoustic signals at VolcĂĄn de Fuego and a baseline for real-time monitoring of its eruptive activity using infrasound

    Stability Analysis of Coiled Tape Springs

    No full text
    Tape springs have been used for many years in deployable booms and space mechanisms and currently are bing considered as components for more advanced deployable structures. Tape springs can be elastically coiled and will self-deploy when released. Their stability in the packaged configuration is critical for these applications. We propose a numerical and analytical framework to investigate the stability of coiled isotropic tape springs, where neither tension nor radial pressure are applied. Torsional and bending instabilities were observed when the ration between the coiled radius and the radius of the cross-section exceeded a critical value. A stability boundary is derived for different geometries and material properties. The effects of varying the number of coils and the self-contact conditions between adjacent loops of a tape spring are also studied, and the existence of out-of-plane instability modes is discussed
    corecore