143 research outputs found

    Recherches sur l’écosystĂšme de la forĂȘt subĂ©quatoriale de basse CĂŽte-d’Ivoire IV. Estimation du Bilan hydrique

    Get PDF

    Recherches sur l’écosystĂšme de la forĂȘt subĂ©quatoriale de basse CĂŽte-d’Ivoire III. Inventaire et structure de la vĂ©gĂ©tation ligneuse

    Get PDF

    Recherches sur l’écosystĂšme de la forĂȘt subĂ©quatoriale de basse CĂŽte-d’Ivoire II. Le cadre geographique

    Get PDF

    Induced ferromagnetism in Mn3N2 phase embedded in Mn/Si3N4 multilayers

    Get PDF
    Room temperature ferromagnetism has been obtained for different sets of Mn/Si3N4 multilayers prepared by sputtering. In order to find the most suitable conditions to stabilize the ferromagnetic ordering in this system, the evolution of the magnetic properties has been studied for films in which the Si3N4 layer thickness was maintained constant while that of the Mn layer was varied, Mn tm/Si3N4 3.4 nm n, and conversely, in Mn 0.7 nm/Si3N4 tsn 43 samples, in which the Mn layer thickness was kept constant while varying the Si3N4 layer thickness. Structural, compositional, electronic and magnetic characterizations have been performed by means of x-ray reflectometry, Rutherford backscattering spectrometry, x-ray photoemission spectroscopy, x-ray absorption, and superconducting quantum interference device for further knowledge of the magnetic-structural relationship in this system. Our results show that the peculiar magnetic behavior of these films is mainly related to the stabilization of a slightly distorted Mn3N2 phase that is induced by the Si3N4 at the interfaces. For samples with larger Mn layer thickness, metallic Mn and Mn3N2 phases coexist, which leads to a reduction of the total magnetization per Mn atom due to the presence of metallic Mn. For small Mn layer thickness tm 0.86 nm, where noncontinuous Mn3N2 layers are formed, the magnetization decreases noticeably due to the superparamagnetic size limit. It has been found that the best conditions for the stabilization of the ferromagnetism in this system occur when both, the manganese-rich and the silicon nitride layers, are continuous and with similar thickness, close to 3.5 nm.Ministerio de Educación y Ciencia de España-MAT2006-01004, MAT2008-06542-C04-01, MAT2008-06765-C02-02, S-0505/MAT/0194, Consolider 2010_26400 y Nanoselect CSD2007-0004

    Tuning the size, composition and structure of Au and Co50Au50 Nanoparticles by High-Power Impulse Magnetron Sputtering in gas-phase Synthesis

    Get PDF
    Gas-phase synthesis of nanoparticles with different structural and chemical distribution is reported using a circular magnetron sputtering in an ion cluster source by applying high-power impulses. The influence of the pulse characteristics on the final deposit was evaluated on Au nanoparticles. The results have been compared with the more common direct current approach. In addition, it is shown for the first time that high-power impulses in magnetron based gas aggregation sources allows the growth of binary nanoparticles, CoAu in this case, with a variety of crystalline and chemical arrangements which are analyzed at the atomic level

    Application of diamond-like carbon coatings to elastomers frictional surfaces

    Get PDF
    Nitrile-butyl rubber-like materials were coated with amorphous hydrogenated diamond-like carbon (DLC) coatings in order to modify their surface and tribological properties. Measurements of water contact angle were performed by the sessile drop method and showed that the coated samples are more hydrophobic with water contact angles up to 116°. The surface free energy of the elastomers was calculated by the acid-base regression method considering polar and dispersive contributions and the results were correlated with changes in the surface chemistry measured by X-ray photoelectron spectroscopy. It has been found that the lower presence of oxygen functional groups on the elastomer surfaces led to lower surface free energies, even though the polar contribution was not predominant. We also found that the DLC coatings led to a significant decrease of the surface free energy (up to 16%) and that there is a good correlation between the surface free energy values and the corresponding water contact angle values. The coefficient of friction was also measured and presented a significant decrease after coating with DLC. © 2008 Elsevier Ltd. All rights reserved.The authors acknowledge the financial support of the EU from the Sixth framework programme in the KRISTAL Project no. 515837-2. L. MartĂ­nez and Y. Huttel acknowledge the Spanish “Ministerio de EducaciĂłn y Ciencia” for the “Juan de la Cierva” and “RamĂłn y Cajal” programmes, respectively. R. Nevshupa acknowledges the “Marie Curie” programme (MIF1-CT-2006-22067)
    • 

    corecore