NEW INTERPRETATION ON EMG CHARATERISTICS OF SPASTIC CEREBRAL PALSY DURING A REHABILITATIVE WALKING EXERCISE

The purpose of this study is to interpret the EMG characteristics of spastic cerebral palsy children during walking with power spectrum analysis. The EMG signal of 16 cerebral palsy patients (GP) and 18 age matched control (Normal) were collected during several walking trial. It was found that our CP participants ha:d significantly longer firing duration and higher median frequency within a gait cycle for al.l the muscle groups, these indicated of the EMG characteristics of in the spastic muscles. In addition, the CP produced significantly smaller root mean square value in tibialis anterior muscle than the normal; this indicated that the tibialis anterior muscle of GP was weakness or atrophy. Because of good objectivity and reproducibility, employing RMS and the MF could :be suggested to be the parameters for further gait studies

Mathematical Modelling and Experimental Evaluation of Electrostatic Sensor Arrays for the Flow Measurement of Fine Particles in a Square-shaped Pipe

Abstract—Square-shaped pneumatic conveying pipes are used in some industrial processes such as fuel injection systems in coal-fired power plants and circulating fluidized beds. However, little research has been conducted to characterise the gas–solid two-phase flow in a square-shaped pneumatic conveying pipe. This paper presents mathematical modelling and experimental assessment of novel non-restrictive electrostatic sensor arrays for the measurement of pulverised fuel flow in a square-shaped pipe. The sensor arrays consist of twelve pairs of strip-shaped electrodes, which are uniformly embedded in the four flat pipe walls. An analytical mathematical model of the sensor arrays is established and the induced charge and currents of different electrodes due to a point charge are then derived based on the model. Experimental tests were conducted on a 54 mm square-shaped pipe section of a pneumatic conveyor test rig under a range of flow conditions. The fuel velocity profile over the whole cross-section of the pipe is measured. Mathematical modelling and experimental results demonstrate that the proposed non-restrictive electrostatic sensor arrays are capable of characterising the local pulverised fuel flow in a square-shaped pneumatic conveying pipe. Index Terms—electrostatic sensor, square-shaped pipe, mathematical modelling, velocity profile, pulverised fuel

Measurement of the Mass Flow Distribution of Pulverized Coal in Primary Air Pipes Using Electrostatic Sensing Techniques

On-line measurement of pulverized fuel (PF) distribution between primary air pipes on a coal-fired power plant is of great importance to achieve balanced fuel supply to the boiler for increased combustion efficiency and reduced pollutant emissions. An instrumentation system using multiple electrostatic sensing heads are developed and installed on 510 mm bore primary air pipes of a 600 MW coal-fired boiler for the measurement of mass flow distribution of PF. An array of electrostatic electrodes with different axial widths is housed in a sensing head. An electrode with a greater axial width and three narrower electrodes are used to derive the electrostatic signals for the determination of PF mass flow rate and velocity, respectively. The measured PF velocity is used for the calibration of coal mass flow rate. On-plant comparison trials of the developed system were conducted under typical operating conditions. Isokinetic sampling equipment is used to obtain reference data to evaluate the performance of the system. Experimental data demonstrate that the developed system is effective and reliable for the on-line continuous measurement of PF mass flow distribution between the primary air pipes of the same mill

Orbital and Spin Parameter Variations of Partial Eclipsing Low Mass X-ray Binary X 1822-371

We report our measurements for orbital and spin parameters of X 1822-371 using its X-ray partial eclipsing profile and pulsar timing from data collected by the Rossi X-ray Timing Explorer (RXTE). Four more X-ray eclipse times obtained by the RXTE 2011 observations were combined with historical records to trace evolution of orbital period. We found that a cubic ephemeris likely better describes evolution of the X-ray eclipse times during a time span of about 34 years with a marginal second order derivative of $ddot{P}_{orb}=(-1.05 pm 0.59) imes 10^{-19}$ s$^{-1}$. Using the pulse arrival time delay technique, the orbital and spin parameters were obtained from RXTE observations from 1998 to 2011. The detected pulse periods show that the neutron star in X 1822-371 is continuously spun-up with a rate of $dot{P}_{s}=(-2.6288 pm 0.0095) imes 10^{-12}$ s s$^{-1}$. Evolution of the epoch of the mean longitude $l=pi /2$ (i.e. $T_{pi / 2}$) gives an orbital period derivative value consistent with that obtained from the quadratic ephemeris evaluated by the X-ray eclipse but the detected $T_{pi / 2}$ values are significantly and systematically earlier than the corresponding expected X-ray eclipse times by $90 pm 11$ s. This deviation is probably caused by asymmetric X-ray emissions. We also attempted to constrain the mass and radius of the neutron star using the spin period change rate and concluded that the intrinsic luminosity of X 1822-371 is likely more than $10^{38}$ ergs s$^{-1}$.postprin

Single grain (LRE)-Ba-Cu-O superconductors fabricated by top seeded melt growth in air

We have recently reported a practical processing method for the fabrication in air of large, single grain (LRE)-Ba-Cu-O [where LRE Nd, Sm, Eu and Gd] bulk superconductors that exhibit high Tc and high Jc. The process is based initially on the development of a new type of generic seed crystal that can promote effectively the epitaxial nucleation of any (RE)-Ba-Cu-O system and, secondly, by suppressing the formation of (LRE)/Ba solid solution in a controlled manner within large LRE-Ba-Cu-O grains processed in air. In this paper we investigate the degree of homogeneity of large grain Sm-Ba-Cu-O superconductors fabricated by this novel process. The technique offers a significant degree of freedom in terms of processing parameters and reproducibility in the growth of oriented single grains in air and yields bulk samples with significantly improved superconducting and field-trapping properties compared to those processed by conventional top seeded melt growth (TSMG)

The measurement of skeletal muscle with multi-parameters by sonography

2004-2005 > Academic research: refereed > Publication in refereed journalVersion of RecordPublishe

Isometric contraction of skeletal muscle with multiple parameters

2006-2007 > Academic research: refereed > Publication in refereed journalVersion of RecordPublishe

Effects of La3+ on ATPase activities of plasma membrane vesicles isolated from Casuarina equisetifolia seedlings under acid rain stress

The effects of La3+ on the growth and the ATPases activities of plasma membrane(PM) vesicles isolated from Casuarina equisetifolia seedlings under artificial acid rain(pH 4.5) stress were studied. The results show that the height, length of roots, fresh weight and PM H+-ATPase activites of Casuarina equisetifolia seedlings increase by the treatments of soaking seeds in LaCl3 solutions with lower concentrations, and those can reach their peak values by treating with 200 mg . L-1 La3+. However, in comparison with the CK, those are inhibited by the higher La3+ concentrations; PM Ca2+-ATPase activity is inhibited with the treatments of La3+. The results also reveal that the H+-ATPase activity and the growth of cell enlarge have a remarkable positive correlation, and La3+ activating H+-ATPase can facilitate plant growth. La3+ also can alleviate cytosolic acidification of plant under acid rain stress and indirectly maintain the stability of intracellular environment. In order to resistant to acid rain and accelerate the growth of Casuarina equisetifolia, the suitable range of La3+ concentrations to soak seeds for 8 h is 50 similar to 200 mg . L-1

Selective scattering between Floquet-Bloch and Volkov states in a topological insulator

The coherent optical manipulation of solids is emerging as a promising way to engineer novel quantum states of matter. The strong time periodic potential of intense laser light can be used to generate hybrid photon-electron states. Interaction of light with Bloch states leads to Floquet-Bloch states which are essential in realizing new photo-induced quantum phases. Similarly, dressing of free electron states near the surface of a solid generates Volkov states which are used to study non-linear optics in atoms and semiconductors. The interaction of these two dynamic states with each other remains an open experimental problem. Here we use Time and Angle Resolved Photoemission Spectroscopy (Tr-ARPES) to selectively study the transition between these two states on the surface of the topological insulator Bi2Se3. We find that the coupling between the two strongly depends on the electron momentum, providing a route to enhance or inhibit it. Moreover, by controlling the light polarization we can negate Volkov states in order to generate pure Floquet-Bloch states. This work establishes a systematic path for the coherent manipulation of solids via light-matter interaction.Comment: 21 pages, 6 figures, final version to appear in Nature Physic

Study of the transient and depth-dependent swelling behavior of articular cartilage by ultrasound

2004-2005 > Academic research: refereed > Publication in refereed journalVersion of RecordPublishe