688 research outputs found
New approaches for removing the Si-OH layer of biogenic silica before analysing oxygen isotopes - Helium Flow Dehydration (HFD) and Vacuum Bead Melting (VBM) technique
The analysis of oxygen isotopes from diatom silica (δ18OSi) in sediment cores has obtained importance for palaeoclimate reconstruction especially where carbonate proxies are either rare or not available. Compared to the widely accepted relation of oxygen isotopes of carbonate origin to climate-relevant parameters, challenges still occur using biogenic silica. These questions arise at sample preparation as well as and the analysis itself, but are especially related to the removal of loosely bound oxygen of the hydrous layer. It is the common view that diatoms consist of an isotopically homogenous inner Si-O-Si layer and a less dense, hydrous layer forming Si-OH bonds, which has to be removed from the sample prior to analysis. Three methods have been accepted so far to perform this step: Controlled Isotopic Exchange (CIE) followed by fluorination, Stepwise Fluorination (SWF) and inductive High-Temperature carbon reduction (iHTR). The former method of vacuum dehydration (VD) proved to be unable to remove all exchangeable oxygen.Here, a new, remotely-operated laser-fluorination based mass spectrometry unit is used for the analysis. The silica is reacted with a CO2 laser in a BrF5 atmosphere and oxygen is then transferred to and analysed in a mass spectrometer (PDZ Europa 20-20). As CIE is both time-consuming and work-intense and SWF is impractical for this setup mainly due to the high pressure increase during dehydration, a new, efficient and fast method should be developed to remove the hydrous layer using the laser-fluorinationprocess.Two approaches were tested to remove the Si-OH layer and the impact on δ18OSi was assessed by performing tests on internal standard materials of marine and lacustrine biogenic silica and of quartz. For VBM, a minimum of 1.5 mg of pure sample is melted to a bead with a defocused laser to eliminate the hydrous outer layer and to reduce the surface. After the bead has formed it is transferred into the reaction chamber completely reacted with a focused laser under BrF5 atmosphere and subsequently analysed on-line.The second method, HFD is an improvement of the outdated VD technique. The sample is heated to 1050°C in a He flow transporting away any removed exchangeable oxygen immediately and thus, not allowing it to re-react with the sample. Various tests have been performed considering pre-heating at 200°C, He flow adjustments and the time of the sample exposed to 1050°C.VBM has difficulties to fully remove the hydrous layer, which results in comparatively lower δ18O values. The final set-up was not found yet. The HFD generated similar data than SWF in other laboratories with a high reproducibility and accuracy (standard deviation <0.2 ). Best results could be achieved by pre-heating the sample at 200°C and later on expose it for 15 minutes under a Helium counter flow at 1050°C. Experience with both techniques will be discussed and the reliability of the data compared to other methods
The impact of different soil parameters on the community structure of dominant bacteria from nine different soils located on Livingston Island, South Shetland Archipelago, Antarctica.
The degradation of coastal permafrost and the development of sub-sea permafrost in the near-shore zone of the Laptev Sea : extended abstract
The oxygen isotope record from diatoms at Lake El’gygytgyn –Quaternary Far East Russian Arctic palaeo-temperature and talik dynamics
Paleolimnological Reconstructions of Holocene Environments and Climate from Lake Lyadhej-To, Ural Mountains, Northern Russia
The use of CORONA images in remote sensing of periglacial geomorphology: an illustration from the NE Siberian coast
CORONA images have been used for the mapping of periglacial features on the Bykovsky Peninsula and adjacent Khorogor Valley in northeast Siberia. Features, mapped and analysed within a geographical information system, include thermokarst depressions, thermo-erosional valleys, thermo-erosional cirques, thermokarst lakes, thermokarst lagoons and pingos. More than 50% of the area is strongly influenced by thermally-induced subsidence. Thermokarst in the area is probably less active today than in the early-middle Holocene
Using thermoterrace dimensions to calculate the coastal erosian rate
Thermoterraces in syngenetic ice complexes are widespread along the erosion dominated Yakutia Arctic coast. Thermoterraces progressively record quantitative information about their existence, which may be used to determine the mean shore retreat rate during the time they are present. Initial measurements of four thermoterraces on the south coast of the Dmitry Laptev Strait were carried out by the authors in 2002 and shore retreat rates were calculated. Comparison of erosion rates obtained using thermoterrace dimensions and geodetic survey results with those determined using aerial photographs showed that erosion rate values obtained in these two ways are approximately of the same order
- …