Superconducting Electrometer Based on the Resistively Shunted Bloch Transistor

We have fabricated the Bloch transistor shunted on-chip by a small-sized Cr resistor with Rs about 1 kOhm. The Bloch transistor normally consists of two small Josephson junctions connected in series, which in our case have been replaced by two superconducting interferometer loops, each with two junctions in parallel. A capacitively coupled gate is supplied to control the induced charge of the small intermediate electrode (island) of the transistor. The measured I-V curves show no hysteresis and correspond to the operation of a effective Josephson junction at the high-damping and strong-noise limits. The critical current of the system was found to be close to its nominal value, that is in accordance with the electromagnetic environment theory. The I-V curves were modulated by the gate with a period of e and a maximum swing of about 2 /mu_V. Such rather moderate modulation results from the Josephson-to- charging energies ratio, Ej/Ec about 9, in our sample being far from its optimum value of 0.3 up to 1.Comment: To be published in IEEE Transactions on Applied Superconductivity, June 199

Synchronized single electron emission from dynamical quantum dots

We study synchronized quantized charge pumping through several dynamical quantum dots (QDs) driven by a single time modulated gate signal. We show that the main obstacle for synchronization being the lack of uniformity can be overcome by operating the QDs in the decay cascade regime. We discuss the mechanism responsible for lifting the stringent uniformity requirements. This enhanced functionality of dynamical QDs might find applications in nanoelectronics and quantum metrology.Comment: 4 pages, 3 figures, submitted to AP

Characterization of All-Chromium Tunnel Junctions and Single Electron Tunneling Devices Fabricated by Direct-Writing Multilayer Technique

We report about the fabrication and analysis of the properties of Cr/CrO_x/Cr tunnel junctions and SET transistors, prepared by different variants of direct-writing multilayer technique. In all cases, the CrO_x tunnel barriers were formed in air under ambient conditions. From the experiments on single junctions, values for the effective barrier height and thickness were derived. For the Cr/CrO_x/Cr SET transistors we achieved minimal junction areas of 17 x 60 nm^2 using a scanning transmission electron microscope for the e-beam exposure on Si_3N_4 membrane substrate. We discuss the electrical performance of the transistor samples as well as their noise behavior.Comment: 19 pages, 9 figure

The effect of thermal annealing on the properties of Al-AlOx-Al single electron tunneling transistors

The effect of thermal annealing on the properties of Al-AlOx-Al single electron tunneling transistors is reported. After treatment of the devices by annealing processes in forming gas atmosphere at different temperatures and for different times, distinct and reproducible changes of their resistance and capacitance values were found. According to the temperature regime, we observed different behaviors as regards the resistance changes, namely the tendency to decrease the resistance by annealing at T = 200 degree C, but to increase the resistance by annealing at T = 400 degree C. We attribute this behavior to changes in the aluminum oxide barriers of the tunnel junctions. The good reproducibility of these effects with respect to the changes observed allows the proper annealing treatment to be used for post-process tuning of tunnel junction parameters. Also, the influence of the annealing treatment on the noise properties of the transistors at low frequency was investigated. In no case did the noise figures in the 1/f-regime show significant changes.Comment: 6 pages, 7 eps-figure

Ultrafast optical ranging using microresonator soliton frequency combs

Light detection and ranging (LIDAR) is critical to many fields in science and industry. Over the last decade, optical frequency combs were shown to offer unique advantages in optical ranging, in particular when it comes to fast distance acquisition with high accuracy. However, current comb-based concepts are not suited for emerging high-volume applications such as drone navigation or autonomous driving. These applications critically rely on LIDAR systems that are not only accurate and fast, but also compact, robust, and amenable to cost-efficient mass-production. Here we show that integrated dissipative Kerr-soliton (DKS) comb sources provide a route to chip-scale LIDAR systems that combine sub-wavelength accuracy and unprecedented acquisition speed with the opportunity to exploit advanced photonic integration concepts for wafer-scale mass production. In our experiments, we use a pair of free-running DKS combs, each providing more than 100 carriers for massively parallel synthetic-wavelength interferometry. We demonstrate dual-comb distance measurements with record-low Allan deviations down to 12 nm at averaging times of 14 $\mu$s as well as ultrafast ranging at unprecedented measurement rates of up to 100 MHz. We prove the viability of our technique by sampling the naturally scattering surface of air-gun projectiles flying at 150 m/s (Mach 0.47). Combining integrated dual-comb LIDAR engines with chip-scale nanophotonic phased arrays, the approach could allow widespread use of compact ultrafast ranging systems in emerging mass applications.Comment: 9 pages, 3 figures, Supplementary information is attached in 'Ancillary files

Single-parameter non-adiabatic quantized charge pumping

Controlled charge pumping in an AlGaAs/GaAs gated nanowire by single-parameter modulation is studied experimentally and theoretically. Transfer of integral multiples of the elementary charge per modulation cycle is clearly demonstrated. A simple theoretical model shows that such a quantized current can be generated via loading and unloading of a dynamic quasi-bound state. It demonstrates that non-adiabatic blockade of unwanted tunnel events can obliterate the requirement of having at least two phase-shifted periodic signals to realize quantized pumping. The simple configuration without multiple pumping signals might find wide application in metrological experiments and quantum electronics.Comment: 4 pages, 4 figure

Generation of energy selective excitations in quantum Hall edge states

We operate an on-demand source of single electrons in high perpendicular magnetic fields up to 30T, corresponding to a filling factor below 1/3. The device extracts and emits single charges at a tunable energy from and to a two-dimensional electron gas, brought into well defined integer and fractional quantum Hall (QH) states. It can therefore be used for sensitive electrical transport studies, e.g. of excitations and relaxation processes in QH edge states

Referenced Single-Molecule Measurements Differentiate between GPCR Oligomerization States.

The extent to which Rhodopsin family G-protein-coupled receptors (GPCRs) form invariant oligomers is contentious. Recent single-molecule fluorescence imaging studies mostly argue against the existence of constitutive receptor dimers and instead suggest that GPCRs only dimerize transiently, if at all. However, whether or not even transient dimers exist is not always clear due to difficulties in unambiguously distinguishing genuine interactions from chance colocalizations, particularly with respect to short-lived events. Previous single-molecule studies have depended critically on calculations of chance colocalization rates and/or comparison with unfixed control proteins whose diffusional behavior may or may not differ from that of the test receptor. Here, we describe a single-molecule imaging assay that 1) utilizes comparisons with well-characterized control proteins, i.e., the monomer CD86 and the homodimer CD28, and 2) relies on cell fixation to limit artifacts arising from differences in the distribution and diffusion of test proteins versus these controls. The improved assay reliably reports the stoichiometry of the Glutamate-family GPCR dimer, γ-amino butyric acid receptor b2, whereas two Rhodopsin-family GPCRs, β2-adrenergic receptor and mCannR2, exhibit colocalization levels comparable to those of CD86 monomers, strengthening the case against invariant GPCR oligomerization.This is the final version of the article. It first appeared from Elsevier via http://dx.doi.org/10.1016/j.bpj.2015.09.00

Participatory Militias: An Analysis of an Armed Movement's Online Audience

Armed groups of civilians known as "self-defense forces" have ousted the powerful Knights Templar drug cartel from several towns in Michoacan. This militia uprising has unfolded on social media, particularly in the "VXM" ("Valor por Michoacan," Spanish for "Courage for Michoacan") Facebook page, gathering more than 170,000 fans. Previous work on the Drug War has documented the use of social media for real-time reports of violent clashes. However, VXM goes one step further by taking on a pro-militia propagandist role, engaging in two-way communication with its audience. This paper presents a descriptive analysis of VXM and its audience. We examined nine months of posts, from VXM's inception until May 2014, totaling 6,000 posts by VXM administrators and more than 108,000 comments from its audience. We describe the main conversation themes, post frequency and relationships with offline events and public figures. We also characterize the behavior of VXM's most active audience members. Our work illustrates VXM's online mobilization strategies, and how its audience takes part in defining the narrative of this armed conflict. We conclude by discussing possible applications of our findings for the design of future communication technologies.Comment: Participatory Militias: An Analysis of an Armed Movement's Online Audience. Saiph Savage, Andres Monroy-Hernandez. CSCW: ACM Conference on Computer-Supported Cooperative Work 201

Single-charge escape processes through a hybrid turnstile in a dissipative environment

We have investigated the static, charge-trapping properties of a hybrid superconductor---normal metal electron turnstile embedded into a high-ohmic environment. The device includes a local Cr resistor on one side of the turnstile, and a superconducting trapping island on the other side. The electron hold times, t ~ 2-20s, in our two-junction circuit are comparable with those of typical multi-junction, N >= 4, normal-metal single-electron tunneling devices. A semi-phenomenological model of the environmental activation of tunneling is applied for the analysis of the switching statistics. The experimental results are promising for electrical metrology.Comment: Submitted to New Journal of Physics 201