Turbulent transport in the scrape-off layer of Wendelstein 7-X

Turbulent transport is widely considered to be the main driver for cross-field transport in the scrape-off layer (SOL) of toroidal magnetized plasmas. Here, reciprocating Langmuir probes are employed to measure both the plasma profiles and the turbulent particle transport in the SOL of the Wendelstein 7-X stellarator. The relation between turbulent radial particle flux Γr and the local pressure gradient is often approximately linear across the entire SOL width, indicating that radial turbulence spreading is absent. This observation holds across a wide range of magnetic configurations and different plasma heating and density scenarios. The magnitude of the turbulent transport for a given gradient reveals a dependence on the magnetic configuration and the position in the SOL, which we relate to the cross-spectral characteristics of multi-tip floating potential measurements. Magnetic islands can add further complexity due to non-monotonic SOL profiles and the breaking of the transport-gradient relation. Finally, anomalous diffusion coefficients are determined from the probe measurements

Plasma filaments in the scrape-off layer of Wendelstein 7-X

Plasma filaments have been observed by reciprocating electric probes in the Scrape-Off Layer (SOL) of the Wendelstein 7-X stellarator. Comparison with target probes indicates that a filament observed in the W7-X SOL extends to the sheath. Two-dimensional simulations of seeded filaments exhibit good quantitative agreement with experimental measurements in filament velocity scalings, despite an assumption of constant field line curvature. Both experiment and simulation show a slow radial propagation of filaments, indicating that filaments are essentially bound to their flux surface and do not perform ballistic radial motion. In contrast, the poloidal propagation along flux surfaces is much faster than the radial motion

Advanced electron cyclotron heating and current drive experiments on the stellarator Wendelstein 7-X

During the first operational phase (OP 1.1) of Wendelstein 7-X (W7-X) electron cyclotron resonance heating (ECRH) was the exclusive heating method and provided plasma start-up, wall conditioning, heating and current drive. Six gyrotrons were commissioned for OP1.1 and used in parallel for plasma operation with a power of up to 4.3 MW. During standard X2-heating the spatially localized power deposition with high power density allowed controlling the radial profiles of the electron temperature and the rotational transform. Even though W7-X was not fully equipped with first wall tiles and operated with a graphite limiter instead of a divertor, electron densities of n e > 3·1019 m-3 could be achieved at electron temperatures of several keV and ion temperatures above 2 keV. These plasma parameters allowed the first demonstration of a multipath O2-heating scenario, which is envisaged for safe operation near the X-cutoff-density of 1.2·1020 m-3 after full commissioning of the ECRH system in the next operation phase OP1.2