96 research outputs found
Recommended from our members
Electroluminescence excitation mechanisms in an epoxy resin under divergent and uniform field
Electroluminescence excitation mechanisms have been investigated in epoxy resin under divergent and uniform field situations. Metallic wires embedded in the resin were used to produce field divergence whereas film samples were metallised to obtain a uniform field. Electroluminescence under divergent field was stimulated by an impulse voltage. Light was emitted on the positive and negative fronts of the square pulses when the field exceeded 20 kV/mm at the wire surface, with equal intensity and without polarity dependence. There was evidence of space charge accumulation around the wires in multiple-pulse experiments. Charge injection and extraction occurring at both fronts of the pulse provide the condition for EL excitation. Further excitation of the EL during the plateau of the voltage pulse is prevented by the opposite field of the trapped charge. Field computation with and without space charge supports the proposed interpretation. A DC voltage was used for the uniform field experiments. A continuous level of electroluminescence is found at 175 kV/mm. Charging/discharging current measurements and space charge profile analyses using the pulsed electro-acoustic (PEA) technique were performed at different fields up to the EL level. Dipolar orientation generates a long lasting transient current that prevents the conduction level being reached within the experimental protocol (one hour poling time). The continuous EL emission is nevertheless associated with a regime where the conduction becomes dominant over the orientational polarization. Polarization and space charge contribute to the PEA charge profiles. Homo-charge injection at anode and cathode is seen at 20 kV/mm and a penetration of positive space charge in the bulk is detected above 100 kV/mm, suggesting an excitation of the continuous EL by bipolar charge recombination
Recommended from our members
Space charge induced luminescence in epoxy resin
Dielectric breakdown of epoxies is preceded by a light emission from the solid state material, so-called electroluminescence. Very little is known however on the luminescence properties of epoxy. The aim of this paper is to derive information that can be used as a basis to understand the nature of the excited states and their involvement in electrical degradation processes
Recommended from our members
Charge injection, electroluminescence, and ageing of an epoxy resin in high divergent fields
[INTRODUCTION]Most experimental studies of electrical ageing have concentrated on semi-crystalline polymers such as those used in cable insulation and capacitors (see for example [1]). Theoretical models [2-4] for electrical ageing have been developed on the basis of these studies. The consensus is that ageing involves the formation of low-density regions, though the mechanisms responsible are disputed. For example, bond scission by high-energy electrons [2,5], and mechanical deformation have both been suggested. Both of these mechanisms are related to charge injection and the subsequent formation of high local fields. The semi-crystalline polymers studied so far have similar chemistries and almost identical morphologies. They tend, therefore, to show many similarities in, for example, the size of the energy barriers for the ageing reaction, critical ageing levels, and field dependence of ageing [4]. These similarities make it difficult to discriminate between mechanisms. Epoxy resins, however, are network polymers with a different molecular chemistry to that of the semi-crystalline polymers and are thus ideal to evaluate the proposed ageing mechanisms. We have therefore studied an epoxy resin (CY1301) under both uniform field and high divergent field conditions. Uniform field conditions were used to gain baseline characteristics for the properties of the unaged epoxy resin, and also for the effects of electrical ageing in low fields. Studies in high divergent fields were made using an electrode arrangement adapted from that of [6]. A number of wires set approximately 0.5mm apart were embedded, parallel to the flat faces, in thin (290 m ) flat samples. The radius of the wires ranged from 5 m (gold plated tungsten) to 25 m (tungsten). Relatively small voltages applied to the wires (5 kV DC) therefore produced local fields up to 170 kV/mm depending upon the wire radius chosen. These field levels are high enough to inject space-charge [6] without leading to instantaneous failure. This geometry, therefore, may both inject charge and simulate local stress enhancements arising from charge accumulation. The number of wires is large (30) so that the volume affected is big enough to allow changes on ageing to be detectable
Recommended from our members
The decay of space charge in a glassy epoxy resin following voltage removal
The PEA technique is used to measure the distribution of space charge in an epoxy resin after polarisation for one week at an applied field of 7.14kV/mm over a range of temperatures. The decay of the space charge is followed for times up to 114 hours after removal of the voltage and analysed in terms of a number of alternative decay mechanisms. It is shown that the rate-determining stage of the decay mechanism is that of a thermally activated process that has been associated with charge de-trapping. At times greater than 102s the de-trapping process behaves as though the space charge field does not exist and the retention time of the space charge depends only upon the depth of the deepest occupied traps and the temperature
Recommended from our members
Photoluminescence, recombination induced luminescence and electroluminescence in epoxy resin
Dielectric breakdown of epoxies is preceded by light emission, or so-called electroluminescence, from the solid-state material. Very little is known about the luminescence properties of epoxies. The aim of this paper is to derive information that can be used as a basis to understand the nature of the excited states and their involvement in electrical degradation processes. Three different kinds of stimulation were used to excite the material luminescence. Photoluminescence was performed on the base resin, the hardener and the cured resin. Luminescence excited by a silent discharge has been analysed to identify which of the luminescent centres are optically active upon the recombination of electrical charges and could therefore act as charge traps. Finally, the electroluminescence spectrum has been acquired and compared with the previous ones. Although the identification of the origin of these emissions is far from being complete, it has been found that the photoluminescence from the cured resin is due to in-chain chromophores, which acts as trapping centres. The excited states involved in photoluminescence also seems to be involved in electroluminescence, but other components are detected as well, which could be due to the degradation of the resin molecule under the effect of the electric stress
Recommended from our members
Internal charge behaviour of nanocomposites
The incorporation of 23 nm titanium dioxide nanoparticles into an epoxy matrix to form a nanocomposite structure is described. It is shown that the use of nanometric particles results in a substantial change in the behaviour of the composite, which can be traced to the mitigation of internal charge when a comparison is made with conventional TiO2 fillers. A variety of diagnostic techniques (including dielectric spectroscopy, electroluminescence, thermally stimulated current, photoluminescence) have been used to augment pulsed electro-acoustic space charge measurement to provide a basis for understanding the underlying physics of the phenomenon. It would appear that, when the size of the inclusions becomes small enough, they act co-operatively with the host structure and cease to exhibit interfacial properties leading to Maxwell-Wagner polarization. It is postulated that the particles are surrounded by high charge concentrations in the Gouy-Chapman-Stern layer. Since nanoparticles have very high specific areas, these regions allow limited charge percolation through nano-filled dielectrics. The practical consequences of this have also been explored in terms of the electric strength exhibited. It would appear that there was a window in which real advantages accrue from the nano-formulated material. An optimum loading of about 10% (by weight) is indicated
HOXB5 Cooperates with NKX2-1 in the Transcription of Human RET
The enteric nervous system (ENS) regulates peristaltic movement of the gut, and abnormal ENS causes Hirschsprung's disease (HSCR) in newborns. HSCR is a congenital complex genetic disorder characterised by a lack of enteric ganglia along a variable length of the intestine. The receptor tyrosine kinase gene (RET) is the major HSCR gene and its expression is crucial for ENS development. We have previously reported that (i) HOXB5 transcription factor mediates RET expression, and (ii) mouse with defective HOXB5 activity develop HSCR phenotype. In this study, we (i) elucidate the underlying mechanisms that HOXB5 mediate RET expression, and (ii) examine the interactions between HOXB5 and other transcription factors implicated in RET expression. We show that human HOXB5 binds to the promoter region 5′ upstream of the binding site of NKX2-1 and regulates RET expression. HOXB5 and NKX2-1 form a protein complex and mediate RET expression in a synergistic manner. HSCR associated SNPs at the NKX2-1 binding site (-5G>A rs10900296; -1A>C rs10900297), which reduce NKX2-1 binding, abolish the synergistic trans-activation of RET by HOXB5 and NKX2-1. In contrast to the synergistic activation of RET with NKX2-1, HOXB5 cooperates in an additive manner with SOX10, PAX3 and PHOX2B in trans-activation of RET promoter. Taken together, our data suggests that HOXB5 in coordination with other transcription factors mediates RET expression. Therefore, defects in cis- or trans-regulation of RET by HOXB5 could lead to reduction of RET expression and contribute to the manifestation of the HSCR phenotype
Charge transport modelling in electron-beam irradiated dielectrics: a model for polyethylene
- …