3 research outputs found
How stress and temperature conditions affect rock-fluid chemistry and mechanical deformation
We report the results from a series of chalk flow-through-compaction experiments performed at three effective stresses (0.5, 3.5, and 12.3MPa) and two temperatures (92 and 130◦C). The results show that both stress and temperature are important to both chemical alteration and mechanical deformation. The experiments were conducted on cores drilled from the same block of outcrop chalks from the Obourg quarry within the Saint Vast formation (Mons, Belgium). The pore pressure was kept at 0.7MPa for all experiments with a continuous flow of 0.219M MgCl2 brine at a constant flow rate; 1 original pore volume (PV) per day. The experiments have been performed in tri-axial cells with independent control of the external stress (hydraulic pressure in the confining oil), pore pressure, temperature, and the injected flow rate. Each experiment consists of two phases; a loading phase where stress-strain dependencies are investigated (approximately 2 days), and a creep phase that lasts for 150–160 days. During creep, the axial deformation was logged, and the effluent samples were collected for ion chromatography analyses. Any difference between the injected and produced water chemistry gives insight into the rock-fluid interactions that occur during flow through the core. The observed effluent concentration shows a reduction in Mg2+, while the Ca2+ concentration is increased. This, together with SEM-EDS analysis, indicates that magnesium-bearing mineral phases are precipitated leading to dissolution of calcite. This is in-line with other flow-through experiments reported earlier. The observed dissolution and precipitation are sensitive to the effective stress and test temperature. Higher stress and temperature lead to increased Mg2+ and Ca2+ concentration changes. The observed strain can be partitioned additively into a mechanical and chemical driven component.publishedVersio
Recommended from our members
Psycho-education programme for temporomandibular disorders: a pilot study
BACKGROUND: Temporomandibular disorders (TMDs) are by far the most predominant condition affecting the temporomandibular joint (TMJ), however many patients have mild self-limiting symptoms and should not be referred for specialist care. The aim of this pilot study was to develop a simple, cost-effective management programme for TMDs using CD-ROM. 41 patients (age 18–70) participated in this study, patients were divided into three groups: the 1st group were involved in an attention placebo CD-ROM (contain anatomical information about the temporomandibular system), the 2nd group received information on CD-ROM designed to increase their control and self efficacy, while the 3rd group received the same programme of the 2nd group added to it an introduction to self-relaxing techniques followed by audio tape of progressive muscle relaxation exercises. Each of the groups was asked to complete a number of questionnaires on the day of initial consultation and six weeks afterwards. RESULTS: The two experimental groups (2nd & 3rd) were equally effective in reducing pain, disability and distress, and both were more effective than the attention placebo group (1st), however the experimental groups appeared to have improved at follow-up relative to the placebo-group in terms of disability, pain and depressed mood. CONCLUSION: This pilot study demonstrates the feasibility and acceptability of the design. A full, randomized, controlled trial is required to confirm the efficacy of the interventions developed here
Cognitions, chronicity, distress and disability in temporomandibular disorder (idiopathic orofacial pain)
EThOS - Electronic Theses Online ServiceGBUnited Kingdo