9,144 research outputs found
Performance of high-altitude, long-endurance, turboprop airplanes using conventional or cryogenic fuels
An analytical study has been conducted to evaluate the potential endurance of remotely piloted, low speed, high altitude, long endurance airplanes designed with 1990 technology. The baseline configuration was a propeller driven, sailplane like airplane powered by turbine engines that used JP-7, liquid methane, or liquid hydrogen as fuel. Endurance was measured as the time spent between 60,000 feet and an engine limited maximum altitude of 70,000 feet. Performance was calculated for a baseline vehicle and for configurations derived by varying aerodynamic, structural or propulsion parameters. Endurance is maximized by reducing wing loading and engine size. The level of maximum endurance for a given wing loading is virtually the same for all three fuels. Constraints due to winds aloft and propulsion system scaling produce maximum endurance values of 71 hours for JP-7 fuel, 70 hours for liquid methane, and 65 hours for liquid hydrogen. Endurance is shown to be strongly effected by structural weight fraction, specific fuel consumption, and fuel load. Listings of the computer program used in this study and sample cases are included in the report
Study of fuel systems for LH2-fueled subsonic transport aircraft, volume 1
Several engine concepts examined to determine a preferred design which most effectively exploits the characteristics of hydrogen fuel in aircraft tanks received major emphasis. Many candidate designs of tank structure and cryogenic insulation systems were evaluated. Designs of all major elements of the aircraft fuel system including pumps, lines, valves, regulators, and heat exchangers received attention. Selected designs of boost pumps to be mounted in the LH2 tanks, and of a high pressure pump to be mounted on the engine were defined. A final design of LH2-fueled transport aircraft was established which incorporates a preferred design of fuel system. That aircraft was then compared with a conventionally fueled counterpart designed to equivalent technology standards
Study of fuel systems for LH2-fueled subsonic transport aircraft, volume 2
For abstract, see N78-31085
Search for Mars lander/rover/sample-return sites: A status review
Ten Mars sites were studied in the USA for four years. The sites are the Chasma Boreale (North Pole), Planum Australe (South Pole), Olympus Rupes, Mangala Valles, Memnonia Sulci, Candor Chasma, Kasel Valles, Nilosyrtis Mensae, Elysium Montes, and Apollinaris Patera. Seven sites are being studied by the USSR; their prime sites are located at the east mouth of Kasel Valles and near Uranius Patera. Thirteen geological maps of the first six USA sites are compiled and in review. Maps of the Mangala East and West sites at 1:1/2 million scale and a 1:2 million scale map show evidence of three episodes of small-channel formation interspersed with episodes of volcanism and tectonism that span the period from 3.5 to 0.6 b.y. ago. The tectonic and geological history of Mars, both ancient and modern, can be elucidated by sampling volcanic and fluvial geologic units at equatorial sites and layered deposits at polar sites. The evidence appears clear for multiple episodes of fluvial channeling, including some that are quite recent; this evidence contrasts with the theses of Baker and Partridge (1986) and many others that all channels are ancient. Verification of this hypothesis by Mars Observer will be an important step forward in the perception of the history of Mars
Formation of "Chemically Pure" Magnetite from Mg-Fe-Carbonates Implications for the Exclusively Inorganic Origin of Magnetite and Sulfides in Martian Meteorite ALH84001
Magnetite and sulfides in the black rims of carbonate globules in Martian meteorite ALH84001 have been studied extensively because of the claim by McKay et al. that they are biogenic in origin. However, exclusively inorganic (abiotic) processes are able to account for the occurrence of carbonate-sulfide-magnetite assemblages in the meteorite. We have previously precipitated chemically zoned and sulfide-bearing carbonate globules analogous to those in ALH84001 (at less than or equal to 150 C) from multiple fluxes of variable-composition Ca-Mg-Fe-CO2-S-H2O solutions. Brief heating of precipitated globules to approx. 470 C produced magnetite and pyrrhotite within the globules by thermal decomposition of siderite and pyrite, respectively. We have also shown that morphology of magnetite formed by inorganic thermal decomposition of Fe-rich carbonate is similar to the morphology of so-called biogenic magnetite in the carbonate globules of ALH84001. Magnetite crystals in the rims of carbonate globules in ALH84001 are chemically pure [Note: "Chemically pure" is defined here as magnetite with Mg at levels comparable or lower than Mg detected by [8] in ALH84001 magnetite]. A debate continues on whether or not chemically pure magnetite can form by the thermal decomposition of mixed Mg-Fe-carbonates that have formed under abiotic conditions. Thomas-Keprta et al. argue that it is not possible to form Mg-free magnetite from Mg-Fe-carbonate based on thermodynamic data. We previously suggested that chemically pure magnetite could form by the thermal decomposition of relatively pure siderite in the outer rims of the globules. Mg-Fe-carbonates may also thermally decompose under conditions conducive for formation of chemically pure magnetite. In this paper we show through laboratory experiments that chemically pure magnetite can form by an inorganic process from mixed Mg-Fe-carbonates
Microwave Spectroscopy
Contains reports on seven research projects.United States Army Signal Corps (Contract DA36-039-sc-74895
Bags, junctions, and networks of BPS and non-BPS defects
We investigate several models of coupled scalar fields that present discrete
Z_2, Z_2 x Z_2, Z_3 and other symmetries. These models support topological
domain wall solutions of the BPS and non-BPS type. The BPS solutions are
stable, but the stability of the non-BPS solutions may depend on the parameters
that specify the models. The BPS and non-BPS states give rise to bags, and also
to three-junctions that may allow the presence of networks of topological
defects. In particular, we show that the non-BPS defects of a specific model
that engenders the Z_3 symmetry give rise to a stable regular hexagonal network
of domain walls.Comment: Revtex, 16 pages, 6 ps figures; Shorter version to be published in
Phys. Rev.
A new fireworm (Amphinomidae) from the Cretaceous of Lebanon identified from three-dimensionally preserved myoanatomy
© 2015 Parry et al. Open Access This article is distributed under the terms of the Creative Commons Attribution 4.0
International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and
reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to
the Creative Commons license, and indicate if changes were made. The Creative Commons Public Domain Dedication waiver
(http://creativecommons.org/publicdomain/zero/1.0/) applies to the data made available in this article, unless otherwise stated. The attached file is the published version of the article
Morphology and foraging behavior of Oklahoma's grass-feeding termite: Gnathamitermes tubiformans (Isoptera: Termitidae)
Grass-feeding termites, Gnathamitermes sp., can be considered beneficial in pastureland, where they aerate topsoil, recycle nutrients from grasses and forbs, and excavate and redistribute soil. The primary objective of this report is to illustrate and determine the average physical dimensions of Gnathamitermes tubiformans soldiers by measuring key body parts, including left mandible length, as well as discuss observed foraging behavior. G.Tubiformans soldiers have unique mandibles that can be used for accurate identification. Workers are morphologically similar compared with some other arid-land termite species, thus soldier characteristics are used for identification. The secondary objective is to describe observations of G.Tubiformans foraging behavior. This report also provides detailed line drawings and a watercolor illustration for aid in identification. Termites were collected near Temple, Cotton County, Oklahoma, and measured with high precision microscopy. To ensure accurate identification, fourteen different soldier body measurements were determined. The ability to identify termites that are potentially beneficial or detrimental to forage grass biomass production may aid efforts to enhance livestock production on pastures.Peer reviewedEntomology and Plant PathologyPsycholog
How does conformational flexibility influence key structural features involved in activation of anaplastic lymphoma kinase?
Anaplastic Lymphoma Kinase (ALK) plays a major role in developing tumor processes and therefore has emerged as a validated therapeutic target. Applying atomistic molecular dynamics simulations on the wild type enzyme and the nine most frequently occurring and clinically important activation mutants we revealed important conformational effects on key interactions responsible for the activation of the enzyme
- …