Preliminary Study of Advanced Turboprops for Low Energy Consumption

The fuel savings potential of advanced turboprops (operational about 1985) was calculated and compared with that of an advanced turbofan for use in an advanced subsonic transport. At the design point, altitude 10.67 km and Mach 0.80, turbine-inlet temperature was fixed at 1590 K while overall pressure ratio was varied from 25 to 50. The regenerative turboprop had a pressure ratio of only 10 and an 85 percent effective rotary heat exchanger. Variable camber propellers were used with an efficiency of 85 percent. The study indicated a fuel savings of 33 percent, a takeoff gross weight reduction of 15 percent, and a direct operating cost reduction of 18 percent was possible when turboprops were used instead of the reference turbofan at a range of 10 200 km. These reductions were 28, 11, and 14 percent, respectively, at a range of 5500 km. Increasing overall pressure ratio from 25 to 50 saved little fuel and slightly increased takeoff gross weight

Technology and benefits of aircraft counter rotation propellers

Results are reported of a NASA sponsored analytical investigation into the merits of advanced counter rotation propellers for Mach 0.80 commercial transport application. Propeller and gearbox performance, acoustics, vibration characteristics, weight, cost and maintenance requirements for a variety of design parameters and special features were considered. Fuel savings in the neighborhood of 8 percent relative to single rotation configurations are feasible through swirl recovery and lighter gearboxes. This is the net gain which includes a 5 percent acoustic treatment weight penalty to offset the broader frequency spectrum noise produced by counter rotation blading

Controls on plot-scale growing season CO2 and CH4 fluxes in restored peatlands: Do they differ from unrestored and natural sites?

This study brings together plot-scale growing season fluxes of carbon dioxide (CO2) and methane (CH4) from six Canadian peatlands restored by the moss layer transfer technique (MLTT) and compares them with fluxes from adjacent unrestored and natural peatlands to determine1) if CO2 and CH4 fluxes return to natural-site levels and 2) whether the ecohydrological controls (e.g. water table, plant cover) on these fluxes are similar between treatments. We also examine differences between eastern (humid/maritime climate) and western (sub-humid climate) Canadian plots, and between restoration of former horticultural peat extraction sites and oil industry well-pads. Our results indicate that restored site fluxes of CO2 and CH4 are not significantly different between eastern and western Canada or between a restored well-pad and restored horticultural peat extraction sites. Restoration resulted in gross primary production rates similar to those at natural plots and significantly greater than those at unrestored plots. Ecosystem respiration was not significantly different at restored and unrestored plots, and was lower at both than at natural plots. Methane emission was significantly greater at restored plots than at unrestored plots, but remained significantly lower on average than at natural plots. Water table was a significant control on CH4 flux across restored and natural plots. Vascular plant cover was significantly related to CO2 uptake (gross photosynthesis) at restored and unrestored plots, but not at natural plots, while higher moss cover resulted in significantly greater net uptake of CO2 at natural plots but not at restored and unrestored plots. Overall, MLTT restoration greatly alters CO2 and CH4 dynamics compared to unrestored areas but fluxes remain, on average, significantly different from those in natural peatlands, in both the magnitude of mean growing season fluxes and controls on variation in these fluxes among plots. Peatland restoration by MLTT results in reduced CO2 emissions and higher CH4 emissions; however, more year-round measurements in more restored peatlands over longer periods post-restoration are needed to improve greenhouse gas emission estimates for restored Canadian peatlands

Manned Mars landing missions using electric propulsion

Manned Mars landing missions using electric propulsion - evaluation of various mission profile

Conductivity in a symmetry broken phase: Spinless fermions with 1/d1/d corrections

The dynamic conductivity $\sigma(\omega)$ of strongly correlated electrons in a symmetry broken phase is investigated in the present work. The model considered consists of spinless fermions with repulsive interaction on a simple cubic lattice. The investigated symmetry broken phase is the charge density wave (CDW) with wave vector $Q=(\pi,\pi,\pi)^\dagger$ which occurs at half-filling. The calculations are based on the high dimensional approach, i.e. an expansion in the inverse dimension $1/d$ is used. The finite dimensionality is accounted for by the inclusion of linear terms in $1/d$ and the true finite dimensional DOS. Special care is paid to the setup of a conserving approximation in the sense of Baym/Kadanoff without inconsistencies. The resulting Bethe-Salpeter equation is solved for the dynamic conductivity in the non symmetry broken and in the symmetry broken phase (AB-CDW). The dc-conductivity is reduced drastically in the CDW. Yet it does not vanish in the limit $T \to 0$ due to a subtle cancellation of diverging mobility and vanishing DOS. In the dynamic conductivity $\sigma(\omega)$ the energy gap induced by the symmetry breaking is clearly discernible. In addition, the vertex corrections of order $1/d$ lead to an excitonic resonance lying within the gap.Comment: 23 pages, 19 figures included with psfig, Revtex; Physical Review B15, in press (October/November 1996) depending on the printer/screen driver, it might be necessary to comment out figures 3,4,5,10,11,12,19 and have them printed separatel

Effects of Next-Nearest-Neighbor Hopping on the Hole Motion in an Antiferromagnetic Background

In this paper we study the effect of next-nearest-neighbor hopping on the dynamics of a single hole in an antiferromagnetic (N\'{e}el) background. In the framework of large dimensions the Green function of a hole can be obtained exactly. The exact density of states of a hole is thus calculated in large dimensions and on a Bethe lattice with large coordination number. We suggest a physically motivated generalization to finite dimensions (e.g., 2 and 3). In $d=2$ we present also the momentum dependent spectral function. With varying degree, depending on the underlying lattice involved, the discrete spectrum for holes is replaced by a continuum background and a few resonances at the low energy end. The latter are the remanents of the bound states of the $t-J$ model. Their behavior is still largely governed by the parameters $t$ and $J$. The continuum excitations are more sensitive to the energy scales $t$ and $t_1$.Comment: To appear in Phys. Rev. B, Revtex, 23 pages, 10 figures available on request from [email protected]

Hole motion in the Ising antiferromagnet: an application of the recursion method

We study hole motion in the Ising antiferromagnet using the recursion method. Using the retraceable path approximation we find the hole's Green's function as well as its wavefunction for arbitrary values of $t/J_z$. The effect of small transverse interaction also is taken into account. Our results provide some additional insight into the self-consistent Born approximation.Comment: 8 pages, RevTex, no figures. Accepted for publication in Phys.Rev.